Question is ⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured, Options are ⇒ (A) at lowest gain crossover frequency, (B) at highest gain crossover frequency, (C) at the gain crossover frequencies, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured, Options are ⇒ (A) at lowest gain crossover frequency, (B) at highest gain crossover frequency, (C) at the gain crossover frequencies, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a stable system having two or more gain crossover frequencies the phase margin is measured
A.	at lowest gain crossover frequency [Wrong Answer]
B.	at highest gain crossover frequency [Correct Answer]
C.	at the gain crossover frequencies [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The resolution of a 12-bit D/A converter using a binary ladder with + 10V as the full scale output will be
2.44 mV
3.50 mV
4.32 mV
5.12 mV

⇒ The minterm designation for ABCD is
m₈
m₁₀
m₁₄
m₁₅

⇒

Assertion (A): In the circuit shown figure the diode is used to protect the active devices. Transistor T goes into saturation when a positive pulse is applied at base and non conducting

Reason (R): When the current in an inductor is suddenly stopped, a high voltage is induced across
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a radar, the return echo arrives after the allocated pulse interval. Then
the receiver may be over loaded
the target will appear closer than its actual position
the return echo may interfere with transmitter operation
none of the above

⇒ A two branch parallel circuit has a 20 Ω resistance and 1 H inductance in one branch and a 100 μF capacitor in the second branch. It is fed from 100 V ac supply, at resonance, the input impedance of the circuit is
500 Ω
50 Ω
20 Ω
5 Ω

⇒ A parallel plate capacitor having C = 200 x 10^-12 F has loss dielectric having tan δ = 4 x 10^-4. At an ac voltage of f = 10⁶ Hz and peak value 2 V, the dielectric losses are
10^-8 W
10^-6 W
10^-4 W
10^-2 W

⇒ In figure, V_{020 V
10 V
5 V
0}

⇒ The ALU carrier out arithmetic and logic operations (OR AND, NOT, etc.) it processes
decimal numbers
binary numbers
hexadecimal numbers
octal numbers

⇒ In a combination limiter with sinusoidal input voltage the output wave can be nearly square.
TRUE
FALSE

⇒ Symbol shown in figure represen
P-channel enhancement MOSFET
N-channel DEMOSFET
UJT with P-type base
UJT with N-type base

⇒ Evaluate the value of 2 [u (t - 1) - u (1 - 2t)] (u ( t + 1) + u (t)) at t = 3 sec.
0
4
∞
1

⇒ Consider the following stateme
1, 2, 3
1, 3, 4
2, 3, 4
1, 2, 4

⇒ (1111.11)₂ is
(1.01)₁₀
(0.75)₁₀
(15.3)₁₀
(15.75)₁₀

⇒ The characteristic impedance of loss less transmission line is
L/R
L/C
1/LC
C/L

⇒ The logic realized by the circuit shown in figure belo
F = A - C
F = A + C
F = B ⊙ C
F = B ⊕ C

⇒ In FM signal with a modulation index m_f is passed through a frequency tripler. The wave in the output of the tripler will have a modulation index of
m_f
3m_f
m_f/3
m_f/9

⇒ The number of distinct Boolean expression of 4 variables is
16
256
1024
65536

⇒ Which of the following devices has the 'negative resistance' characteristic?
Reflex klystron
Gunn diode
P-N-P transistor
Magnetron

⇒ The angular location of poles depends on
undamped natural frequency
damping ratio
both (a) and (b)
neither (a) nor (b)

⇒ If both emitter base and collector base junctions of a BJT are forward biased, the transistor is in
active region
saturated region
cut off region
inverse mode

⇒ A 3 phase ac regulator uses
3 thyristors
6 thyristors
9 thyristors
12 thyristors

⇒ The ASCII code is
5-bit code
7-bit code
9-bit code
11-bit code

⇒ In a rectangular waveguide if operating frequency is greater than cut off frequency then propagation constant is
purely real
purely imaginary
equal to unit
a complex number

⇒ In a CE amplifier circuit the ac voltage between emitter and ground
is very high
may be high or low
is zero
depends on circuit configuration

⇒ The typical squelch circuit
cuts off an IF amplifier when the AGC is maximum
cuts off an IF amplifier when the AGC is minimum
cuts off an audio amplifier when the carrier is absent
eliminates the RF interference when the signal is weak

⇒ A half bridge inverter
needs a 3 wire dc supply
may use a two wire or 3 wire dc supply
has higher output voltage if fed from 3 wire dc supply
has higher efficiency if fed from 3 wire dc supply

⇒ In the context of error detection in satellite transmission, ARQ stands for
Automatic Repeat Request
Automatic Relay Request
Accelerated Recovery Request
Automatic Radiation Quenching

⇒ ECL can be used to high frequencies in the order of
500 kHz
1 MHz
100 MHz
500 MHz

⇒ A trinitron colour picture tube uses
three electron guns
one electron gun
one electron gun with three separate in line cathodes
none of the above

⇒ Consider the following statements about directional coupler shown in the fi
1 and 2 only
3 and 4 only
1, 2 and 3
2, 3 and 4