Question is ⇒ For a reactance function H(s), Options are ⇒ (A) Re [H(jω)] is positive for ω ≥ 0, (B) Re [H(jω)] is zero for ω ≥ 0, (C) Re [H(jω)] is positive or zero for ω ≥ 0, (D) Re [H(jω)] is zero or negative for ω ≥ 0, (E) , Leave your comments or Download question paper.

Question is ⇒ For a reactance function H(s), Options are ⇒ (A) Re [H(jω)] is positive for ω ≥ 0, (B) Re [H(jω)] is zero for ω ≥ 0, (C) Re [H(jω)] is positive or zero for ω ≥ 0, (D) Re [H(jω)] is zero or negative for ω ≥ 0, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a reactance function H(s)
A.	Re [H(jω)] is positive for ω ≥ 0 [Wrong Answer]
B.	Re [H(jω)] is zero for ω ≥ 0 [Correct Answer]
C.	Re [H(jω)] is positive or zero for ω ≥ 0 [Wrong Answer]
D.	Re [H(jω)] is zero or negative for ω ≥ 0 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When electronic emission occurs due to bombardment of high velocity electrons on a metal surface, it is called secondary emission.
TRUE
FALSE

⇒ A channel has a SNR of 7 and BW 4 kHz. Keeping the channel capacity (BPS) same, the BW is reduced to accommodate more channels. The SNR
decreases
increases
remains same
partially affected

⇒ A source generates three symbols with probabilities 0.25, 0.25, 0.50 at a rate of 3000 symbols per second. Assuming independent generation of symbols, the most efficient source encoder would have average bit rate is as
6000 bits/sec
4500 bits/sec
3000 bits/sec
1500 bits/sec

⇒

Assertion (A): In 8085, P flag is for parity checking.

Reason (R): If the result of ALU has even parity, P flag is set and if the result has odd parity, P flag is reset.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In a FM signal, the modulation index increases, then the power
increases
decreases
remains constant
none of the above

⇒ For a full rectified sine wave, the form factor and peak factor respectively are
1.57 and 2
1.57 and 2
1.11 and 1.11
1.11 and 2

⇒ Which of the statement is correct?
h and g matrices are inverse of each other
z and y matrices are inverse of each other
for reciprocal networks AD - BC = 1
ABCD parameters are used in transistor circuit

⇒ Typical switching time for ECL is
5 nano seconds
5 micro seconds
5 milli seconds
5 seconds

⇒ Transition capacitance is associated with __________ and depletion capacitance is associated with __________ diodes.
reverse bias and forward bias
forward bias and reverse bias
reverse bias and reverse bias
forward bias and forward bias

⇒ In a megger the controlling torque is provided by
spring
gravity
coil
eddy current

⇒ A voltmeter using thermocouples measures
rms value
peak value
average value
peak to peak value

⇒ Which display device resembles vacuum tube?
LED
LCD
VF
None of these

⇒ Read the following statements about TWT

It uses thermionic emission.
It uses an attenuater.
It is inherently a resonant device.
It has broad bandwidth.

Which of the above are correct?
1, 2, 3 and 4
1, 2 and 3
1, 3 and 4
1, 2 and 4

⇒ When a lead acid battery is fully charged the colours of its positive and negative plates are
grey and dark brown
dark grey and brown
grey and brown
dark brown and grey

⇒

Assertion (A): In reverse biased p-n junction, the reverse saturation current is nearly constant if the reverse voltage is less than critical value.

Reason (R): The total reverse current is sum of reverse saturation current and surface leakage current.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a TWT the phase velocity of the axial component of the field on the slow wave structure is kept
equal to velocity of electron
slightly less than velocity of electron
slightly more than velocity of electron
equal to velocity of light in free space

⇒ In 8085 microprocessor, how many I/O ports can be accessed by memory mapped method?
8
256
32 K
64 K

⇒ With increasing temperature, the electrical conductivity of metals
increases
decreases
increases first and then decreases
remains unaffected

⇒ The maximum rectification efficiency in case of full wave rectifier is
1
0.812
0.666
0.406

⇒ The polarities of the magnetised iron rod of
A is N, B is S and C is neutral
A is N, B is S and C is S
A is N, B is N and C is S
A is S, N is S and C is N

⇒ If A = 7 ∠15, A² is
49 ∠225°
49 ∠30°
49 ∠15°
49 ∠7.5°

⇒ A + 1.9 lens has a focal length of 25 mm. The diameter of lens is about
13 mm
1.3 mm
130 mm
none of the above

⇒ A lossless transmission line is connected to two identical voltage source as shown in figu
∞
100
50
25

⇒ Zener breakdown occurs
due to rapture of covalent band
mostly in germanium junctions
in lightly doped junctions
due to thermally generated minority carriers

⇒ In n type semiconductor, the free electron concentration
is nearly equal to density of donor atoms
is much greater than density of donor atoms
is much less than density of donor atoms
may be equal to or more or less than density of donor atoms

⇒ Which of the following circuits cannot be demodulate SSB?
Product detector
Balanced modulator
Phase discriminator
BFO

⇒ A stepper motor is essentially
a synchronous motor
induction motor
dc motor
either (b) or (c)

⇒ The current through a 10 Ω resistance in a dc circuit having two emf sources is 3A. If this resistance is changed to 20 Ω, the new value of current will be
less than 3 A
equal or less than 3 A
equal to or less or more than 3 A
1.5 A

⇒ For the discrete time system of the given fig
y_k - 0.5 y_k_{- 1} - 0.25 y_k_{- 2} = u_k
y_k + 0.5 y_k_{- 1} - 0.25 y_k_{- 2} = u_k
y_k - 0.5 y_k_{- 1} + 0.25 y_k_{- 2} = u_k
y_k + 0.5 y_k_{- 1} + 0.25 y_k_{- 2} = u_k

⇒ The inductance of a coil can be increased by
choosing core material having high relative permeability
decreasing diameter of the former
decreasing the number of turns
increasing core length