Question is ⇒ For a plate-modulated class C amplifier the plate supply voltage is E. The maximum plate cathode voltage could be almost high as, Options are ⇒ (A) 2E, (B) 3E, (C) 4E, (D) 6E, (E) , Leave your comments or Download question paper.

Question is ⇒ For a plate-modulated class C amplifier the plate supply voltage is E. The maximum plate cathode voltage could be almost high as, Options are ⇒ (A) 2E, (B) 3E, (C) 4E, (D) 6E, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a plate-modulated class C amplifier the plate supply voltage is E. The maximum plate cathode voltage could be almost high as
A.	2E [Wrong Answer]
B.	3E [Wrong Answer]
C.	4E [Correct Answer]
D.	6E [Wrong Answer]
View Answer 3 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In common base connection, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_C and V_CE
I_E and V_CB
I_E and V_CE

⇒ Thyristors can be used for control of
dc separately excited motor
dc shunt motor
dc series motor
all of the above

⇒ Decimal 43 in hexadecimal and BCD number system is respectively.
B2, 01000011
2B, 01000011
2B, 00110100
B2, 01000100

⇒ Which SNR denotes excellent picture quality in TV?
50 dB
30 dB
15 dB
5 dB

⇒

Assertion (A): The speed of a shaft can be measured by using a dc tacho generator.

Reason (R): A two phase servometer can also be used as a speed transducer.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A capacitor is needed for an ac circuit of 230 V, 50 Hz the peak voltage rating of the capacitor should be
230 V
0.5 x 230 V
2 x 230V
230/2V

⇒ Consider the following statements

Thermistor is more sensitive than platinum resistance thermometer
The resistance of thermistor is solely a function of its absolute temperature whether the source of heat is external or internal
Thermistor has linear temperature-resistance relationship
Thermistor has linear negative temperature coefficient

Of the Statements, the correct statements are
1 and 2
3 and 4
1, 2, 3, 4
1, 2 and 4

⇒ The directive gain of λ/2 resonant wire is 1.64.
TRUE
FALSE

⇒ In a half bridge inverter, the freewheeling diodes are needed
even when load is resistive
only when load is inductive
only when load is inductive or capacitive
for all types of loads

⇒ Select the correct relation
∇(AB) = A ∇ B + B ∇ A
∇ . (AB) = ∇ A . B + A ∇ B
∇ x (AB) = ∇ A x B + A ∇ B
All of the above

⇒ As per Matthiessen's rule, the total resistivity r of a conductor can be written as r = r_i + aT, where r_i and a are constants and T is absolute temperature. At very low temperatures
aT = 0
aT > r_i
aT ∼ r_i
aT < r_i

⇒ In which mode of BJT operation are both junctions reverse biased?
Active
Saturation
Cut off
Reverse active

⇒ A transponder is a satellite equipment which
receives a signal from Earth station and amplifies
changes the frequency of the received signal
retransmits the received signal
does all of the above-mentioned functions

⇒ Which of the following devices should be used for accurate measurement of a low dc voltage?
Small range moving coil voltmeter
Dc potentiometer
Small range thermocouple voltmeter
Hot wire instrument

⇒ In a flip-flop with RS latch a high S and a low R set the output to __________ and a low S and a high R set the output __________ .
low, low
high, high
low, high
high, low

⇒ A voltage wave is v = 50 sin ωt. Its average value calculated over full one cycle is
zero
35.36 V
31.85 V
none of the above

⇒ Which of the following is not a keyword in C?
int
float
return
capital

⇒ Compared to a p-n junction with N_A = N_D = 10¹⁴/cm³, which one of the following statements is TRUE for a p-n junction with N_A = N_D = 10²⁰/cm³?
Reverse breakdown voltage is lower and depletion capacitance is lower
Reverse breakdown voltage is higher and depletion capacitance is lower
Reverse breakdown voltage is lower and depletion capacitance is higher
Reverse breakdown voltage is higher and depletion capacitance is higher

⇒ In the design of a single mode step index optical fiber close to upper cut-off, the single mode operations is NOT preserved if
radius as well as operating wavelength are halved
radius as well as operating wavelength are doubled
radius is halved and operating wavelength is doubled
radius is doubled and operating wavelength is halved

⇒ In figure, the switch is closed at t = 0. At t = 0⁺ The value of current supplied by batter
0.0416666666666667
0.0833333333333333
zero
infinity

⇒ Consider the following:

Si
Ge
GaAs
InP

Which of the above semiconductors should be used for making highly efficient photodiodes?
1 and 4 only
3 and 4 only
1, 3 and 4
2, 3 and 4

⇒ The output of a diode detector contains
D.C. voltage
modulating signal
RF ripple
all of the above

⇒ For an n-channel JEFT having drain source voltage constant if the gate source voltage is increased (more negative) pinch off would occur for
high values of drain current
saturation values of drain current
zero drain current
gate current equal to the drain current

⇒ A Weinbridge oscillator is a
VHF oscillator
RF oscillator
microwave oscillator
audio frequency oscillator

⇒ For insulators the energy gap is of the order of
0.1 eV
0.7 eV
1.1 eV to 1.2 eV
5 to 15 eV

⇒ In a controlled rectifier a freewheeling diode is necessary if the load is
inductive
resistive
capacitive
any of the above

⇒

Match the following:

	List I (Logic)		List II (Characteristic)
A.	RTL	1.	High fan out
B.	CMOS	2.	Highest speed of operation
C.	I²L	3.	High noise immunity
D.	ECL	4.	Lowest product of power and delay

A-4, B-3, C-2, D-1
A-4, B-3, C-2, D-3
A-3, B-1, C-4, D-2
A-3, B-4, C-1, D-2

⇒ AM-SC stands for
Amplitude Modulated-Suppressed Carrier
Amplitude Modulated-Single Carrier
Amplitude Modulated-Synchronous Carrier
Amplitude Modulated-Self Carrier

⇒

Match the following:

	List I (Types of memory)		List II (Used As)
A.	DRAM	1.	Cache memory
B.	SRAM	2.	Main memory
C.	Parallel Access Registers	3.	BIOS memory
D.	ROM	4.	CPU registers

A-1, B-4, C-2, D-3
A-3, B-4, C-2, D-1
A-1, B-2, C-4, D-3
A-3, B-2, C-4, D-1

⇒ In a 3 phase full wave regulator feeding resistance load connected in star, the possible range of firing angle a is
0 ≤ a ≤ 180°
0 ≤ a ≤ 150°
0 ≤ a ≤ 120°
0 ≤ a ≤ 90°