Question is ⇒ For a plane good conductor, skin depth varies, Options are ⇒ (A) directly as square root of permeability, (B) directly as square root of frequency, (C) inversely as permittivity, (D) inversely as square root of conductivity, (E) , Leave your comments or Download question paper.

Question is ⇒ For a plane good conductor, skin depth varies, Options are ⇒ (A) directly as square root of permeability, (B) directly as square root of frequency, (C) inversely as permittivity, (D) inversely as square root of conductivity, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a plane good conductor, skin depth varies
A.	directly as square root of permeability [Wrong Answer]
B.	directly as square root of frequency [Wrong Answer]
C.	inversely as permittivity [Wrong Answer]
D.	inversely as square root of conductivity [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statements about Java variables

Java variable must start with a letter or underscore or dollor sign.
Java variable can not start with a digit.
After the first character the variable can have any combination of letters or numbers.
Capitalization of letters must be consistent.

Which of the above are correct?
All
1, 2 and 3 only
2, 3, 4 only
1, 2 and 4 only

⇒

Assertion (A): In control system velocity error is not an error in velocity but is an error in position due to a ramp input.

Reason (R): For a type of system velocity error is zero.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In figure the current through resist
is always equal to 130 mA
may vary between 130 mA and 10 mA
may vary between 65 mA and 10 mA
is always equal to 65 mA

⇒ n type semiconductors
are negatively charged
are produced when indium as impurity is added to germanium
are produced phosphorus as impurity is added to silicon
none of the above

⇒ When the ac input signal is very large the instantaneous operating point CE amplifier moves all the way between
ac saturation and ac cut off points
ac operating and ac cut off points
ac saturation and ac operating points
none of the above

⇒ FM broadcast is done using
medium waves
short waves
VHF and UHF waves
microwaves

⇒ Magnitude Plot of a Composite signal x(t) = e^2jt + e^3jt is
half wave rectified sinusoidal
full wave rectified sinusoidal
exponentially increasing sinusoidal
exponentially decreasing sinusoidal

⇒ The spins in a ferrimagnetic material are
all aligned parallel
partially aligned antiparallel without exactly cancelling out sublattice magnetisation
randomly oriented
all aligned antiparallel such that the sublattice cancels out exactly

⇒ If all bubbles are removed, what are the new RAM locati
(8000)_H - (83FF)_H
(80AA)_H - (80FF)_H
(FF00)_H - (FFFF)_H
none of the above

⇒ If f(t) = r (t - a), F(s) =
e^-as/s²
a/(s + a)
1/(s + a)
e^-as/s

⇒ A line has standing waves with a voltage maximum of 35 mV and minimum of 17.5 mV VSWR is
2
4
0.5
0.25

⇒ A cycloconverter is
ac-dc converter
dc-ac converter
dc-dc converter
ac-ac converter

⇒ The n state variables can be considered as n components of a state vector.
TRUE
FALSE

⇒

Match the following:

	List I (Instrument)		List II (Measured quantity)
A.	Hot wire	1.	only voltage
B.	PMMC	2.	phase
C.	Electrostatic	3.	true RMS value
D.	Lock in Amplifier	4.	dc value

A-3, B-2, C-1, D-4
A-1, B-4, C-2, D-3
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1

⇒ __________ acts as a depolarizer in a dry cell.
ammonium chloride
carbon powder
manganese dioxide
zinc chloride

⇒ A single phase energy meter has the rating 1200 resolutions/ kWh. If a 500 W electric gadget is used for 4 hours, the energy meter will make
1200 revolutions
1800 revolutions
2100 revolutions
2400 revolutions

⇒ A two branch parallel circuit has a 10 Ω resistance and 0.5 H inductance in one branch and a 100 μF capacitor in the second branch. It is fed from 100 V ac supply. At resonance, the source current is
0.416666666666667
0.0416666666666667
0.2 A
0.05 A

⇒ A microprocessor with a 16-bit address bus is used in a linear memory selection configuration (i.e., Address bus lines are directly used as chip selects of memory chips) with 4 memory chips. The maximum addressable memory space is
64 K
16 K
8 K
4 K

⇒

Assertion (A): The variable name 5KING is not valid in Fortran 77.

Reason (R): In Fortran 77 the first character of a variable name must be an alphabet.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A sinusoidal voltage of 2 kV peak value is amplitude modulated to give 20% modulation. The peak value of each side band term is
400 V
200 V
100 V
800 V

⇒ A low-pass filter frequency responce H (jω) = A (ω) e^jΦ(ω) does not produce any phase distortion, if
A(ω) = Cω², Φ (ω) = kω³
A(ω) = Cω², Φ (ω) = kω
A(ω) = Cω², Φ (ω) = kω²
A(ω) = C, Φ (ω) = kω^-1

⇒ The circuit of figure is generally employed
bridge
low-pass filter
peaking network
high-pass filter

⇒ A germanium diode has a reverse saturation current of 30 μA at 125°C and forward current of 1 mA at a forward potential of 0.8 V and the reverse potential is 0.6 V What are its dynamic forward and reverse resistance at this temperature.
10.7 Ω, 70 kΩ
34 Ω, 20 kΩ
80 Ω, 20 kΩ
800 Ω, 40 kΩ

⇒ The factors which govern fan out of CMOS gates are
maximum permissible propagation delay
input capacitance of each load
both (a) and (b)
neither (a) nor (b)

⇒ The voltage drop per ampere-metre of an aluminium conductor is higher as compared to a copper conductor of the same size due to its higher
insulation resistance
resistivity
conductivity
current density

⇒ The relative permeability is taken as unity for which of the following?
Air
Cobalt
Vacuum
Bismuth

⇒ Voltage standing wave pattern in a loss less transmission line with characteristic impedance 50 Ω and a resistive load is shown in the figu
50 Ω
200 Ω
12.5 Ω
0 Ω

⇒ Which of the following terms are equivalent?

A ⊕ B ⊕ C
A ⊕ B ⊙ C
A ⊙ B ⊕ C
A ⊙ B ⊙ C

1 and 4; 2 and 3
1 and 3
2 and 3
1, 2 and 4

⇒ To measure an emf by dc potentiometer it is necessary to standardise the potentiometer with the help of a standard cell.
TRUE
FALSE

⇒ Bipolar IC memories are fabricated using
high density versions of the bipolar transistor flip-flop
low density versions of the unipolar transistor flip-flop
high density versions of the MOSFET
low density versions of the MOSFET