Question is ⇒ For a photoengraving the mask used is, Options are ⇒ (A) master mask, (B) slave mask, (C) working mask, (D) photo mask, (E) , Leave your comments or Download question paper.

Question is ⇒ For a photoengraving the mask used is, Options are ⇒ (A) master mask, (B) slave mask, (C) working mask, (D) photo mask, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a photoengraving the mask used is
A.	master mask [Wrong Answer]
B.	slave mask [Wrong Answer]
C.	working mask [Correct Answer]
D.	photo mask [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the basic series inverter circuit, the source supplies load
only in positive half cycle
both in positive and negative half cycles
only in part of positive half cycle
in positive half cycle and part of negative half cycle

⇒ For a second order system delay time t_d is the time required to reach
half the final value for the very first time
the final value for the very first time
90% of the final value for the very first time
none of the above

⇒ In figure the bridge is balanced when Z₄
120∠70°
187.5∠ - 10°
187.5∠ - 70°
333.3∠ - 70°

⇒ In degenerate p type semiconductor material, the Fermi level,
is in the valence band
is in conduction band
is at the centre in between valence and conduction bands
is very near conduction band

⇒ Which of the following wave remains unaffected during day and night?
Tropospheric wave
Sky wave
Ground wave
None of the above

⇒ In a FM receiver, amplitude limiter
amplifiers low frequency signals
reduces the amplitude of signals
eliminates any change in amplitude of received FM signals
none of the above

⇒

Assertion (A): A dc potentiometer measures the true open circuit emf of a source.

Reason (R): At balance point, a dc potentiometer does not draw any current from the source.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then array length will be
10 λ
100 λ
20 λ
5 λ

⇒ The width of a radio beam from a 1 m diameter parabolic antenna at 10 GHz is about
100°
50°
5°
1°

⇒ In an RL series circuit the inductance is 1H and current at an instant is 0.6 A. The energy stored in magnetic field is
0.36 J
0.18 J
0.09 J
0.03 J

⇒ The force required to initiate motion between two contacting surfaces is called
coulomb friction
viscous friction
static friction
none of the above

⇒

Assertion (A): When frequencies of signals fed to X and Y plates of CRO are multiples of each other, Lissajous pattern is displayed on screen.

Reason (R): In a CRO, the vertical deflection is proportional to voltage applied to Y plates.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which of the following effects is used in measurement of magnetic flux?
Hall effect
Seeback effect
Piezo electric effect
Photoelectric effect

⇒ Colour code of carbon resistors has only two bands.
TRUE
FALSE

⇒ A typical value of insertion loss of SAW filter is
15 dB
2 dB
40 dB
60 dB

⇒ In a high speed modem the data rate handled is about
1000 bps
5000 bps
20000 bps
50000 bps

⇒ When Z₁ << Z, The circuit of figure work
inverting amplifier
Schmitt trigger
non-inverting amplifier
source follower

⇒ For measurement of high voltage capacitors the suitable bridge is
Wien bridge
modified De Sauty bridge
Schering bridge
either (a) or (b)

⇒ The wavelength of an electromagnetic wave after reflection at angle on a surface
remains same as the wavelength perpendicular to the surface
remains same in the free space
increases in actual direction of propagation
decreases in actual direction of propagation

⇒ Which is a digital coding technique?
PCM
DM
DPCM
All

⇒ In a radio receiver, if the intermediate frequency is too low
Image-frequency rejection will improve
Selectivity will be too sharp
The frequency selectivity of the local oscillator will have to be lowered
All of the above

⇒ A duplexer is used to
couple two antennas to a transmitter
isolate the antenna from the local oscillator
prevent interference between two antennas connected to receiver
use an antenna for reception or transmission without interference

⇒ Substitution theorem applies to
Linear network
Non linear network
Linear time invariant network
Any network

⇒

Assertion (A): If the reading of an instrument is low, the error is large.

Reason (R): The error of an instrument is certain percentage of its full scale deflection.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Consider the following statements

A 33 MHz 486 has higher MIPS than 33 MHz 386.
A 33 MHz 486 has higher MFLOPS than 33 MHz 386 of these statements.

Both are true
Both are false
1 is true and 2 is false
1 is false and 2 is true

⇒

Match the following:

	List I (Operation in Basic)		List II (Priority)
A.	Exponentiation	1.	1
B.	Multiplication and division	2.	2
C.	Addition and subtraction	3.	3
D.	Expression within parenthesis	4.	4

A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-4, B-3, C-2, D-1
A-2, B-3, C-4, D-1

⇒ Which of the following statement is incorrect?
Curl of vector potential is magnetic field density
Electric charges in motion produce magnetic field
Electric charges at rest produce electrostatic field
None of the above

⇒ Which of the following is susceptible to race condition?
R-S latch
D latch
Both R - S and D latches
None of the above

⇒ If X(z) = (1 - a)z^-1/[(1 - z^-1)(1 - az^-1)] and 1 < |z|, the final value of x_k is
0
1
∞
2

⇒ A DC voltage source is connected across a series R - L - C circuit. Under steady-state conditions, the applied DC voltage drops entirely across the
R only
C only
L only
R and L combination