Question is ⇒ For a periodic waveform, the power spectral density and correlation function form, Options are ⇒ (A) a Laplace transform pair, (B) a Fourier transform pair, (C) either (a) or (b), (D) neither (a) nor (b), (E) , Leave your comments or Download question paper.

Question is ⇒ For a periodic waveform, the power spectral density and correlation function form, Options are ⇒ (A) a Laplace transform pair, (B) a Fourier transform pair, (C) either (a) or (b), (D) neither (a) nor (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a periodic waveform, the power spectral density and correlation function form
A.	a Laplace transform pair [Wrong Answer]
B.	a Fourier transform pair [Correct Answer]
C.	either (a) or (b) [Wrong Answer]
D.	neither (a) nor (b) [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The effective value of the waveform in the given figur
5
2.5
2.5
5.0

⇒ The secondary lobes in binomial arrays can be reduced by
maintaining spacing between two consecutive radiating sources less than λ/2
maintaining the amplitudes in radiating sources, from outer towards the centre source, proportional to the coefficients of the successive terms of the binomial series
both (a) and (b)
none of the above

⇒ The addressing mode depicted in the given figur
direct
register
register indirect
immediate

⇒ Which of the following will increase the antenna radiation efficiency?
Use of larger section of conductor
Providing insulation on conductor
Top loading of antenna
Any of the above

⇒ The correct relation between joules and calories is
calories = joules/4.156
joules = calories/4.156
calories = joules x 10⁷/4.156
joules = calories x 10⁷/4.156

⇒ In a digital circuit, a clock is a
crystal type
multivibrator
flip-flop
free running multivibrator

⇒ What will be FSV in 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ
0.99 V
0.9 V
0.1 V
0

⇒

Assertion (A): In two wattmeter method of 3 phase power measurement, one of the wattmeters would read negative if power factor of load is less than 0.5.

Reason (R): In two wattmeter method of 3 phase power measurement, both the wattmeters would show equal readings if power factor of load is unity.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which of the following has highest power gain?
CE
CC
CB
CB or CC

⇒ If f is the frequency of electromagnetic wave, f_c is cutoff frequency, then in a rectangular waveguide
attenuation is low when f > f_c
attenuation is low when f < f_c
attenuation is high when f < f_c
either (b) or (c)

⇒ In a rectangular waveguide if operating frequency is greater than cut off frequency then propagation constant is
purely real
purely imaginary
equal to unit
a complex number

⇒ In a dual converter operated in circulating current mode, the circulating current flows
when load current is zero
when load current is non-zero
even when load current is zero
none of the above

⇒ Of the various capacitances associated with a junction transistor the gain bandwidth product is affected to maximum extend by
base collector parasitic capacitor
base collector space charge layer capacitance
base emitter space charge layer capacitance
base emitter diffusion capacitance

⇒ A current increasing at the rate of 1A/s is passed through a 1 H inductor. At t = 0, i = 0. The flux linkages after 1 sec are
0.5 Wb-turn
1 Wb-turn
2 Wb-turn
4 Wb-turn

⇒ The circuit of figure is used to measure the value R_x. Ammeter resistance R_a = 0.1 Ω voltmeter resistance R_v = 5000 Ω. It R_x1 and R_x2, are the measured values of R_x with switch in position 1 and 2, the mean of R_x1, and R_x2,
9.98 Ω
10 Ω
10.04 Ω
10.1 Ω

⇒ In figure, the current
0.0416666666666667
0.0833333333333333
0.166666666666667
0.333333333333333

⇒ A long periodic antenna is a
frequency independent antenna
frequency dependent antenna
directional antenna
none of the above

⇒ The integral of a unit impulse is unit step function.
TRUE
FALSE

⇒ A first order system will never be able to give a __________ response.

Band pass
Band reject
All pass

Choose the correct option
1, 2 and 3 are true
1 and 3 are true, 2 is false
1 and 2 are false, 3 is true
1 and 2 are true, 3 is false

⇒ Which of the following is type declaration statement in C?
int bar
s = s + 1
king = horse + 1
prin = prin * prin

⇒ The holes diffuse from P-region to the N-region in a P-N junction diode because
there is greater concentration of holes in the P-region as compared to N-region
there is greater concentration of holes in the N-region as compared to P-region
the free electrons in the N-region attract them
potential difference facilities such transfer

⇒ Which of these statements is correct?
Ridge guide is essentially a form of capacitively loaded guide.
Ridge guide is essentially a form of inductively loaded guide.
Ridge guide is essentially a form of resistively loaded guide.
Ridge guide has higher power handling capacity than rectangular waveguide.

⇒ In the given circuit, the switch is open for a long time. At time t = 0, the switch is closed. What are the initial and final values of voltages across the induc
0 V and 0 V
0 V and 80 V
80 V and 0 V
80 V and 80 V

⇒ Over which frequency range the effect of atmospheric noise is significant?
Over 35 MHz
Below 30 MHz
Between 30 MHz and 100 MHz
Between 100 MHz and 150 MHz

⇒ A rectangular waveguide having TE₁₀ mode as dominant mode is having a cut off frequency of 18 GHz for the TE₃₀ mode. The inner broad wall dimension of the rectangular waveguide is
5/3 cm
5 cm
5/2 cm
10 cm

⇒ Power monitor and reflectometer use the principle of
directional coupler
klystron amplifier
Gunn diode
TWT

⇒ A copper specimen has resistivity equal to 1.8 x 10^-8 ohm-m at room temperature. At a temperature of 700 K, the resistivity is likely to be
1.6 x 10^-8 Ω-m
2 x 10^-8 Ω-m
3 x 10^-8 Ω-m
6 x 10^-8 Ω-m

⇒ A 50 p characteristic impedance line is connected to a load which shows a reflection coefficients of 0.268. If V_in = 15 volt, then the net power delivered to the load will be
0.139 W
1.39 W
0.278 W
2.78 W

⇒ For a transfer function the coefficients of the numerator and denominator polynomials in s must be real.
TRUE
FALSE

⇒ Thermistor is used in
temperature measurement
temperature control
high temperature alarm circuits of devices
all of the above