Question is ⇒ For a parallel two wire line with both conductors touching each other, the characteristic impedance is about, Options are ⇒ (A) 300 Ω, (B) 200 Ω, (C) 80 Ω, (D) 24 Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ For a parallel two wire line with both conductors touching each other, the characteristic impedance is about, Options are ⇒ (A) 300 Ω, (B) 200 Ω, (C) 80 Ω, (D) 24 Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a parallel two wire line with both conductors touching each other, the characteristic impedance is about
A.	300 Ω [Wrong Answer]
B.	200 Ω [Wrong Answer]
C.	80 Ω [Correct Answer]
D.	24 Ω [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In floating point representation decimal number 13.5 is
1101.1
1.1011 x 2³
0.11011 x 2⁴
11.011 x 2²

⇒ The input resistance R, of an ideal voltage amplifier is __________ and that of a current amplifier is __________ .
zero, zero
infinite, infinite
zero, infinite
infinite, zero

⇒ Higher order TDM levels are obtained by
forming super master groups
using A law
using μ law
dividing pulse width

⇒ The number of counter states which an 8 bit stair step A/D converter has to pass through before conversion takes place is equal to
1
8
255
256

⇒ For an antenna of height h_t metres, the radio horizon is equal to
4h_t metres
4h_t km
2.5h_t km
2.5h_t metres

⇒ Photoconductive devices uses
metallic conductors
good quality insulators
semiconductors
either (a) or (c)

⇒ In a pure capacitive circuit if the supply frequency is reduced to 1/2, the current will
be reduced by half
be doubled
be four times as high
be reduced to one fourth

⇒ The capacitance of a capacitor is not affected by
area of plates
thickness of plates
∈_r
distance between plates

⇒ The magnetic moment in units of Bohr magneton of a ferrous ion in any ferrite is
zero
2
4
6

⇒ The output resistance of a microphone is 20 ohms. It is to feed a line of impedance 320 ohms. To ensure maximum power transfer, the turn ratio of transformer is
16
256
2
4

⇒ Determine the correctness or otherwise of the following Assertion [a] and the Reason
Both [a] and [r] are true and [r] is the correct reason for [a]
Both [a] and [r] are true but [r] is not the correct reason for [a]
Both [a] and [r] are false
Both [a] and [r] are true

⇒ A transistor amplifier with 85% efficiency is expected to be
class A
class B
class C
class AB

⇒ One coulomb charge is equal to the charge on
6.24 x 10¹⁸ electrons
6.24 x 10²⁴ electrons
6.24 x 10¹⁸ atoms
none of the above

⇒ Manganin, an alloy of copper and manganese, is used in
Soldering material
Heating elements
Ballast resistors
Standard resistances

⇒ In fabricating silicon BJT in ICs by the epitaxial process, the number of diffusions used is usually
2
3
4
6

⇒ What is the major cause of creeping in an energy-meter?
Over compensation for friction
Mechanical vibrations
Excessive voltage across the potential coil
Stray magnetic fields

⇒ The distance of a direct broadcasting satellite from earth's surface is about
1000 km
10000 km
36000 km
55000 km

⇒ BCD numbers are useful whenever
binary to hexadecimal conversion is desired
binary to BCD conversion is desired
decimal information is transferred into or out of a digital system
none of the above

⇒ Linear transistor circuits always operate in
saturation region
cut off region
active region
passive region

⇒ The response to sinusoidal excitation can be found by
settings s = jω in the network function
settings s = - jω in the network function
taking inverse transform of network function
none of the above

⇒ The ripple factor of power supply is a measure of
its filter efficiency
diode rating
its voltage regulation
purity of power output

⇒

Assertion (A): Interfacing means synchronisation of digital information transmission between input output devices and computer.

Reason (R): A computer with higher bit word size executes programs at a faster rate.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Secondary emission occurs in
diode
triode
tetrode
pentode

⇒ A loop antenna may be of
square on triangular shape
hexagonal shape
circular shape
any of the above

⇒ Resistivity of metals consists of two parts, one part constant and the other temperature dependent.
TRUE
FALSE

⇒ The graph of a network has 6 branches with 3 tree branches. The minimum number of equations required for solution of network is
2
3
4
5

⇒ Which of the following best represents the output impedance of an actual op-amp?
10 ohm
100 ohm
10 k ohm
100 k ohm

⇒ Phase velocity of waves propagating in a hollow metal waveguide is
greater than the group velocity
less than the velocity of light in free space
equal to the velocity of light in free space
equal to group velocity

⇒ Consider the following statements as regards SAW filter

The centre frequency is determined by the pitch of IDT comb shaped electrodes
The response can be modified shaping the overlap of comb electrodes
The response is maximum when acoustic wave has its wavelength equal to pitch
When a number of identical electrodes are arranged at the same pitch, the frequency characteristics of the filter is expressed by (sin x)/x

Which of the above statements are correct?
1, 2, 3, 4
1, 2, 3 only
1, 2, 4 only
2, 3, 4 only

⇒ In an SSB transmitter one is most likely to find
class C audio amplifier
tuned modulator
class B RF amplifier
class AB power amplifier