Question is ⇒ For a junction FET in the pinch off region, as the drain voltage is increased, the drain current, Options are ⇒ (A) becomes zero, (B) abruptly decrease, (C) abruptly increases, (D) remains constant, (E) , Leave your comments or Download question paper.

Question is ⇒ For a junction FET in the pinch off region, as the drain voltage is increased, the drain current, Options are ⇒ (A) becomes zero, (B) abruptly decrease, (C) abruptly increases, (D) remains constant, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a junction FET in the pinch off region, as the drain voltage is increased, the drain current
A.	becomes zero [Wrong Answer]
B.	abruptly decrease [Wrong Answer]
C.	abruptly increases [Wrong Answer]
D.	remains constant [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Superposition theorem can be used to find the output of a full wave rectifier excited by sinusoidal signal sources of different frequencies connected in series.

Reason (R): Superposition theorem is valid for all linear systems.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The frequency at which phase angle is 180° is called
phase crossover frequency
stability limit frequency
frequency of limited stability
gain margin frequency

⇒ For a photo conductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in the intensities of optical illumination results in
change in open circuit voltage
change in short circuit current
a reduction resistance
an increase of resistance

⇒ Leak type bias is used in a plate-modulated class C amplifier to
prevent tuned circuit damping
prevent over modulation
increase the bandwidth
prevent excessive grid current

⇒ As the number SWG increases, area of cross-section decreases.
TRUE
FALSE

⇒ In a line VSWR of a load is 6 dB. The reflection coefficient will be
0.033
0.33
0.66
3.3

⇒ In 8085 microprocessor with memory mapped I/O which of the following is true?
I/O devices have 16 bit addresses
I/O devices are accessed during IN and OUT instructions
There can be a maximum of 256 input and 256 output devices
Logic operations can not be performed

⇒ Directivity means
maximum directive gain
zero directive gain
minimum directive gain
none of the above

⇒ UHF range is
30 MHz to 300 MHz
300 MHz to 3000 MHz
3000 MHz to 30, 000 MHz
above 30, 000 MHz

⇒ In figure, the short circuit current through terminal AB wil
1.5 A
0.125
0.0833333333333333
0.0416666666666667

⇒ The forbidden energy gap for germanium is
0.12 eV
0.32 eV
0.72 eV
0.92 eV

⇒ In the circuit shown, all the transmission line sections are lossless. The Voltage Standing Wave Ration (VSWR) on the 60W lin
1
1.64
2.5
3

⇒ Choose the correct option

Mesh is the smallest loop of circuit
Loop is smallest path of circuit
Loop does not contain any mesh
Loop may have one or more than one mesh

1, 2, 3, 4
3, 4, 2
1, 4
3, 2

⇒ When the emitter current of a transistor is changed by 1 mA, its collector current changes by 0.990 mA. The common base short circuit current gain a for the transistor is
0.99
1.01
1.001
0.99

⇒ For the transmission of normal speech, the PCM channel needs a bandwidth of __________ kHz.
2
4
16
32

⇒ Eddy currents are essential for the deflecting torque of an induction wattmeter.
TRUE
FALSE

⇒ The voltage at which Avalanche occurs is known as
cut in voltage
barrier voltage
breakdown voltage
depletion voltage

⇒ FM signal can be generated by
diode reactance modulator
saturable reactor modulator
reactance tube modulator
none of the above

⇒ Which of the following antenna is best guided by a waveguide?
Biconical
Horn
Helical
Dish

⇒ Which of the following values represents the open loop gain of typical op-amp?
100
10000
100000
1000000

⇒ A single phase semiconverter is feeding a highly inductive load. The circuit has a freewheeling diode across the load and firing angle is a. During one cycle of input voltage, the total duration of conduction of freewheeling diode is
a
2 a
4 a
0.5 a

⇒ The primary constants of a transmission line are
R and L
R, L and C
R and C
R, L, G and C

⇒ In an RC phase shift oscillator, the total phase shift of the three RC lead networks is
360°
180°
90°
0°

⇒ Figure represen
NPN transistor
PNP transistor
Zener diode
Power diode

⇒ If the Q of a single-stage single-tuned amplifier is doubled, then its bandwidth will
remain same
become half
become doubled
become four times

⇒ The modulation index of an FM is changed from 0 to 1. How does the transmitted power change?
Gets halved
Gets doubled
Gets increased by 50 percent
Remains unchanged

⇒ A broadside array operating at 100 cm wavelength consist of 4 half-wave dipoles spaced 50 cm apart. Each element carries radio frequency current in the same phase and of magnitude 0.5 A. The radiated power will be
196 W
73 W
36.5 W
18.25 W

⇒ 3N 200 is a
semi-conductor diode
P-N-P transistor
dual gate MOSFET
UJT

⇒ The VLF, LF and MF antennas are
horizontally polarized
vertically polarized
non linearly polarized
either (a) or (b)

⇒ In microwave system the function of mode filter is
to suppress modes with lower cut off frequencies
to suppress modes with higher cut off frequencies
to change mode of wave transmission
both (b) and (c)