Question is ⇒ For a half wave rectified voltage, the form factor and peak factor respectively are, Options are ⇒ (A) 1.11 and 2, (B) 1.57 and 2, (C) 1.11 and 1.11, (D) 1.57 and 2, (E) , Leave your comments or Download question paper.

Question is ⇒ For a half wave rectified voltage, the form factor and peak factor respectively are, Options are ⇒ (A) 1.11 and 2, (B) 1.57 and 2, (C) 1.11 and 1.11, (D) 1.57 and 2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a half wave rectified voltage, the form factor and peak factor respectively are
A.	1.11 and 2 [Wrong Answer]
B.	1.57 and 2 [Correct Answer]
C.	1.11 and 1.11 [Wrong Answer]
D.	1.57 and 2 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The ending part of the popular teleserial Mahabharat will be beamed to the viewers
WESTAT
INSAT-IC
ARABSAT
INSAT-ID

⇒ What will be equipotential surfaces for a pair of equal and opposite line charges?
Spheres
Concentric cylinders
Non-concentric cylinders
None of the above

⇒ Figure shows characteristics curves for bipolar transistor. These curves
output characteristics of n-p-n transistor (common base)
output characteristics of p-n-p transistor (common base)
output characteristics of n-p-n transistor (common emitter)
output characteristics of p-n-p transistor (common emitter)

⇒ If a = 0.995, I_E = 10 mA, I_CO = 0.5 mA, then I_CEO will be
100 μA
25 μA
10.1 μA
10.5 μA

⇒ If E is electric field intensity, the current density due to field emission is proportional to
E
E²
E^2.5
E^3/2

⇒ Resistivity of metals is expressed in terms of
μ ohm
μ ohm/cm
μ ohm-cm
μ ohm-cm/°C

⇒ In the circuit shown, in switch S is open for a long time and is closed at t = 0. The current i(t) for t ≥ 0^{+i(t) = 0.5 - 0.125e^-1000t A
i(t) = 1.5 - 0.125e^-1000t A
i(t) = 0.5 - 0.5e^-1000t A
i(t) = 0.375e^-1000t A}

⇒ Nyquist plot provides information about absolute stability as well as relative stability.
TRUE
FALSE

⇒

Assertion (A): A half cycle of sine wave can be expressed as sum of sine wave and another sine wave shifted by T/2 where T is the time period.

Reason (R): The function u(t - t₀) - u(t - t₀ - T) is a gate function occuring at t = t₀ and of duration T.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In p type semiconductor holes are majority carriers.
TRUE
FALSE

⇒ In commercial electron tubes the current produced by the cathode at 1000 K is about
0.01 A per cm² of cathode surface
0.1 A per cm² of cathode surface
1 A per cm² of cathode surface
5 A per cm² of cathode surface

⇒ The numerical value of directive gain may lie between
1 and + 1
0 and 1
0 and ∞
1 and ∞

⇒ A rectifier circuit has load resistance R. It uses a capacitance filter having capacitance C. For low ripple in the output
RC should be 1
RC should be low
RC should be high
RC should be neither low nor high

⇒ Reflectors and lens antennas are commonly used
in LF communication systems
not beyond 100 kHz
in the range 10 MHz to 100 MHz
above 100 MHz

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then modulating frequency is
159 Hz
1590 Hz
1.59 MHz
15.9 MHz

⇒ The circuit in figur
Cauer I form
Foster I form
Cauer II form
Foster II form

⇒ A clipper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ While forming Routh's array, the situation of a row of zeros indicates that the system
has symmetrically located roots
is not sensitive to variations in gain
is stable
is unstable

⇒ When a coil consisting of single turn rotates at a uniform speed in a magnetic field, the induced e.m.f. is
changing
reversing
steady
alternating

⇒ In a crystal oscillator of the Colpitt's oscillator type, the crystal is put is place of the
resistor R₁
condenser C₂
condenser C₁
inductor L

⇒ A volt ratio box should have low resistance.
TRUE
FALSE

⇒ A broadcast radio transmitter radiates 5 kW when the modulation percentage is 60. How much of this is carrier power?
6.66 kW
5 kW
4.9 kW
4.23 kW

⇒ Sparking affects amplitude modulation.
TRUE
FALSE

⇒ For a current transformer, the standard secondary rating is
1 A or 5 A
2.5 A
0.416666666666667
5 A or 10 A

⇒ Introducing a resistor in the emitter of a common amplifier stabilizes the d.c. operating point against variations in
only the temperature
only β of the transistor
both temperature and β
none of these

⇒ Friction forces acts in a direction
opposite to that of velocity
same as that of velocity
at right angle to that of velocity
partly opposite and partly at right angle to the direction of velocity

⇒ A signal m(t) is multiplied by a sinusoidal waveform of frequency f_c such
0.5 M(f + f_c)
0.5 M(f - f_c)
0.5 M(f + f_c) + 0.5 M(f - f_c)
0.5 M(f - f_c) + 0.5 M(f - f_c)

⇒ A constant k low pass filter has f_c = 1000 Hz. At f = 500 Hz, the phase shift is
p
zero
more than p
less than p

⇒ In a full bridge circuit supplying an RLC under damped circuit
the waveshapes of output voltage and load current are square
the waveshapes of output voltage and load current are sinusoidal
the waveshapes of output voltage is square but the waveshape of load current is nearly sinusoidal
none of the above

⇒ In all metals
conductivity decreases with increase in temperature
current flow by electrons as well as by holes
resistivity decreases with increase in temperature
the gap between valence and conduction bands is small