Question is ⇒ For a good voltage amplifier, its input impedance should be, Options are ⇒ (A) low as compared to the resistance of the source, (B) high as compared to the resistance of the source, (C) always inductive, (D) always capacitive, (E) , Leave your comments or Download question paper.

Question is ⇒ For a good voltage amplifier, its input impedance should be, Options are ⇒ (A) low as compared to the resistance of the source, (B) high as compared to the resistance of the source, (C) always inductive, (D) always capacitive, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a good voltage amplifier, its input impedance should be
A.	low as compared to the resistance of the source [Wrong Answer]
B.	high as compared to the resistance of the source [Correct Answer]
C.	always inductive [Wrong Answer]
D.	always capacitive [Wrong Answer]
View Answer 4 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a series R-L circuit when excited by a 1 volt battery the current is 1 - e^-t. If it is excited by a source 2 sin t, the current will be
2 sin (t - 45°) + e^-t
2 sin (t + 45°) + e^-t
sin (t - 45°) + e^-t
sin (t + 45°) + e^-t

⇒ The density of dynamic RAM is
the same as static RAM
less than that of static RAM
more than that of static RAM
either equal or less than that of static RAM

⇒ The power dissipation in a transistor is the product of
emitter current and emitter to base voltage
emitter current and collector to emitter voltage
collector current and collector to emitter voltage
none of the above

⇒ If h₁[n] = 3δ[n] + δ[n - 1], h₂[n] = 2δ[n] + δ[n
{6, 18, 7, 4, 0, - 6, 9}
{9, 0, - 6, 21, 7, 6, 1}
{7, - 1, 3, 1, 7, 0, 6}
{9, - 6, 0, 1, 21, 7, 18, 6}

⇒ The current rating of a cable depends on
length of cable
diameter of cable
both length and diameter of cable
none of the above

⇒ An RL series circuit has an impedance of 20 Ω when frequency is 25 Hz. At f= 50 Hz, the impedance will be
40 Ω
20 Ω
less than 40 W but more than 20 Ω
less than 20 W but more than 10 Ω

⇒ Which of these triggering methods for series connected SCRs use LASCR in the gate circuit?
Resistance triggering
Simultaneous triggering
Sequential triggering
Optical triggering

⇒ A computer program is used to read N and compute N !. IF N = 6, the result will be
6
12
720
1040

⇒ Which of the following modes of transmission will not be supported by a rectangular waveguide?
TE₁₅
TE₁₂
TM₁₁
TM₁₀

⇒ In a bistable multivibrator, commutating capacitors are used to
increase the base storage charge
provide ac coupling
increase the speed of response
alter the frequency of the output

⇒ The SCR would be turned OFF by voltage reversal of applied anode-cathode ac supply of frequency of
30 kHz
15 kHz
5 kHz
20 kHz

⇒ When a BJT is operated under saturated condition
both junctions are forward biased
both junctions are reverse biased
CB junction is forward biased and EB junction is reverse biased
EB junction is forward biased and CB junction is reverse biased

⇒ A system has poles at 0.01 Hz, 1 Hz and 80 Hz, zeros at 5 Hz, 100 Hz and 200 Hz. The approximate phase of the system response at 20 Hz is
-90°
0°
90°
-180°

⇒ A FET
has two P-N junctions
has three P-N junctions
depends on the variation of the depletion layer width with reverse voltage, for its operation
depends on the variation of a magnetic field for its operation

⇒ The absolute values of pinch-off voltage and gate-source cut-off voltage are
nearly zero
complementary to each other
never equal
equal

⇒ Which of the following exhibits negative resistance in a portion of its characteristics?
Tunnel diode
Zener diode
JFET
MOSFET and tunnel diode

⇒ Decimal number 5436 when converted into 9's complement will become
4356
4653
4563
4655

⇒ The expression Y = pM (0, 1, 3, 4) is
POS
SOP
Hybrid
none of the above

⇒ Dielectric loss due to polarisation occurs in
bipolar dielectrics
non-metallic dielectrics
liquid dielectrics
all of the above

⇒ The action of bellows is similar to that of
mass
viscous friction
spring
none of the above

⇒ Consider the following

Maximum energy of electrons liberated photoelectrically is independent of light intensity
Maximum energy of electrons liberated photoelectrically varies nonlinearly with frequency of incident light.

(1) is true and (2) is false
(1) and (2) both are true
(1) is false and (2) is true
(1) and (2) both are false

⇒ The sign of a floating point number depends on
only the sign of mantissa
only the sign of exponent
the sign of both mantissa and exponent
either (a) or (b)

⇒

Assertion (A): The resistivity of intrinsic semiconductor decreases with increase in temperature.

Reason (R): The forbidden gap decreases with increase in temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which coupling produces the minimum interference with frequency response?
RC coupling
Transformer coupling
Direct coupling
Impedance coupling

⇒ 2's complement number 00011111 = __________ ₁₀
31
-31
11
-11

⇒ In a 3 phase full wave regulator feeding a star connected resistance load, firing angle is 75°. Then the number of thyristors conducting at one time is
1
2
3
4

⇒ In the state equation x = AX + Bu is a n x m matrix.
TRUE
FALSE

⇒ The function δ' (t-b) is
a step function originating at t = b
an impulse function originating at t = b
a unit doublet originating at = t - b
none of the above

⇒ For the network shown below, if V_D = 12 V and V_GSQ = - 2 V value of R_S wil
13.35 kΩ
3.35 kΩ
33.31 kΩ
3.95 kΩ

⇒

Assertion (A): The dual of a circuit can be drawn by window-dot method.

Reason (R): The principle of duality is of great help in circuit analysis.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true