Question is ⇒ For a given voltage four heating coils will give maximum heat when connected, Options are ⇒ (A) in parallel, (B) in series, (C) with two parallel pairs in series, (D) with one pair in parallel and the other two in series, (E) , Leave your comments or Download question paper.

Question is ⇒ For a given voltage four heating coils will give maximum heat when connected, Options are ⇒ (A) in parallel, (B) in series, (C) with two parallel pairs in series, (D) with one pair in parallel and the other two in series, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a given voltage four heating coils will give maximum heat when connected
A.	in parallel [Correct Answer]
B.	in series [Wrong Answer]
C.	with two parallel pairs in series [Wrong Answer]
D.	with one pair in parallel and the other two in series [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following features of an instrument

suitable for both ac and dc
free from hysteresis and eddy current errors
No waveform and frequency errors
it is essentially a voltmeter

This instrument is
moving iron
moving coil
electrostatic
dynamometer

⇒ A dc network has an open circuit voltage of 5 V. When its terminals are short circuited a current of 5 A flows through the short circuit. If the short circuit is removed and a resistance of 1.5 Ω is connected across its terminals, the current will be
0.0416666666666667
0.0833333333333333
2.5 A
0.208333333333333

⇒ For a full wave bridge rectifier supplied with 50 Hz a.c., the lowest ripple frequency will be
50 Hz
100 Hz
200 Hz
400 Hz

⇒ The speed at which axial electric field due to signal advances in a TWT is equal to
speed of light
(speed of light) (helix pitch helix circumference)
(speed of light) (helix circumference helix pitch)
(speed of light) (helix pitch) (helix circumference)

⇒ If the target area is small compared to wavelength of radar the situation is called
resonance region
Rayleigh region
optical region
binomial region

⇒ It two voltages are v₁ = 100 sin (ωt - 30°) and v₂ = cos ω t then
v₁ is leading v₂ by 30°
v₂ is leading v₁ by 30°
v₂ is leading v₁ by 60°
v₁ is leading v₂ by 60°

⇒ A casual LTI system is described by the difference equat
|a| = 2 |β| < 2
|a| > 2 |β| > 2
|a| < 2 any value of β
|β| < 2, any value of a

⇒ The amplifier network is shown bel
6.42 kΩ, 5.6 kΩ
6.42 Ω, (5.62) kΩ
6.4kΩ, (5.62) kΩ
6.42 Ω, 5.6 kΩ

⇒ Examine the following truth table. The product of sum from this truth tabl
(X + Y) (X + Y)
(X + Y) (X + Y)
(X + Y) (X + Y)
(X + Y) (X + Y)

⇒ Which one of the following statements is wrong. The radar cross-section of a target?
depends on frequency
may be reduced by special coating of non-spherical target
depends on the aspect of target if it is non-spherical
is equal to actual cross-sectional area for small targets

⇒ Consider the cascade structure of two filte
1 and 3
only 2
2 and 3
only 3

⇒ The poles of an RC function
are simple and lie or negative real axis
are simple and lie on ω axis
must be complex conjugate
may be anywhere on s plane

⇒

Assertion (A): Feedback control systems offer more accurate control than open loop systems.

Reason (R): The feedback path establishes a link for comparison of input and output and subsequent error correction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A 3 phase semiconverter when supplying a certain load has a rectification efficiency of 0.6 and transformer utilisation factor of 0.35. When a 3 phase full converter is supplying the same load
rectification efficiency will be more than 0.6 and TUF will be more than 0.35
rectification efficiency will be more than 0.6 but TUF will be less than 0.35
rectification efficiency will be less than 0.6 and TUF will be less than 0.35
rectification efficiency will be less than 0.6 but TUF will be more than 0.35

⇒

Assertion (A): An instruction cycle consists of fetch and execute cycles.

Reason (R): Fetch cycle has one machine cycle but execute cycle may have one or more machine cycles depending on length of instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A conditionally stable system is stable for the value of gain between two critical values. It is unstable if
the gain is increased beyond upper critical value
the gain is decreased below lower critical value
both (a) and (b)
none of the above

⇒ Presently, the worlds's largest and most advanced multi-purpose communication satellite is
INSAT-2
Intelsat-V
INSAT-ID
Olympus-I

⇒ For satellite communication, standard Earth stations have antenna diameters in the range of __________ metre.
27.5 to 30
10 to 15
30 to 50
5 to 10

⇒ In order to achieve accuracy, the slide wire of a potentiometer should be
as long as possible
as short as possible
neither too long nor too short
very thin

⇒ A universal shift register can shift left or right.
TRUE
FALSE

⇒ Start and stop bit do not contain any information but are used in serial communication for
error correction
error detection
synchronization
slowing down the communication

⇒ In admittance parameter set, the dependent variables are the currents at the two ports.
TRUE
FALSE

⇒ The core of a solenoid is made of material of relative permeability μ_r. A small cavity area dA and length dl is cut in the core. If it is desired that flux density in the cavity should be equal to B₀
the fields inside and outside the cavity must be equal
the field inside the cavity must be made stronger than field outside the cavity
the field inside the cavity must be made weaker than the field outside the cavity
none of the above

⇒ From which instant is the turn off time of a thyristor defined
when anode voltage becomes zero
when anode current becomes zero
when both anode voltage and current become zero
none of the above

⇒ The advantage of pulse modulation is
the transmitted power can be concentrated into short bursts
the time intervals between pulses can be filled with sample values from other message
pulse wave may obtain appreciable D.C. and low frequency content
all of the above

⇒ The characteristic equation of a feedback control system is given by s³ + 5s² + (K + 6)s + K
(- 3, 0)
(- 2, 0)
(- 1, 0)
(2, 0)

⇒ If the transmission parameters of the given networks are A = C = 1, B = 2 and D = 3, then the value of Z_{m12/13 Ω
13/12 Ω
3 Ω
4 Ω}

⇒ The units for apparent power are watts.
TRUE
FALSE

⇒ An SCR is triggered at 40° in the positive half cycle only. The average anode current is 50 A. If the firing angle is changed to 80°, the average anode current is likely to be
50 A
25 A
less than 50 A but more than 25 A
less than 25 A

⇒ If E is energy level of electron and E_F is Fermi level, then
all quantum states with E less than E_F will be occupied at T = 0
all quantum states with E less than E_F will be empty at T = 0
some quantum states with E less than E_F will be occupied at T = 0
none of the above