Question is ⇒ For a flexible cable, most suitable insulation is, Options are ⇒ (A) magnesium oxide, (B) glass fibre, (C) insulating tape, (D) polyvinyl chloride, (E) , Leave your comments or Download question paper.

Question is ⇒ For a flexible cable, most suitable insulation is, Options are ⇒ (A) magnesium oxide, (B) glass fibre, (C) insulating tape, (D) polyvinyl chloride, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a flexible cable, most suitable insulation is
A.	magnesium oxide [Wrong Answer]
B.	glass fibre [Wrong Answer]
C.	insulating tape [Wrong Answer]
D.	polyvinyl chloride [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The standard intermediate frequency for FM ratio is
10.7 MHz
4.5 MHz
75 kHz
455 kHz

⇒ The total number of channels allotted for cellular telephone is
666
333
221
111

⇒ In high power radars, which of the following are used for switching?
Power diode
Power BJT
Power MOSFET
Thyristor

⇒ Power Point is a presentation software.
TRUE
FALSE

⇒ Which is not a software?
DOS
Windows
MS WORD
Hard disk

⇒ When microwave signals follow the curvature of the earth, this is known as
the Faraday effect
ducting
tropospheric scatter
ionospheric reflection

⇒ In a channel voice coder, the outputs of sixteen 20 Hz low pass filters are sampled, multiplexed and A/D converted. If sampling is at 40 samples/second and 3 bits/sample represents each voltage sample, the bit rate is about
1.9 k bits/sec
0.95 k bits/sec
3.8 k bits/sec
7.6 k bits/sec

⇒ MF is generally used for
telegraphy
radio and television links
satellite communication
broadcasting, navigation

⇒ In figure the diode is ideal (zero cut in voltage zero forward resistance). Then the current through diod
0
0.166666666666667
0.0416666666666667
none of the above

⇒ If f₁(t)<< F₁(jω) and f₂(t)↔ F₂(jω), then [a₁ f₁(t) + a₂f₂(t)]↔
a₁F₁(jω) + a₂F₂(jω)
a₁a₂F₁(jω) + F₂(jω)
a₁F₁(jω) - a₂F₂(jω)
a₁F₁*(jω) + a₂F₂*(jω)

⇒ The I/P impedance of a short circuited quarter wave long transmission line is
purely reactive
purely resistive
depend on the characteristic impedance of the line
none of the above

⇒ Diamagnetic materials do not have permanent magnetic dipoles.
TRUE
FALSE

⇒ Dielectric materials have high specific resistance.
TRUE
FALSE

⇒ In 8085 stack pointer is
4 bit register
8 bit register
16 bit register
32 bit register

⇒ As compared to a p-n junction diode
a schottky diode has lower cut in voltage and lower reverse saturation current
a schottky diode has higher cut in voltage and higher reverse saturation current
a Schottky diode has lower cut in voltage and higher reverse saturation current
a schottky diode has higher cut in voltage and lower reverse saturation current

⇒ A network is said to be non-linear if it does not satisfy
homogeneity condition
superposition condition
both (a) and (b)
associative condition

⇒ Silicon diodes have __________ reverse resistance than germanium diodes.
a much smaller
a much larger
an infinite
a negligible

⇒ In a resistor the current is i and the voltage is v. The rate of dissipation of heat at any time t is
vi
vit
vt
vit²

⇒ In a single phase cycloconverter with centre tapped transformer
all thyristors carry currents for equal duration
the durations of currents in all thyristors may or may not be equal
the durations of currents in all thyristors cannot be equal
the duration of currents in all thyristors must be equal for satisfactory operation

⇒ For a diamagnetic material, μ_r = 1.
TRUE
FALSE

⇒ ADC 0804 is a
dual slope A/D converter
single slope A/D converter
successive approximation A/D converter
either (a) or (b)

⇒ Voltage standing wave pattern in a loss less transmission line with characteristic impedance 50 Ω and a resistive load is shown in the figu
50 Ω
200 Ω
12.5 Ω
0 Ω

⇒ RF amplifiers are used in radio receivers for
better sensitivity
improved signal-to-noise ratio
better coupling of receiver to the antenna
all of the above

⇒ A certain transistor has a_dc of 0.98 and a collectors leakage current of 5 μA. If I_E = 1 mA, the collector current will be
1.005 mA
0.985 mA
0.975 mA
0.955 mA

⇒ In the circuit of figure the current through 5 Ω resistance at t = &infin
0.166666666666667
2.5 A
3.1 A
0

⇒ As the number SWG increases, area of cross-section decreases.
TRUE
FALSE

⇒ An m derived low pass filter has f_c = 1000 Hz, f_∞ = 1250 Hz and m = 0.6. If m is increased, then
both f_c and f_∞ will increase
both f_c and f_∞ will decrease
f_c will remain constant but f_∞ will decrease
f_c will remain constant but f_∞ will increase

⇒ If the number of information bits is m, the number of parity bits p in the Hamming code is given by equation
2^p = m + p + 1
2^p ≥ m + p + 1
2^P = m + p
2^p ≥ m + p

⇒ An antenna having a high Q has
lower BW
higher BW
flat response
none of the above

⇒ Which of the following parameters of CE circuit has the unit of ohms?
h_ie
h_re
h_fe
h_oe