Question is ⇒ For a circular wave guide, Options are ⇒ (A) cutoff frequency for TE10 and TE01 modes are same, (B) cutoff frequency for TE10 and TE01 modes are different, (C) cutoff frequency for TE10 mode = twice the cutoff frequency for TE20 mode, (D) cutoff frequency for TE10 mode = haf the cutoff frequency for TE20 mode, (E) , Leave your comments or Download question paper.

Question is ⇒ For a circular wave guide, Options are ⇒ (A) cutoff frequency for TE10 and TE01 modes are same, (B) cutoff frequency for TE10 and TE01 modes are different, (C) cutoff frequency for TE10 mode = twice the cutoff frequency for TE20 mode, (D) cutoff frequency for TE10 mode = haf the cutoff frequency for TE20 mode, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a circular wave guide
A.	cutoff frequency for TE₁₀ and TE₀₁ modes are same [Correct Answer]
B.	cutoff frequency for TE₁₀ and TE₀₁ modes are different [Wrong Answer]
C.	cutoff frequency for TE₁₀ mode = twice the cutoff frequency for TE₂₀ mode [Wrong Answer]
D.	cutoff frequency for TE₁₀ mode = haf the cutoff frequency for TE₂₀ mode [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following in C

Arithmetic operations can be performed on ints.
Arithmetic operations can be performed on floats.
Arithmetic operation can be performed on chars

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ In a lead acid battery
the numbers of positive and negative plates are equal
the number of positive plates may be equal to or more than the number of negative plates
the number of positive plates is more than the number of negative plates
the number of negative plates is more than the number of positive plates

⇒ When a line short circuited at far end, the minimum voltage occurs at
far end
source end
midway between source and far end
none of the above

⇒ The most commonly used microphone for public address systems is
carbon
crystal
moving coil
condenser

⇒ Which of the following is not a DTP program?
Page maker
Coral draw
Coral ventura
Coral key

⇒ A binary adder has
one half adder
one half adder and 2 full adders
two half adders
one half adder and many full adders

⇒ In a CE amplifier the input impedance is equal to the ratio of
ac base voltage to ac base current
ac base voltage to ac emitter current
ac emitter voltage to ac collector current
ac collector voltage to ac collector current

⇒ Which of the following op-amp circuits has zero resistance in the feedback path?
Inverting amplifier
Summing amplifier
Source follower
Integrating amplifier

⇒ Which display device resembles vacuum tube?
LED
LCD
VF
None of these

⇒ The number of channels available in MF band (300 kHz - 3 MHz) for AM modulating signal of 20 kHz is
70
67
100
150

⇒ A single phase full wave regulator feeds R-L load. The best gating signal is
short duration pulses
long duration pulses
pulse train
either (a) or (b)

⇒

Assertion (A): A tuned amplifier uses a parallel tuned circuit

Reason (R): A tuned amplifier is used to amplify a narrowband frequencies

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a zener diode
the forward current is very high
sharp breakdown occurs at a certain reverse voltage
the ratio v-i can be negative
there are two p-n junctions

⇒ Dielectric materials have high specific resistance.
TRUE
FALSE

⇒ For the network shown below, if V_D = 12 V and V_GSQ = - 2 V value of R_S wil
13.35 kΩ
3.35 kΩ
33.31 kΩ
3.95 kΩ

⇒ A single phase cycloconverter feeds a resistance heating load. The heating power is provided by
only the fundamental component of output wave
only higher harmonics in the output wave
both fundamental and higher harmonics in the output wave
either (a) or (b)

⇒ If transmitted power is 10 kW, the field strength at a distance d is 50 mV/m. If transmitted power is reduced to 2.5 kW, the field strength at the same point will be
25 mV/m
12.5 mV/m
6.25 mV/m
3.125 mV/m

⇒ The electrochemical equivalent of a material
depends on its valency
depends on its atomic weight
depends on its valency and atomic weight
depends on the degree of hardness of the material

⇒ A rectangular waveguide (2.29 x 1.02) cm operates at a freq. of 11 GHz in TE₁₀ mode. If the maximum potential gradient of the signal is 5 kV/cm, then the maximum power handling capacity of the waveguide will be
31.11 mW
31.11 W
31.11 kW
31.11 MW

⇒ In the words Kb or Mb used describing memory capacity, the letter b denotes
bits
bytes
bits or bytes depending on type of memory
bubbles

⇒ According to Siegel and Labus, antenna can be treated as
closed transmission line
shorted transmission line
earthed transmission line
opened-out transmission line

⇒ Low gain-bandwidth product of a JFET is due to
reduced number of holes
junction capacitive effects
low degree of isolation between input and output
all of the above

⇒ In a 3 phase fully controlled converter the firing frequency is
3 times the line frequency
6 times the line frequency
9 times the line frequency
12 times the line frequency

⇒

Assertion (A): The sign and magnitude of displacement can be measured by an LVDT.

Reason (R): LVDT is based on the principle of mutual inductance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The nodal method of circuit analysis is based on
KVLs, ohm law
KCLs, ohm law
KCLs, KVL
KCL, KVL, ohms law

⇒ Two coils X of 1000 turns and Y of 2000 turns are placed such that 60% of the flux produced by coil X links coil Y. A current of 1 A in coil X produces 0.1 wb flux. The mutual inductance between coils is
0.12 H
0.08 H
0.06 H
0.04 H

⇒ The Table given below is the mark obtained by 2 students in 8 different subjec
-0.4748
0.4748
-0.0338
0.0338

⇒ An AND gate has two inputs A and B and one inhibit input 3, Output is 1 if
A = 1, B = 1, S = 1
A = 1, B = 1, S = 0
A = 1, B = 0, S = 1
A = 1, B = 0, S = 0

⇒ Energy content of atmospheric noise
does not depend on frequency
decreases as frequency is increased
increases as frequency is increased
either (a) or (c) depending on the temperature

⇒ Two thyristor of same rating and same specifications
will have equal turn on and turn off periods
will have equal turn on but unequal turn off periods
may have equal or unequal turn on and turn off periods
will have unequal turn on and turn off periods