Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | For a 2 port network, the O/P short circuit current was measured with a 1 volt source at the I/P then value of the current gives |

A. | h_{12} [Wrong Answer] |

B. | y_{12} [Wrong Answer] |

C. | h_{21} [Wrong Answer] |

D. | y_{21} [Correct Answer] |

View Answer
Explanation:-
Answer : DDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ A matched generator (Z

_{g}= Z

_{0}) with 1 Ω available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are

0.5 W, 0.5 W, 0 W

0 W, 0 W, 1 W

0.33 W each

0 W, 0.25 W, 0.25 W

⇒ In an ac circuit, the maximum and minimum values of power factor can be

2 and 0

1 and 0

0 and -1

1 and -1

⇒ 10's complement of 16

_{10}is

83

_{10}

84

_{10}

38

_{10}

48

_{10}

⇒ Microwaves

get reflected by ionosphere

are absorbed by ionosphere

are neither reflected nor absorbed by ionosphere

are both reflected and absorbed by ionosphere

⇒ If number of information bits is 11, the number of parity bits in Hamming code is

5

4

3

2

⇒ The directive gain of λ/2 resonant wire is 1.64.

TRUE

FALSE

⇒ Which of the following factors are responsible to design IC logic gates to operated at a fixed supply voltage of 5 volts?

- Low heating of IC logic gates
- Compatibility with other logic gates
- Satisfactory and safe operation
- Standardization from IC manufacturing point of view.

1 only

2 only

2 and 3

3 and 4

⇒ The unit of permeability is

T

Wb

H/M

H

⇒ An RC impedance function has a constant value at

*s*= 0. The last element in the first cauer synthesis

will be a capacitor

may be R or C

will be R

will depend on the behaviour of function at

*s*= ∞

⇒ The fourier transform of the half cosine pulse as shown below is _______

0.5 {sin [0.5(

*f*- 1)] + sin [0.5 (

*f*+ 1)]}

0.25 [sin c[0.25 (

*f*- 2)1 + sin c[0.25(

*f*+ 2)]]

0.5 {sin c [0.5 (

*f*- 1)] + sin c [0.5 (

*f*+ 1)]}

sin c(

*f*- 0.5) + sin c (

*f*+ 0.5)

⇒ When a material becomes a superconductor, its resistivity becomes

very small

zero

about 10% of normal value

about 20% of normal value

⇒ Complex pole in z-plane is as shown below. This is the pole diagram for ________

Decaying sinusoidal sequence

Growing sinusoidal sequence

Decaying non sinusoidal sequence

Growing non sinusoidal sequence

⇒ A single phase half wave converter is feeding a resistive load. Just before triggering, the voltage across thyristor is

zero

about 1 V

same as input voltage

twice the input voltage

⇒ For TE or TM modes of propagation in bounded media, the phase velocity is

independent of frequency

is a linear function of frequency

is a non-linear function of frequency

can be frequency dependent or frequency independent on the source

⇒ A transistor is operated as non-saturated switch to eliminate

turn on time

turn off time

storage time

delay time

⇒

**Assertion (A):** Impedance matching can be done by using stubs.

**Reason (R):** A double stub is used for impedance matching when frequency of signal varies.

Both A and R are correct and R is correct explanation of A

Both A and R are correct but R is not correct explanation of A

A is correct but R is wrong

A is wrong but R is correct

⇒ In figure the voltage distribution on a vertical earthed antenna is represented

curve A

curve B

curve C

curve D

⇒ In a biased limiter the clipping level can be adjusted by adjusting the voltage of battery.

TRUE

FALSE

⇒ 24 telephone channels, each band limited to 3.4 kHz are to be time division multiplexed using PCM. If sampling frequency is 10 kHz and number of quantization levels is 128, the required bandwidth of PCM is

1.68 MHz

240 kHz

81.6 kHz

3.072 MHz

⇒ The dependent current source shown in given fig

delivers 80W

absorbs 80W

deliver 40W

absorbs 40W

⇒ The term 'Poisson's ratio' is connected with

strain gauge

LVDT

Bourden tube

capacitance transducer

⇒ The capacitance of a cylindrical capacitor is directly proportional to its length.

TRUE

FALSE

⇒

Match the following:

List I (Properties) | List II (Relations) | ||
---|---|---|---|

A. | Linear but NOT time-invariant | 1. | y(t) = t^{2}x(t) |

B. | Time-invariant but NOT linear | 2. | y(t) = t |x(t)| |

C. | Linear and time invariant | 3. | y(t) = |x(t)| |

4. | y(t) = x(t - 5) |

A-1, B-3, C-4

A-2, B-3, C-4

A-3, B-1, C-2

A-1, B-2, C-3

⇒ If the sign bit of mantissa is 0 and the exponent is increased from a positive to a more negative number the result is

a larger floating point number

a smaller floating point number

either (a) or (b) depending on the actual number

a negative floating point number

⇒ Which of the following is not a keyword in C?

int

float

return

capital

⇒ The antenna current of an AM transmitter is 8 A. When only the carrier is sent, but it increases to 8.93 A. When the carrier is sinusoidally modulated. The percentage modulation is nearly

0.9

0.8

0.75

0.7

⇒ Which of the following diode is designed to operate in the breakdown region?

Signal diode

Power diode

Zener diode

None of the above

⇒ The directive gain of a transmitting antenna is proportional to

its cross-sectional area

square of cross-sectional area

square root of cross-sectional area

cube root of cross-sectional area

⇒ In the following figure C = 0.02 μF, and V

_{th}is known to be of frequency ω = 10

^{7}rad/sec and

*r*

_{d}= 2.5 Ω and Z

_{Th}= R

_{Th}= 10 Ω Then phase angle between

*i*

_{d}and V

_{d26.5°25°30°0°}

⇒ If

*i*= 10 + 12 cos 500

*t*- 3.5 sin 500

*t*, then in amplitude phasse form

*i*=

10 + 12.5 sin (500

*t*+ 106.20°)

5 + 12.5 sin (500

*t*+ 106.20°)

10 + 11 sin (500

*t*+ 106.20°)

10 + 12.5 sin (500

*t*+ 10°)