Question is ⇒ For 8 bit representation the minimum positive and minimum negative numbers are, Options are ⇒ (A) 2-128 each, (B) 2-28 and 2-127, (C) 2-127 and 2-128, (D) 2-127each, (E) , Leave your comments or Download question paper.

Question is ⇒ For 8 bit representation the minimum positive and minimum negative numbers are, Options are ⇒ (A) 2-128 each, (B) 2-28 and 2-127, (C) 2-127 and 2-128, (D) 2-127each, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For 8 bit representation the minimum positive and minimum negative numbers are
A.	2^-128 each [Correct Answer]
B.	2^-28 and 2^-127 [Wrong Answer]
C.	2^-127 and 2^-128 [Wrong Answer]
D.	2^-127each [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which one of the following compounds is widely used for making ferrites?
FeO
CuO
MgO
Fe₂O₃

⇒ In a stop-and-wait ARQ system, the transmitting terminal
waits for positive or negative acknowled-gement from the receiving terminal after sending a block
sends another block if positive acknowledge is received through ACK character
resends the previous block if negative acknowledgement is received through a NAK character
does not wait for acknowledgement after sending a block

⇒ For transmission line load matching over a range of frequencies, it is best to use a
double stub
balun
single stub of adjustable position
broadband directional coupler

⇒ Strip lines are used at
microwave frequency
low frequency
High frequency
at any frequency

⇒ In PCM, if the number of quantization levels is increased from 4 to 64, then the bandwidth requirement will approximately be increased __________ times.
8
16
3
32

⇒ A 3 phase bridge inverter is fed by 400 V battery. The load is star connected and has a resistance of 10 Ω per phase. The peak value of load current is
40 A
20 A
0.416666666666667
0.208333333333333

⇒ From an n channel JFET for V_DS constant and if V_GS is made more negative, pinch off would occur at
higher value of drain current
saturation value of drain current
zero drain current
gate current equal to drain current

⇒ The absorption of radio waves by the atmosphere depends on
the polarization of the waves
the polarization of the atmosphere
frequency of the waves
their distance from the transmitter

⇒ The directivity of 20 turn helix having a = 12° circumference equal to one wavelength, will be
1.8 dB
6 dB
12 dB
18 dB

⇒ e^-2t is __________ .
energy signal
power signal
neither energy signal nor power signal
both energy and power signal

⇒ In an ac network the sum of currents entering a node is 10 ∠45°. The sum of currents leaving the node is
19.32 ∠45°
15 ∠45°
20 ∠45°
zero

⇒ If X(z) = (1 - az^-1)^-1 and |a| < |z|, the initial value x₀ = 0
TRUE
FALSE

⇒ In figure if C is replaced by short circuit then R_B wil
425 K
412 K
474 K
400 K

⇒ Two thyristors of the same rating and specifications
will have equal on state voltage drops
will have equal forward blocking voltage for the same current
will have different on state voltage drops
may have equal or different on state voltage drops and equal or different forward blocking voltage's for the same current

⇒ The time base of a high frequency CRO whose screen diameter is 10 cm is set at 10 μ sec/cm. The lowest frequency which can be fully displayed on the screen is
more than 100 kHz
equal to 100 kHz
equal to 10 kHz
less than 10 kHz

⇒ When a material is in superconducting state and a magnetic field is applied
the superconducting property is not affected
the superconducting property may be affected and resistivity may increase from zero to a low value
the superconducting property may be destroyed
the material may become an insulator

⇒ The correct relation between energy and charge is
Energy = voltage/charge
Charge = Energy x voltage
Energy = voltage (charge)^0.5
Energy = voltage x charge

⇒ Each instruction in assembly language program has the following fields:

Lable field
Mnemonic field
Operand field
Comment field

The correct sequence of these fields is?
1, 2, 3, 4
1, 2, 4, 3
2, 1, 3, 4
2, 1, 4, 3

⇒ It is known that noise phase modulates the FM wave. As the noise side band frequency approaches the carrier frequency, the noise amplitude
will increase
will decrease
will remain constant
will reduce to negligible value

⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals

⇒ In the circuit, the value of the voltage source
-22 V
-12 V
+12 V
-10 V

⇒ The output of a full adder is
SUM
CARRY
SUM and CARRY
none of the above

⇒ The input voltage for starting oscillations in an oscillator is caused by
negative feedback
positive feedback
noise voltage in resistors
a special generator

⇒ For an ideal 3000 Hz channel, Nyquist rate is
3000 bps
6000 bps
9000 bps
12000 bps

⇒ 7BF₁₆ = __________ ₂
0111 1011 1110
0111 1011 1111
0111 1011 0111
0111 1011 0011

⇒ The effect of a finite gain of operational amplifier used in an integrator is that
it would not integrator
slope of the O/P will varied with time
final value of the O/P
there will be instability in the cirucuit

⇒ Addition of a small amount of antimony to germanium will result in
formation of P-type semiconductor
more free electrons than holes in the semiconductor
antimony concentrating on the edges of the crystals
increased resistance

⇒ A line of characteristic impedance Z₀ branches into two line each with characteristic impedance Z₀. The refracted voltage is
zero
infinite
equal to incident voltage
two third of incident voltage

⇒ For a junction FET in the pinch off region, as the drain voltage is increased, the drain current
becomes zero
abruptly decrease
abruptly increases
remains constant

⇒ In an LC filter, the ripple factor,
increases with load current
increases with load resistance
remains constant with the load current
has the lowest value