Question is ⇒ Following is a reason of distortion in communication system, Options are ⇒ (A) external interference, (B) random variations, (C) insufficient Channel Bandwidth, (D) all, (E) , Leave your comments or Download question paper.

Question is ⇒ Following is a reason of distortion in communication system, Options are ⇒ (A) external interference, (B) random variations, (C) insufficient Channel Bandwidth, (D) all, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Following is a reason of distortion in communication system
A.	external interference [Wrong Answer]
B.	random variations [Wrong Answer]
C.	insufficient Channel Bandwidth [Wrong Answer]
D.	all [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a combination limiter with sinusoidal input voltage the output wave can be nearly square.
TRUE
FALSE

⇒

Assertion (A): A PROM can be used as a synchronous counter

Reason (R): Each memory location in a PROM can be read synchronously.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ T.V. broadcasting based on
line of sight communication
ionospheric propagation
ground wave
medium wave

⇒ The effective refraction index of the ionosphere for radio wave is
more than unity
less than unity
equal to unity
either more or less than unity depending on the electron concentration

⇒ In which region of a CE bipolar transistor is collector current almost constant?
Saturation region
Active region
Breakdown region
Both saturation and active region

⇒ Consider the following statements as regards advantages of CCD sensors as camera pick up tube

High sensitivity
Good spectral response
Image lag absent

Out of the above which are correct
1, 2, 3
1, and 2 only
1 and 3 only
2 and 3 only

⇒ A telephone exchange has 9000 subscribers. If the number of calls originating at peak time is 10, 000 in one hour, the calling rate is
0.9
43017
0.81
0.1

⇒ In the transformer shown in figure, the inductance measured across terminal 1 and 2 was 4 H with terminals 3 and 4 open. It was 3H when terminals 3 and 4 are short circuited. The coefficient of couplin
1
0.707
0.5
indeterminate due to insufficient data

⇒ For a good public address system the sound intensity at the farthest point should be at least
20 dB over threshold of hearing
40 dB over threshold of hearing
80 dB over threshold of hearing
120 dB over threshold of hearing

⇒ To draw ac equivalent circuit for a CE amplifier we should
Reduce all dc sources to zero
Short all capacitors
Reduce all dc sources to zero and short all capacitors
Reduce all dc sources to zero and open all capacitors

⇒ For checking the parity of a digital word, it is preferable to use
AND gates
NAND gates
EX-OR gates
NOR gates

⇒ For the system of the given figure, the closed loop poles ar
0 and -4
-2 ± j6
2 ± j6
-3 ± j8

⇒ The main use of JFET with a
frequency mixer
source follower
voltage doubler
trigger

⇒ If a complex voltage wave is applied to a pure inductance, the resulting current wave is much smoother than the voltage wave.
TRUE
FALSE

⇒ An air-filled rectangular waveguide has dimensions 8cm x 10cm . The phase velocity of guided wave at frequency of 3 GHz for TE₁₀ mode is
1.5 x 10⁸ m/s
5.5 x 10⁸ m/s
3.46 x 10⁸ m/s
0.18 x 10⁷ m/s

⇒

Assertion (A): In CE amplifier the emitter is at ground potential for ac signals

Reason (R): A CE amplifier has near unity voltage gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): A JFET can be used as a current source.

Reason (R): In beyond pinch off region the current in JFET is nearly constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A series resonant circuit is capacitive at f = 150 Hz. The circuit will be inductive somewhere at
f greater than 150 Hz
f less than 150 Hz
f equal to 150 Hz by increasing the value of the resistance
none of the above

⇒ In the given figure shows a negative logic AND gate. If positive logic is used this gate is equivalen
AND gate
OR gate
NOR gate
NAND gate

⇒ Resistivity of copper is lower than that of nickel. When a small percentage of copper is added to nickel, the resistivity
increases
decreases
may increase or decrease
remains the same

⇒ In a 3 phase semiconverter, the freewheeling diode comes into operation only if firing angle
is zero
is 60°
is more than 60°
is more than 90°

⇒ FM broadcast is done using
medium waves
short waves
VHF and UHF waves
microwaves

⇒ A series RLC circuit has Q = 5. A voltage of 10 V rms is applied to it. At resonance, the voltage across C is
10 V rms
10 V peak
50 V rms
50 V peak

⇒ In figure, the current supplied by battery immediately after switching on the circui
0.0416666666666667
0.166666666666667
0.416666666666667
0

⇒ If f=0
X_L = 0 and X_C = 0
X_L = ∞, X_C = ∞
X_L = 0 and X_C = ∞
X_L = ∞ and X_C = 0

⇒ Consider the following symbols

Letters A to Z and a to z
Digits 0 to 9
Logical operators and, or, not
Parenthesis ( )

Which of the above symbols are available in Pascal?
1 and 2 only
1, 2 and 3 only
1, 2 and 4 only
All

⇒ A n-type silicon sample contains a donor concentration of N_d = 2 x 10¹⁶ cm^-3. The minority carrier hole lifetime is t_p0 = 5 μs. The thermal equilibrium generation rate of hole is:
1.125 x 10⁹ cm^-3 s^-1
0.625 x 10⁹ cm^-3 s^-1
4.5 x 10⁹ cm^-3 s^-1
2.25 x 10⁹ cm^-3 s^-1

⇒ FIR filter Passes __________ Phase.
non-linear phase
linear phase
variable phase
none

⇒

Assertion (A): The phenomenon of differential mobility is called transferred electron effect.

Reason (R): GaAs exhibits transferred electron effect.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Match the following:

	List I (Binary)		List II (Hexadecimal)
A.	10101010	1.	FF
B.	11111111	2.	88
C.	10001000	3.	92
D.	10010010	4.	AA

A-4, B-1, C-2, D-3
A-1, B-2, C-3, D-4
A-3, B-1, C-2, D-4
A-1, B-3, C-4, D-1