Question is ⇒ FM is named so because, Options are ⇒ (A) it restrains the frequency excursions of FM, (B) it increases the frequency excursions of FM, (C) it decreases the amplitude of FM signal, (D) it increases the amplitude of FM signal, (E) , Leave your comments or Download question paper.

Question is ⇒ FM is named so because, Options are ⇒ (A) it restrains the frequency excursions of FM, (B) it increases the frequency excursions of FM, (C) it decreases the amplitude of FM signal, (D) it increases the amplitude of FM signal, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	FM is named so because
A.	it restrains the frequency excursions of FM [Correct Answer]
B.	it increases the frequency excursions of FM [Wrong Answer]
C.	it decreases the amplitude of FM signal [Wrong Answer]
D.	it increases the amplitude of FM signal [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A loss less transmission line is terminated in a load which reflects a part of the incident power. The measured VSWR is 2. The percentage of the power that is reflected back is
57.73
33.33
0.11
11.11

⇒ If x^k is one sided to the ri
TRUE
FALSE

⇒ In commercial electron tubes the current produced by the cathode at 1000 K is about
0.01 A per cm² of cathode surface
0.1 A per cm² of cathode surface
1 A per cm² of cathode surface
5 A per cm² of cathode surface

⇒ The unit of ∇ x H is
Ampere
Ampere/meter
Ampere/m²
Ampere-meter

⇒ Which of the following output configurations are available in a TTL gate?

Open collector output
Totem pole output
Tristate output

Select the correct answer from the codes given below:
1 only
1 and 2 only
2 and 3 only
1, 2 and 3

⇒ In a transistor receiver, the use of FET as the first stage amplifier is likely to
improve selectivity of the receiver
improve the effectiveness of the AGC
reduce the effect of negative peak clipping
reduce the effect of noise at all frequencies

⇒ RAM can be expanded to
increase word size
increase word number
either increase word size or increase word number
none of the above

⇒ In each of circuits below, indicate which diode is conduct
Figure A
Figure B
Figure C
All the three

⇒ The inductance of a single layer solenoid of 10 turns is 5 μH. Which one of the following is the correct value of inductance when the number of turns is 20 and the length is doubled.
10 μH
20 μH
40 μH
5 μH

⇒

Assertion (A): When all inputs of a NAND-gate are shorted to get a one input, one output gate, it becomes an inverter.

Reason (R): When all inputs of a NAND-gate are at logic 'O' level, the output is at logic 'I' level.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): A quarter wave transformer is used to match a resistive load to a transmission line.

Reason (R): A quarter wave transformer is a transmission line of quarter wave length.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): The dual of a circuit can be drawn by window-dot method.

Reason (R): The principle of duality is of great help in circuit analysis.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ As compared to TTL, CMOS logic has
higher speed of operation
higher power dissipation
smaller physical size
all of the above

⇒ In a JK Master slave flip flop
both master and slave are positively clocked
both master and slave are negatively clocked
master is positively clocked and slave is negatively clocked
master is negatively clocked and slave is positively clocked

⇒ A 4 bit ripple counter uses flip flops with propagation delay of 50 ns each. The maximum clock frequency which can be used is
5 MHz
10 MHz
20 MHz
25 MHz

⇒ Maxwell's divergence equation for the magnetic field is given as
∇ . B = 0
∇² . B = 0
∇ . B = constant
∇² . B = constant

⇒ Multiplex techniques are used for
low density communications
low density point-to-point communications
high-density point-to-point communications
all of the above

⇒

Match the following:

	List I		List II
A.	Multiplexer	1.	Sequential memory
B.	De-multiplexer	2.	Converts decimal number to binary
C.	Shift register	3.	Data selector
D.	Encoder	4.	Routes single input to many outputs

A-3, B-4, C-1, D-2
A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-1, B-2, C-3, D-4

⇒ A two branch parallel tuned circuit has 100 Ω resistance and 0.1 H inductance in one branch and 10^-6 F capacitor in the other. At resonance frequency, the dynamic resistance is
10 Ω
100 Ω
1000 Ω
10000 Ω

⇒ F₂ layer of atmosphere extends from
250 km to 400 km
150 km to 250 km
50 km to 150 km
15 km to 50 km

⇒ Which of the following does not cause losses in optical fibre cables?
Impurities
Microbending
Attenuation in glass
Stepped index operation

⇒ For a base current of 10 μA, what is the value of collector current in common emitter if β_dc = 100
10 μA
100 μA
1 mA
10 mA

⇒ Each instruction in assembly language program has the following fields:

Lable field
Mnemonic field
Operand field
Comment field

The correct sequence of these fields is?
1, 2, 3, 4
1, 2, 4, 3
2, 1, 3, 4
2, 1, 4, 3

⇒ A tie set schedule shows
incidence of branches to nodes
incidence of branches to loops
incidence of nodes to loops
none of the above

⇒

Assertion (A): Tristate logic is used for bus oriented systems

Reason (R): The outputs of a tristate logic are 0, 1 and indeterminant.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A half adder adds
2 bits
3 bits
4 bits
2 or 3 bits

⇒ Present day stereophonic systems have
only CD playback facility
only tape playback facility
both CD and tape playback facilities along with radio
none of the above

⇒ Calculate the O/P voltage of a non-inverting constant gain multiplier with R₁ = 100 kΩ, R_f= 600 kΩ, V₁ = 2 volt, then O/P voltage V_o of non inverting op-amp is given by
16 V
14 V
20 V
15 V

⇒ If the ladder reference voltage is 2 V, then minimum comparator resolution required is
0.125 V
1.25 V
12.5 V
0

⇒ The attenuation characteristics of a loaded line is similar to that of
low pass filter
high pass filter
band pass filter
band stop filter