Question is ⇒ FM has poor efficiency than, Options are ⇒ (A) AM, (B) AM-SC, (C) PAM, (D) PCM, (E) , Leave your comments or Download question paper.

Question is ⇒ FM has poor efficiency than, Options are ⇒ (A) AM, (B) AM-SC, (C) PAM, (D) PCM, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	FM has poor efficiency than
A.	AM [Wrong Answer]
B.	AM-SC [Correct Answer]
C.	PAM [Wrong Answer]
D.	PCM [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a second order system with 0 < ξ < 1, the angle which poles make with negative real axis is
sin^-1 ξ
cos^-1 ξ
tan^-1 ξ
cot^-1 ξ

⇒ In 8086 microprocessor, if the segment register contains 1 FAB and IP register contains 10AI, the effective memory address is
20B51
304C
FBC0
FDB5

⇒ In the circuit shown, the steady state is reached with S open S is closed at t = 0, the current I in the 1 Ω resistor connected is to be determined at t = 0⁺ is give
1
2
3
42828

⇒ Which of the following can not be used as a variable name in C?
else
coal
ram
vendy

⇒ The causal system given below is _______
minimum phase
maximum phase
mixed phase
none of these

⇒ In the circuit of figure both diodes are ideal. If v₁ = 10 V and v₂ = 10 V which diode will cond
D₁ only
D₂ only
Both D₁ and D₂
Neither D₁ nor D₂

⇒ The input to integrating op-amp is a rectangular wave. The output will be
a sine wave
a rectangular wave
a triangular wave
none of the above

⇒ In figure the potential of gate termina
4 V
-4 V
0
20 V

⇒ The materials having low retentivity are suitable for making
temporary smagnets
weak magnets
permanent magnets
both temporary and permanent magnets

⇒ In figure, the curre
is 2 A from A to B
is 2 A from B to A
depends on the value of R
none of the above

⇒ The channel required for FM telemetry is
same as required for AM telemetry
smaller than that required by AM telemetry
100 times that required for AM telemetry
10 times that required for AM telemetry

⇒ The open loop frequency response of a unity feed back system is as u
20 dB and 15°
20 dB and 25°
6 dB and 15°
6 dB and 25°

⇒ The torque in induction wattmeters due to
capacitive current
electrostatic effect
hall effect
eddy currents

⇒ Which one of the following blocks is not common in both AM and FM receivers?
RF amplifier
Mixer
IF amplifier
Slope detector

⇒ The amplifier circuit shown below uses a silicon transistor. The capacitors C_c and C_E can be assumed to be short at signal frequency and the effect of output resistance r₀ can be ignored. If C_E is disconnected from the circuit, which one of the following statements is T
The input resistance R_i increases and the magnitude of voltage gain A_v decreases
The input resistance R_i decreases and the magnitude of voltage gain A_v decreases
Both input resistance R_i and the magnitude of voltage gain A_v decrease
Both input resistance R_i and the magnitude of voltage gain A_v increase

⇒ The port of PC to which mouse is connected is called
serial port
parallel port
input port
scanner port

⇒ An ac circuit has two branches in parallel. The impedances of the two branches are equal. The p.f. of one branch is 0.8 lagging and 0.8 leading. The overall p.f. is
zero
0.5 lagging
1
0.7 lagging

⇒ In solid insulator materials having only one kind of atom, the types of polarization which exist are
electronic only
electronic and ionic
electronic, ionic and permanent
electronic and permanent

⇒ A₁₆ X 2₁₆ __________ .
16₁₆
15₁₆
14₁₆
13₁₆

⇒ A number of impulses spaced fron one another form an impulse train.
TRUE
FALSE

⇒ The current in a circuit with 10 Ω resistance is i = 3 + 4 sin (100 t + 45°) + 4 sin (300 t + 60°) A. The rms current and power dissipated are
41 A and 410 W
35 A and 350 W
5 A and 250 W
11 A and 1210 W

⇒ For holding the drain current constant in spite of large changes in JFET parameters
current source bias is used
voltage divider bias is used
reverse bias is used
no bias is used

⇒ Which of the following is basically a voltage controlled capacitance?
Zener diode
Diode
Varactor diode
LED

⇒ The specified maximum junction temperature of thyristors is about
50°C
80°C
120°C
200°C

⇒

Assertion (A): Silicon is less sensitive to changes in temperature than germanium.

Reason (R): Cut in voltage in silicon is less than that in germanium.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a single phase full wave regulator feeding a resistive load, the average current over one full cycle
is always zero
cannot be zero
may be sometimes zero
is always positive

⇒ Cassergain feed is used with a parabolic reflector to
increase the gain of the system
increase the beamwidth of the system
reduce the size of the main reflector
allow the feed to be placed at a convenient point

⇒ Consider the following stateme
1, 2 and 3
1 and 2 only
2 and 3 only
3 and 4 only

⇒ If we connect two silicon unilateral switches in anti- parallel we get
SCR
SBS
SCS
UJT

⇒ The angle δ for a mica capacitor is about
25°
15°
5°
1°