Question is ⇒ FM broadcast is used in, Options are ⇒ (A) VHP range, (B) UHF range, (C) MF range, (D) both VHP and UHF range, (E) , Leave your comments or Download question paper.

Question is ⇒ FM broadcast is used in, Options are ⇒ (A) VHP range, (B) UHF range, (C) MF range, (D) both VHP and UHF range, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	FM broadcast is used in
A.	VHP range [Wrong Answer]
B.	UHF range [Wrong Answer]
C.	MF range [Wrong Answer]
D.	both VHP and UHF range [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is a valid FORTRAN assignment statement?
10 = N
X + 2.1 = 5.6
A = B
A = B = 1

⇒ The use of microprocessor control in automobiles results in
improved fuel economy
improved car control
advanced information system for driver
all of the above

⇒ A reactance function is always a quotient of
even to odd polynomials
odd to even polynomials
even to odd or odd to even polynomials
even to even polynomials

⇒ In a superheterodyne receiver, the IF stage has better selectivity than RF stage because
of higher frequency
of lower frequency
of high L/C ratio
of constant passband

⇒ The sign of a floating point number depends on
only the sign of mantissa
only the sign of exponent
the sign of both mantissa and exponent
either (a) or (b)

⇒ A series RLC circuit has a resonant frequency of 1000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
2000 Hz
1025 Hz
975 Hz

⇒ Find the electric charge required on the earth and moon to balance their gravitational attraction if the charge on the earth is 10 times that on the moon.
1.73 TC
17.3 GC
17.3 TC
1.73 GC

⇒

Assertion (A): An instruction cycle consists of fetch and execute cycles.

Reason (R): Fetch cycle has one machine cycle but execute cycle may have one or more machine cycles depending on length of instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The boundary conditions at the interface between two dielectrics in an electric field are given by
D_normal = 0, E_tangential = 0
D_normal = 0, E_normal = 0
D_tangential = 0, E_tangential = 0
D_tangential = 0, E_normal = 0

⇒ A magic tee is to be used as CW duplexer. Then port 1, port 2, port 3 (E arm), port 4 (H arm) respectively should be connected to
matched load, antenna, receiver and CW transmitter
CW transmitter, antenna, receiver and matched load
CW transmitter, receiver, antenna and matched load
CW transmitter, matched load, receiver and antenna

⇒ In which of the following is the width of junction barrier very small?
Tunnel diode
Photo diode
PIN diode
Schottky diode

⇒ The Laplace transform of impulse δ(t) is
1
1/s
s
1/s²

⇒ A second order active bandpass filter can be obtained by cascading LP second order filter having higher cut off frequency f_OH with a second order HP filter having lower cut off frequency f_OL provided
f_OL < f_OH
f_OL > f_OH
f_OH = f_OL
f_OH < 0.5 f_OL

⇒ Which of the following is equivalent to AND-OR realization?
NAND-NOR
NOR-NOR
NOR-NAND
NAND-NAND

⇒ A TV receiver has 20 kV EHT supply and total beam current (for 3 electron guns) of 1500 μA. The power handled by IHVT is
3 W
30 W
300 W
0.3 W

⇒ The useful magnetic flux obtainable from any closed surface is
unity
constant
both (a) and (b)
none of the above

⇒ The line of sight communication requires the transmit and receive antennas to face each other. If the transmit antenna is vertically polarized, for best reception to the receive antenna should be
horizontally polarized
vertically polarized
at 45° within respect to horizontal polarization
at 45° with respect to vertical polarization

⇒ Waveguides are generally used above
20 MHz
100 MHz
200 MHz
1000 MHz

⇒ In a positive edge triggered D flip flop
D input is called direct set
Preset is called direct reset
Present and clear are called direct set and reset respectively
D input overrides other inputs

⇒ In the given figure the input frequency f = 0.1 (1/2 p
0 dB
3 dB
-3 dB
20 dB

⇒ A microcomputer has a 64 K memory. What is the hexadecimal notation for the first memory location?
0
FFFF
0FFF
3FFF

⇒ In a CE amplifier connection, the emitter is at ground potential for
AC quantities
DC quantities
all quantities
none of the quantities

⇒ For a symmetrical network
z₁₁ = z₂₂
z₁₂ = z₂₁
z₁₁ z₂₂ and z₁₂ = z₂₁
z₁₁ z₁₂ - z₁₂² = 0

⇒ What does a link budget for satellite communication include?
Total cost of satellite
Cost of satellite plus launch vehicle
Signal and noise levels is dB
Margins of error permitted

⇒ The counter shown in the given figure
Synchronous
Johnson
Ring
None of the above

⇒ An FM radio receiver which is tuned to a 91.6 MHz broadcast station may receive an image frequency of __________ MHz.
102.3
113
70.2
80.9

⇒ In AM the amplitude of carrier components ... while in FM it
remains constant, does not remain constant
does not remain constant ... remains constant
remains constant... also remains constant
does not remain constant, also does not remain constant

⇒ The given figure shows a K-map for a Boolean function. The number of essential prime implicant
4
5
6
8

⇒ The log magnitude curve for a constant gain K is a horizontal straight line at a magnitude 20 log K dB.
TRUE
FALSE

⇒ A 10 GHz signal propagates in a waveguide with a phase velocity of 4 x 10⁸ m/s. If the signal produces standing wave in the guide, then the distance between successive minimal will be
10 mm
20 mm
30 mm
40 mm