Question is ⇒ FIR filter Passes __________ Phase., Options are ⇒ (A) non-linear phase, (B) linear phase, (C) variable phase, (D) none, (E) , Leave your comments or Download question paper.

Question is ⇒ FIR filter Passes __________ Phase., Options are ⇒ (A) non-linear phase, (B) linear phase, (C) variable phase, (D) none, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	FIR filter Passes __________ Phase.
A.	non-linear phase [Correct Answer]
B.	linear phase [Wrong Answer]
C.	variable phase [Wrong Answer]
D.	none [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which one is correct option?

A pure capacitor never dissipates energy, but only stores.
Capacitor can store finite amount of energy even cunent is zero.
The current through a capacitor is zero if voltage across it d.c.
Voltage across a capacitor cannot change instantaneously since it would require an infinite current.
q_c(0^-) = q_c(0⁺)

5, 4, 3, 2
3, 4, 1, 2
2, 4, 3, 1
1, 2, 3, 4, 5

⇒ In the television system in India, the aspect ratio is
0.16875
0.127777777777778
0.211111111111111
0.170138888888889

⇒ The power required to produce a gain of 10 dB over 4 W of original power is __________ watt.
80
40
0.4
8

⇒ The energy stored in a coil is 108 J. It is opened suddenly in 10 ms. The power dissipated instantaneously across the blades of switch is
108 W
1080 W
10800 W
108000 W

⇒ Phase modulation is commonly-used for data transmission mainly because
phase can be varied from + 180° to 180°
it is resistant to the effects of noise
demodulation is very easy
it gives highest data rates that can be transmitted over a given channel

⇒ The interface chip for 8086 and 16 bit ADC is
8259
8255
8253
8251

⇒ The phase difference (jω - p₁ )
phasor directed from p₁ to jω
phasor directed from origin to p₁
phasor directed from origin to jω point
phasor directed from jω to p₁

⇒ Which device changes parallel data to serial data?
Decoder
Multiplexer
Demultiplexer
Flip flop

⇒ A dipole antenna of λ/8 length has an equivalent total loss resistance of 1.5 Ω. The efficiency of the antenna is
0.0089159
0.089159
0.89159
8.9159

⇒ In Pulse Code Modulation system
large bandwidth is required
quantising noise can be overcome by companding
quantising noise can be reduced by decreasing the number of standard levels
suffers from the disadvantage of its incompatibly with TDM

⇒ Which of the following circuits can operate class AB for audio power output?
Emitter follower
Push pull
Cascade
Darlington pair

⇒ In a JFET, the drain current is maximum when
V_GS = 0
V_GS is not zero but is slightly negative
V_GS is negative
V_GS is negative and equal to V_DS

⇒ A radiation thermometer is suitable for temperatures
below 500°C
below 100°C
above 500°C
above 1400°C

⇒ In a turnstile antenna two-half wave resonant wire radiators are placed at 90° to each other in the same plane and are excited
in phase
in phase opposition
90° out of phase with each other
45° out of phase with each other

⇒

Assertion (A): Inverters and choppers use fast switching thyristors

Reason (R): Fast switching SCR has low turn off time.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The Shannon-Hartley law
refers to noise
defines bandwidth
describes signalling rate
refers to distortion

⇒ Which one of the following gives maximum probability of error?
ASK
DPSK
FSK
PSK

⇒ An advantage of memory interlacing is that
a larger memory is obtained
effective speed of memory is increased
cost of memory is reduced
a non-volatile memory is obtained

⇒ Which language has a preprocessor?
Fortran 77
Pascal
C
None of the above

⇒ The Thevenin equivalent circuit to the left of AB has R_{eq2 Ω
4 Ω
1 Ω
3 Ω}

⇒

Assertion (A): The impedance of a series resonant circuit is minimum at resonance.

Reason (R): Resonance condition implies unity power factor condition.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A short grounded vertical antenna has a length L which is 0.05λ at frequency f. If its radiation resistance at f is R ohms, then its radiation resistance at a frequency 2f will be
R/2Ω
RΩ
2RΩ
4RΩ

⇒ For a waveguide, which of the following statements is wrong?
It is usually made of brass or aluminium
It is usually rectangular or circular in shape
The dielectric region is usually air
The wall thickness is very small as compared to skin depth

⇒ Each of the following statements regarding frequency modulation is true except
amplitude of the modulated wave remains the same as that of carrier wave
the amount of variation of deviation from the original carrier frequency is determined by the frequency of the modulating signal
the rate at which the frequency of modulated wave varies is determined by the frequency of the modulating signal
frequency of modulated wave increases as the signal voltage increases and vice-versa

⇒ Which of the following is the common feature between FETs and bipolars?
Have low input impedance
Have low voltage gain
Are difficult to bias
None of them

⇒ Class A and class B chopper
operate in first quadrant
operate in second quadrant
class A chopper operates in first quadrant while class B operates in second quadrant
may operate in either first or second quadrant

⇒ Auto correlation for t = 0 is equal to
average power S of waveform
square of average power S of waveform
half of average power S of waveform
square root of average power S of waveform

⇒ A silicon (PN) junction at a temperature of 20°C has a reverse saturation current of 10 pico Ampere. The reverse saturation current at 40°C for the same bias is approximately.
30 pA
40 pA
50 pA
60 pA

⇒ Given figure is the voltage transfer characteristi
an N MOS inverter with enhanced mode transistor as load
an N MOS inverter with depletion mode transistor as load
a CMOS inverter
BJT inverter

⇒ Generally op amp is used in
open loop
closed loop
cascaded loop
either (a) or (c)