Question is ⇒ Find current flowing through 1 H inductor at <i>t</i> = 0, at which switch 'S' is ope, Options are ⇒ (A) 0, (B) 2, (C) 3, (D) 5, (E) , Leave your comments or Download question paper.

Question is ⇒ Find current flowing through 1 H inductor at <i>t</i> = 0, at which switch 'S' is ope, Options are ⇒ (A) 0, (B) 2, (C) 3, (D) 5, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Find current flowing through 1 H inductor at t = 0, at which switch 'S' is ope
A.	0 [Wrong Answer]
B.	2 [Wrong Answer]
C.	3 [Correct Answer]
D.	5 [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 4 bit synchronous counter has flip flops having propagation delay of 50 ns each and AND gates having propagation delay of 20 ns each. The maximum frequency of clock pulses can be
20 MHz
50 MHz
14.3 MHz
5 MHz

⇒ Which of the following is a valid real variable in FORTRAN 77?
KPR
LINE
JOB
RATE

⇒ In figure, D₁ turns on
v_i is more than V₁
v_i is less than V₁
v_i is between V₁ and V₂
none of the above

⇒ In a number system with radix r, the decimal value of 110 is equal to 4r. The decimal values of 111 and r respective are equal to
20, 5
16, 4
13, 3
8, 2

⇒ V_th = 0, if
there is no independent source in circuit
there is no dependent source in circuit
voltage source of infinite magnitude
none

⇒ In a single phase full wave ac regulator, the firing angles in the two half cycles
are always equal
are sometimes equal
are never equal
may be equal or unequal

⇒ If 100 V is the peak voltage across the secondary of the transformer in a half-wave rectifier (without any filter circuit), then the maximum voltage on the reverse-biased diode is
200 V
141.4 V
100 V
86 V

⇒ The carriers of n channel JFET are
free electrons and holes
holes
free electrons or holes
free electrons

⇒ Which of the following is used as a passive component in electronic circuits?
Tunnel diode
Capacitor
Transistor
Vacuum tube

⇒ The noise margin of a TTL gate is about
0.2 V
0.4 V
0.6 V
0.8 V

⇒ The mechanical system shown below has its pole(s)
- K/D
- D/K
- DK
0, - K/D

⇒ The storage capacity of DSDD disk and DSHD disk are
1.2 MB each
360 KB each
1.2 MB and 360 KB respectively
360 KB and 1.2 MB respectively

⇒ In a self bias circuit for CE amplifier, the emitter resistance is made three times the original value. The collector current will
remain the same
become three times
decrease
become one-third

⇒ In figure, capacitor is used to develop pulses of short duration and large duty cycle across R₂ when switch is closed. Which of the following combinations is best sui
R₁ and R₂ large but C small
R₁ and R₂ small but C large
R₁ and C large and R₂ small
R₂ and C large but R₁ small

⇒ The power required to produce a gain of 10 dB over 4 W of original power is __________ watt.
80
40
0.4
8

⇒ Consider the following statements regarding an antenna:

It is a transducer
Its performance is essentially frequency sensitive
It is a reciprocal device
With increase in its effective aperture area, width of the radiated beam increases.

Which of the above statements are correct?
1, 2 and 3
1, 2 and 4
2 and 3 only
1 and 4 only

⇒ A circuit has two branches 1 and 2 in parallel. If |Q₁| = 8 KVAR and |Q₂| = 6 KVAR, the magnitude of total kvar drawn form supply will be
14 KVAR
2 KVAR
zero
14 or 2 KVAR

⇒ A dc machine has 6 poles all connected in series. Each pole has 9 H inductance and field current is 2 A. Total inductance and total energy stored are
9 H and 18 J
18 H and 36 J
54 H and 108 J
108 H and 216 J

⇒ A cycloconverter cannot give a frequency higher than input frequency.
TRUE
FALSE

⇒ A 60 W, 23 V bulb is used for 45 minutes. The electrical energy consumed in commercial units is
2700 units
0.45 units
4.5 units
0.045 units

⇒ In the given figure the number of combinations of three non touching loop
0
1
2
3

⇒ A silicon sample A is doped with 10¹⁸ Atoms/cm³ of Boron. Another sample B of identical dimensions is doped with 10¹⁸ atoms/cm³ of phosphorus. The ratio of electron to hole mobility is 3. The ratio of conductivity of the sample A to B is
3
42738
42769
42796

⇒ The decorative lighting works on the principle of
periodic switching on and off
special inverter
rectifier
motor

⇒ In every practical oscillator, the loop gain is slightly larger than unity and the amplitude of the oscillations is limited by the
magnitude of the loop gain
onset if non-linearity
magnitude of gain of the amplifier
feedback transmission factor

⇒ The compensator of the given figure
lag compensator
lead compensator
lag-lead compensator
none of the above

⇒ Consider the following expression for the driving point imped
2 and 4
1 and 3
1 and 4
2 and 3

⇒ TTL uses
multi-emitter transistors
multi-collector transistors
multi-base transistors
multi-emitter or multi-collector transistors

⇒ When P-N junction is in forward bias, by increasing the battery voltage
current through P-N junction reduces
current through P-N junction increases
circuit resistance increases
none of the above

⇒ A signal m(t) with bandwidth 500 Hz is first multiplied by a signal g(t) w
δ(t)
m(t)
0
m(t) δ(t)

⇒ In modern MOSFET_S, the material used for the gate is
high purity silicon
high purity silica
heavily doped polycrystalline silicon
epitaxial grown silicon