Question is ⇒ Figure uses 10 V zener diode. The minimum and maximum current through series resistance, Options are ⇒ (A) 10 mA and 30 mA, (B) 20 mA and 40 mA, (C) 0 and 30 mA, (D) 0 and 40 mA, (E) , Leave your comments or Download question paper.

Question is ⇒ Figure uses 10 V zener diode. The minimum and maximum current through series resistance, Options are ⇒ (A) 10 mA and 30 mA, (B) 20 mA and 40 mA, (C) 0 and 30 mA, (D) 0 and 40 mA, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Figure uses 10 V zener diode. The minimum and maximum current through series resistance
A.	10 mA and 30 mA [Correct Answer]
B.	20 mA and 40 mA [Wrong Answer]
C.	0 and 30 mA [Wrong Answer]
D.	0 and 40 mA [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The circuit of the figure is an example of feedback of the following
current series
current shunt
voltage series
voltage shunt

⇒ Tellegen's theorem is applicable to
circuits with passive elements only
circuits with linear elements only
circuits with time invariant elements only
circuits with active or passive, linear or nonlinear and time invariant or time varying elements

⇒ A pre-emphasis circuit
boosts base frequencies
pre amplifies the complete audio band
amplifies higher audio frequencies
converts FM into phase modulation

⇒ In figure, V_{0zero
5.7 V
6.9 V
12.6 V}

⇒ The D.C. alpha(a) of a transistor is approximately
unity
10 to 50
100 to 500
1000 to 5000

⇒ The density of states (i.e. number of states per eV per m³) in the conduction band for energy level E is proportional to
E
E
E^1.5
E²

⇒ Consider a baseband binary PAM receiver shown below. The additive channel noise n(t) is whit with power spectral density S_N(f) = N₀/2 = 10^-20 W/Hz. The low-pass filter is ideal with unity gain and cutoff frequency 1 MHz. Let Y_k represent the random variable y(t_k10¹⁰
10⁷
1.414 x 10^-10
2 x 10^-20

⇒ In TV system in India, each frame is divided into
625 horizontal lines
525 horizontal lines
425 horizontal lines
325 horizontal lines

⇒ We can know the arrangement of atom in a material by studying electron diffraction pattern.
TRUE
FALSE

⇒ In the given figure, the flip flop
negative edge triggered
positive edge triggered
level triggered
either (a) or (c)

⇒ The generally used value of EHV supply in TV receivers is
1 kV per diagonal cm
1 kV per diagonal inch
0.5 kV per diagonal cm
0, 5 kV per diagonal inch

⇒ In figure it is desired that output wave is symmetrical.
both diodes should be similar and |V₁| = |V₂|
both diodes should be similar
|V₁| = |V₂|
either (a) or (b)

⇒ Logic pulser
generates short duration pulses
generates long duration pulses
generates sinusoidal voltage
generates ideal pulses

⇒
Assertion (A): In direct addressing the address of operand is specified in the instruction.
Reason (R): Direct addressing is also called absolute addressing.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following is not a characteristic of a flip flop?
It is a bistable device
It has two outputs
It has two outputs are complement of each other
It has one input terminal

⇒ The parallel RLC circuit shown in figure is in resonance
I_R < 1 mA
| I_R + I_L | > 1 mA
| I_R + I_L | < 1 mA
| I_L + I_C | > 1 mA

⇒ Which of the following material has nearly zero temperature-coefficient of resistance?
Carbon
Porcelain
Copper
Manganin

⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The quantization step is :
1 x 10^-9 V
5 x 10^-9 V
2.5 x 10^-9 V
0.5 x 10^-9 V

⇒ In direct addressing mode of 8085
All instructions are 3 bytes long
All instructions are 3 bytes long except IN instruction which is 2 bytes long
All instructions are 3 bytes long except IN and OUT instructions which are 2 bytes long
All instructions are 2 bytes long

⇒
Assertion (A): In active region of CE output characteristics of BJT, collector current is nearly constant.
Reason (R): Base current in CE connection is very small.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ If F = 95.0 what will be the result of following FORTRAN 77 program? 35
35
25
25

⇒ If a sequence is causal then ROC is (where a is any number)
|z| > a
|z| < a
|z| = a
Entire Plane

⇒
Assertion (A): In FM the frequency of the carrier is varied by the modulating voltage
Reason (R): FM and PM are two forms of angle modulation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If the diameter of a wire is doubled, the current carrying capacity of the wire becomes
half
twice
four times
one-fourth

⇒ A series RLC circuit has a resonant frequency of 2000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
4000 Hz
2025 Hz
1975 Hz

⇒ If f is more than f_unity the gain of op-amp becomes less than 1.
TRUE
FALSE

⇒ IC 7485 cannot be cascaded.
TRUE
FALSE

⇒ The realization of a reactance function gives
a network having inductances only
a network having capacitances only
a network having resistances only
a network having inductances and capacitances only

⇒ In a rectifier only a portion of input power is converted into DC power. The rest is AC power.
TRUE
FALSE

⇒ A Darlington circuit is obtained by connecting
two CB stages in cascade
two CE stages in cascade
a CE stages followed by CB stage
two emitter follower in cascade

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math