Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Figure shows characteristics curves for bipolar transistor. These curves |

A. | output characteristics of n-p-n transistor (common base) [Wrong Answer] |

B. | output characteristics of p-n-p transistor (common base) [Correct Answer] |

C. | output characteristics of n-p-n transistor (common emitter) [Wrong Answer] |

D. | output characteristics of p-n-p transistor (common emitter) [Wrong Answer] |

View Answer
Explanation:-
Answer : BDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒

**Assertion (A):** Snubber circuit has an RC series circuit in parallel with SCR

**Reason (R):** Voltage across a capacitor can not change instantaneously.

Both A and R are correct and R is correct explanation of A

Both A and R correct but R is not correct explanation of A

A is correct but R is wrong

A is wrong but R is correct

⇒ Which of the following can be used to isolate a low impedance from a high impedance source?

Emitter follower

p filter

Darlington pair

Any of the above

⇒ The approximate value of input impedance of a common emitter amplifier with emitter resistance R

_{e}is given by

*h*

_{ie}+ A

_{I}R

_{e}

*h*

_{ie}+ (

*i*+

*h*

_{fe}) R

_{e}

*h*

_{ie}

(1 +

*h*

_{fe}) R

_{e}

⇒ The range of visible light is

300 to 2000 Å

200 - 4000 Å

4000 to 7700 Å

more than 10000 Å

⇒ Windows can run several tasks simultaneously.

TRUE

FALSE

⇒

**Assertion (A):** In angle modulation the transmitted amplitude is constant.

**Reason (R):** Angle modulation has good immunity to noise and interference.

Both A and R are correct and R is correct explanation of A

Both A and R are correct but R is not correct explanation of A

A is correct but R is wrong

A is wrong but R is correct

⇒ The impulse response

*h*(

*t*) of a linear time-invariant continuous time system is described by

*h*(

*t*) = exp (a

*t*)

*u*(

*t*) + exp (β

*t*)

*u*(-

*t*), where

*u*(

*t*) denotes the unit step function, and a and β are constants. This system is stable if

a is positive and β is positive

a is negative and β is negative

a is positive and β is negative

a is negative and β is positive

⇒ The circuit of figure is used to measure the value R

_{x}. Ammeter resistance R

_{a}= 0.1 Ω voltmeter resistance R

_{v}= 5000 Ω. It R

_{x1}and R

_{x2}, are the measured values of R

_{x}with switch in position 1 and 2, the mean of R

_{x1}, and R

_{x2},

9.98 Ω

10 Ω

10.04 Ω

10.1 Ω

⇒ The slope of log magnitude curve changes by - 40 dB/decade at a certain frequency and the error between asymptote and actual curve is positive. This means that

a double pole is present

a pair of complex conjugate poles is present

either (a) or (b)

neither (a) nor (b)

⇒ A thermistor is a

thermocouple

thermometer

miniature resistance

heat sensitive explosive

⇒ Two resistances R

_{1}= 18.7 Ω. and R

_{2}= 3.624 Ω in series. The total resistance to the appropriate number of significant figures is

22.324 Ω

22.32 Ω

22.3 Ω

22 Ω

⇒ Pressing a key on telephone set generates two frequencies. The basis for selection of these frequencies is

the harmonics of one frequency should not be mistaken for the other frequency

the audio input to the handset transmitter should not be mistaken for a key pressing

both (a) and (b)

neither (a) nor (b)

⇒ A silicon (PN) junction at a temperature of 20°C has a reverse saturation current of 10 pico Ampere. The reverse saturation current at 40°C for the same bias is approximately.

30 pA

40 pA

50 pA

60 pA

⇒ A thyristor has internal power dissipation of 40W and is operated at an ambient temperature of 20°C. If thermal resistance is 1.6° C/W, the junction temperature is

114°C

164°C

94° C

84° C

⇒ If a resistance R of 1 Ω is connected between A and B in figure, current flowing through

0.0416666666666667

0.5 A

0.25 A

0.125 A

⇒ Consider Pole zero diagram as shown, If two Poles are moved in opposite direction towards ω = p/2 and -p/2, the filter wil

change to high pass filter

change to Band Pass filter

remains same

change to LPF

⇒ Which of the following statement is wrong?

A depletion type N-channel MOSFET conducts even when V

_{GS}= 0

A BJT is very sensitive to radiation whereas FET is relatively immune

Bipolars need higher supply voltage than FETs

Both N-channel as well as

*p*-channel JFETs work in the depletion mode

⇒ Fourier transform o the function

*f*(

*t*) = 1 is

2p δ (ω)

p δ (ω)

δ(ω)/2p

δ(ω)/p

⇒ Skin effect is more pronounced at high frequencies.

TRUE

FALSE

⇒ The function to Calculate the maximum value in the specified field of a database is

DM

DMAX

MAX

DBMAX

⇒ In which of the following 8085 instructions are all condition flags except

`CY`

affected?`INR `*r*

`SEE M`

`ACI data`

`ADC`* r*

⇒ The fuse material used in electrical lines must have which one of the following properties?

High resistivity

Low conductivity

High melting point

Low melting point

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls Calculate group velocity for dominant mode.

1.8 x 10

^{8}m/sec

5 x 10

^{8}m/sec

3 x 10

^{8}m/sec

1.5 x 10

^{8}m/sec

⇒ The dual of a loop is

twig

node pan

mesh

tree

⇒ An input voltage V(

*t*) = 10 2 cos (

*t*+ 10°) + 10 3 cos (2

*t*+ 10°)

*V*is applied to a series combination of resistance R = 1 kΩ inductance L = 1H. The resulting steady-state current

*i*(

*t*) in ampere is

10 cos (

*t*+ 55°) + 10 cos (2

*t*+ 10° tan

^{-1}2)

10 cos (

*t*+ 55°) + 103/2 cos (2

*t*+ 55°)

10 cos (

*t*- 35) + 10 cos (2

*t*+ 10° - tan

^{-1}2)

10 cos (

*t*- 35) + 103/2 cos (2

*t*+ 35°)

⇒ The number of address lines in EPROM 4096 x 8 is

2

4

8

12

⇒ Which of the following noise becomes of great importance at high frequencies?

Shot noise

Agitation noise

Flicker noise

Transit time noise

⇒ The HV supply to a TV receiver is 25 kV and the total beam current for the three electron guns is 2000 μA. The power handled by IHVT is

5W

0.5 W

50 W

500 W

⇒ Which of the following semi-conductor has forbidden energy gap less 1 eV?

Sulphur

Phosphorous

Germanium

Carbon

⇒ Which of the following equations satisfy Maxwell's equations?

E

_{x}= E

_{y}= 0, E

_{z}= cos (

*y*-

*ct*)

E

_{x}= E

_{y}= 0, E

_{z}= cos (

*y*-

*ct*)

F

_{y}= cos (

*y*-

*ct*), E

_{x}= E

_{z}= 0

None of these