Question is ⇒ Figure shows a Wheatstone bridge with RTD to one arm. If resistance of RTD = 1020 Ω, the voltage V<sub>0</sub>, Options are ⇒ (A) 49 mV, (B) 51 mV, (C) 48 mV, (D) 45 mV, (E) , Leave your comments or Download question paper.

Question is ⇒ Figure shows a Wheatstone bridge with RTD to one arm. If resistance of RTD = 1020 Ω, the voltage V<sub>0</sub>, Options are ⇒ (A) 49 mV, (B) 51 mV, (C) 48 mV, (D) 45 mV, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Figure shows a Wheatstone bridge with RTD to one arm. If resistance of RTD = 1020 Ω, the voltage V₀
A.	49 mV [Correct Answer]
B.	51 mV [Wrong Answer]
C.	48 mV [Wrong Answer]
D.	45 mV [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The V_TH at terminals A and B is equal
0 V
5 V
- 5 V
None of these

⇒ Given a power supply filter circuit, what measurements must be made of determine percentage regulation
current through and voltage across the capacitor
d.c. load voltage and r.m.s. load voltage
current through load and voltage across load resistance
number of turns and gauge of secondary winding of transformer

⇒

Assertion (A): In FM the frequency of the carrier is varied by the modulating voltage

Reason (R): FM and PM are two forms of angle modulation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ FM has
two sidebands only
four sidebands only
eight sidebands only
infinite sidebands

⇒ The output V-I characteristics of an Enhancement type MOSFET has
only an ohmic region
only a saturation region
an ohmic region at low voltage value followed by a saturation region at higher voltages.
an ohmic region at large voltage values. Preceded by a saturation region at lower voltages.

⇒ The word 'LORAN' means
long range navigation
long range TV transmission
long range cable transmission
either (b) or (c)

⇒ Loop antennas are mostly employed for direction finding (DF) purposes because they are small and hence portable.
TRUE
FALSE

⇒ The Wheatstone bridge method of measuring resistance is ideally suited for the measurement of resistance values in the range of
0.001 to 1 Ω
0.1 to 100 Ω
100 Ω to 10 kΩ
100 kΩ to 10 MΩ

⇒ A JK flip flop has t_pd= 12 ns. The largest modulus of a ripple counter using these flip flops and operating at 10 MHz is
16
64
128
256

⇒

Assertion (A): Hamming code is commonly used for error correction

Reason (R): In Hamming code the number of parity bits increases as the number of information bits increases.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The sensitivity of a superheterodyne receiver is determined by
the gain IF amplifier
the gain of RF amplifier
the noise figure
all of the above

⇒ Separation property of state-transition matrix is
φ(t - t₀) = φ(t) φ(t₀)
φ(t - t₀) = φ^-1(t) φ^-1(t₀)
φ(t - t₀) = φ(t) φ^-1(t₀)
φ(t - t₀) = φ^-1(t) φ^-1(t₀)

⇒ In a network with twelve circuit elements and five nodes, what is the minimum number of mesh equations?
24
12
10
8

⇒ One coulomb charge is equal to the charge on
6.24 x 10¹⁸ electrons
6.24 x 10²⁴ electrons
6.24 x 10¹⁸ atoms
none of the above

⇒

Assertion (A): A large negative feedback is deliberately introduced in an amplifier to make its gain independent of variation is in parameters of active device and other components.

Reason (R): A large negative feedback results in a high value of return difference compared to unity which makes the feedback gain inversely proportional to feedback factor.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Which of these are 16 bit microprocessors?
80286
MC68000
Z8000
All

⇒ Consider the following program in C 0.297
0.2
0
3

⇒ The Voltage e₀ in the figu
2 V
4 V
4/3 V
8 V

⇒ A signal f(t) = cos 10pt + 3 cos 4pt is instantaneously sampled. The maximum allowable value of sampling interval T_s in sec is
1 / 4 sec
1 / 8 sec
1 / 8p sec
1 / 10 sec

⇒ Figure shows the equivalent circuit of resistor. The resistor is non-inductive w
R = L/C
LR = L/C
L = CR²
C = LR²

⇒ Which of the following microphones is used as a standard for calibration?
Moving coil
Carbon
Condenser
Ribbon

⇒ The factors which govern fan out of CMOS gates are
maximum permissible propagation delay
input capacitance of each load
both (a) and (b)
neither (a) nor (b)

⇒ In a transistor which of the following region is very lightly doped and is very thin?
Emitter
Base
Collector
None of the above

⇒ Nichrome is used for
overhead line wires
heater coils
lamp filaments
all of the above

⇒ In EM waves, polarization
is always vertical in an isotropic medium
is caused by reflection
is due to transverse nature of waves
results from longitudinal nature of waves

⇒

Assertion (A): In state space analysis, capacitors are taken to be in tree.

Reason (R): State variable analysis is very suitable for computer solution.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The MOSFET is almost ideal as a switching device because
it has linear characteristics
it works progressively
it consumes low power
it has longer life

⇒ In intrinsic semiconductor magnitude of free electron and hole concentrations are equal.
TRUE
FALSE

⇒ The first geostationary satellite launched in 1965 was called
ANIK
EARLY BIRD (Intelsat-I)
WESTAR
MOLNIYA

⇒

Match the following:

	List I (Functional headings of instruction set of 8085)		List II (Functions performed)
A.	Branch group	1.	Compares, rotates etc.
B.	Logic group	2.	Moves, loads, stores etc.
C.	Data transfer group	3.	Initiates conditional or unconditional jumps, calls etc.

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-1, C-2
A-1, B-3, C-2