Question is ⇒ Figure shows a chopper feeding RLE load, The free wheeling diode conducts w, Options are ⇒ (A) thyristor is on, (B) thyristor is off, (C) both when thyristor is on and thyristor is off, (D) partly when thyristor is off and partly when thyristor is on, (E) , Leave your comments or Download question paper.

Question is ⇒ Figure shows a chopper feeding RLE load, The free wheeling diode conducts w, Options are ⇒ (A) thyristor is on, (B) thyristor is off, (C) both when thyristor is on and thyristor is off, (D) partly when thyristor is off and partly when thyristor is on, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Figure shows a chopper feeding RLE load, The free wheeling diode conducts w
A.	thyristor is on [Wrong Answer]
B.	thyristor is off [Correct Answer]
C.	both when thyristor is on and thyristor is off [Wrong Answer]
D.	partly when thyristor is off and partly when thyristor is on [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The time constant of the circuit in figur
RC
2 RC
3 RC
5 RC

⇒ The inductance of a single layer solenoid of 10 turns is 5 μH. Which one of the following is the correct value of inductance when the number of turns is 20 and the length is doubled.
10 μH
20 μH
40 μH
5 μH

⇒ Consider the common emitter amplifier shown below with the following circuit parameters: β = 100, g_m = 0.3861 A/V, r₀ = ∞ r_p = 259 Ω, R_s = 1 kΩ, R_B = 93 kΩ, R_C = 250 Ω, R_L = 1 kW, C₁ = ∞ and C₂ = 4.
33.9 Hz
27.1 Hz
13.6 Hz
16.9 Hz

⇒ In a fully controlled bridge converter feeding a resistive load the waveshapes of output voltage and output current
are always similar
can never be similar
may be similar or dissimilar
are similar only if a = 0

⇒ Value of 'K' for the system for which the system is stab
K < 1
K > 1
K < 2
K > 2

⇒ In operational Amplifier, Common mode voltage gain should be
0
∞
1
0.5

⇒ Measuring of unknown voltage with a dc potentiometer loses its advantage of open circuit measurement when
primary circuit battery is changed
standardisation is done to compensate for drift
voltage is larger than range of potentiometer
range reduction by factor of 10 is employed

⇒ In free space
phase velocity is greater than light velocity
phase velocity is equal to group velocity
phase velocity is equal to light velocity
Both (b) and (c)

⇒ Which of the following constitute the loss resistance of an antenna?
Dielectric loss
Leakage loss in insulation
Loss in earth connections
All of the above

⇒ In one of the codes for transfer of numbers the code for the succeeding number differs from that of the number only in the change of a single digit. The code is
ASCII
Excess 3 CODE
Gray CODE
none of these

⇒ The resistance of a dc galvanometer is 20 Ω. A current of 10 mA causes full scale deflection. To convert it into 0-300 V voltmeter, we have to use a series resistance of
30000 Ω
29980 Ω
6000 Ω
15 Ω

⇒ In FM, as bandwidth increases
distortion increases
distortion decreases
distortion remains unaffected
all

⇒ The stack pointer holds the address of the desired memory location.
TRUE
FALSE

⇒ In order to achieve good stabilization in potential divider method current I₁ through R₁ and R₂ should be
I₁ > 20 I_B
I₁ > 15 I_B
I₁ < 5 I_B
I₁ > 10 I_B

⇒ Examine the following statements

Air and gases are compressible.
Air, gases and some liquids are compressible.
Oil can function as hydraulic fluid as well as lubricator.

Which of the above statements are correct?
3 only
2 and 3 only
1 and 3 only
2 only

⇒ Auto correlation for t = 0 is equal to
average power S of waveform
square of average power S of waveform
half of average power S of waveform
square root of average power S of waveform

⇒ Which of the following equations satisfy Maxwell's equations?
E_x = E_y = 0, E_z = cos (y - ct)
E_x = E_y = 0, E_z = cos (y- ct)
F_y = cos (y - ct), E_x = E_z = 0
None of these

⇒ In FM, when the bandwidth is doubled, the signal to noise ratio improves by a factor of
2 dB
4 dB
6 dB
8 dB

⇒ Which of the following lines behaves as infinite line?
a line terminated in inductance
a line terminated in capacitance
a short line
a line terminated in z₀

⇒ An n type silicon bar 0.1 cm long and 100 μm² in cross-sectional area has a majority carrier concentration of 5 x 10²⁰/m³ and the carrier mobility is 0.13 m⁰/V-s at 300k. If the charge of an electron is 1.6 x 10^-19 coulomb, then the resistance of the bar is
10⁶ ohm
10⁴ ohm
10^-1 ohm
10^-4 ohm

⇒ Which of the following statement is false?
Television signals are propagated as ground waves
Surface waves can propagate on piezoelectric substrates
The skip distance is the maximum distance upto which ionospheric reflection is possible
Tropospheric scatter propagation is always subjects to fading

⇒ Two wattmeter method is suitable only for balanced loads.
TRUE
FALSE

⇒ Baudot code is a six bit code.
TRUE
FALSE

⇒ A microstrip line has dielectric having relative permittivity ∈_r. The effective dielectric constant is
more than ∈_r
equal to 1
less than ∈_r
either a or b

⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
100 W
66 W
50 W
25 W

⇒ In a shunt-shunt negative feedback amplifier, as compared to the basic amplifier
both input and output impedances, decrease
input impedance decreases but output impedance increase
I/P impedance increases but O/P impedance decreases
both input and O/P impedance increases

⇒ Symbol in the given figure is IEEE symbol
AND
OR
NAND
NOR

⇒ A 3 phase bridge inverter is fed by 400 V battery. The load is star connected and has a resistance of 10 Ω per phase. The peak value of load current is
40 A
20 A
0.416666666666667
0.208333333333333

⇒ Non-coherently detection is not possible for
PSK
ASK
FSK
both (a) and (c)

⇒ Microwave links are typically 50 km apart
because of atmospheric attenuation
because of output tube power limitation
because of earth's curvature
to ensure that applied dc voltage is not excessive