Question is ⇒ Figure sho, Options are ⇒ (A) bipolar transistor, (B) JFET, (C) p-channel MOSFET, (D) n-channel enhancement MOSFET, (E) , Leave your comments or Download question paper.

Question is ⇒ Figure sho, Options are ⇒ (A) bipolar transistor, (B) JFET, (C) p-channel MOSFET, (D) n-channel enhancement MOSFET, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Figure sho
A.	bipolar transistor [Wrong Answer]
B.	JFET [Wrong Answer]
C.	p-channel MOSFET [Wrong Answer]
D.	n-channel enhancement MOSFET [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A single-sideband (SSB) signal contains 3 kW. The power content of the carrier is __________ kW.
2
2
3
0

⇒ Most of the digital computers do not have floating-point hardware because
floating point hardware is costly
it is slower than software
it is not possible to perform floating point addition by hardware
of not specific reason

⇒ Consider the following types of distortions in diode detectors

Distortion is caused due to the reason that dc and ac load impedances are unequal
Distortion is caused because ac load impedance has a reactive component at high audio frequencies
Audio frequency diode current is less than dc current

Which of the above are true?
1, 2 and 3
1 and 2
1 and 3
2 and 3

⇒ A generator is feeding power to a transmission line of characteristic impedance Z₀. The line is terminated in impedance Z_L. Standing waves will be set up if
Z_L = Z₀
Z_L < Z₀
Z_L > Z₀
both (b) and (c)

⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
100 W
66 W
50 W
25 W

⇒ In filter system of sideband suppression the advantage of using mechanical filter is
smaller size
good bandpass
good attenuation characteristics
all of the above

⇒ If KMT = 100, LITRES = 5.0, PCOST = 28.0 and OPCOST = 70.0 what will be the result of the following FORTRAN 77 program? 2
2.1
21
21

⇒ A leaky dielectric has ∈_r = ∈_r^' - j∈_r^". If a field E is applied, the current component in phase with E is proportional to ∈_r^".
TRUE
FALSE

⇒ If the number of ways an event may result ins analysed into m successes and n failures, each equally likely to occur, the probability of success in a single trial is m( m + n)
TRUE
FALSE

⇒ In PAL system
phase of U signal is reversed on alternating lines
phase of V signal is reversed on alternating lines
phases of both U and V signals are reversed on alternating lines
none of the above

⇒ Which of the following are linear ICs?
RF and IF amplifiers
Wide band amplifier
Audio amplifiers
All of the above

⇒ Which of the following is correct? The circuit shown in the fig
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2 and 4

⇒ Antiferromagnetic materials do not have permanent dipoles.
TRUE
FALSE

⇒ The output voltage waveform of a CE amplifier is fed to a dc coupled CRO. The trace on the screen will be
dc output voltage
ac output voltage
sum of dc and ac output voltage
either (a) or (b)

⇒ In a coaxial cable, braided copper is used for
conductor
shield
dielectric
jacket

⇒ Which are the pending interrupts?
5.5
6.5
7.5
None

⇒ The HV and other voltage supplies for a TV receiver are obtained from IHVT. The full name for this device is
Internal high voltage transformer
Integrated high voltage transformer
Instant high voltage transformer
Interleaved high voltage transformer

⇒ One of a loss-less transmission line having the characteristic impedance of 75 Ω and length of 1cm is short-circuit. At 3 GHz, the input impedance at the other end of the transmission line is
0
resistive
capacitance
inductive

⇒ The maximum distance between television transmission and receiving antennas for reasonably good reception should be
less than 20 km
less than 100 km
less than 500 km
less than 1000 km

⇒ An electrostatic voltmeter is suitable for
low voltage at high frequency
high voltage
low voltage at low frequency
all ac and dc voltages

⇒ Consider a parallel plate capacitor being charged. Identify the incorrect statements
Energy stored in the capacitor does not enter it through the connecting wires but through the space around the wires and plates uf capacitor
Rate at which energy flows into this volume is equal to the integration of the Poynting vector over the boundary of the volume between the plates.
The Poynting vector points everywhere radially outward of the volume between the plates
The Poynting vector points everywhere radially into the volume between the plates.

⇒ Magnetic deflection is inversely proportional to
voltage
(voltage)^0.5
(voltage)^1.5
(voltage)²

⇒ An increase in junction temperature of a semiconductor diode
causes a small increase in reverse saturation current
causes a large increase in reverse saturation current
does not affect reverse saturation current
may cause an increase or decrease in reverse saturation current depending on rating of diode

⇒ In figure, I = 2A, then
5 V
3 V
2 V
1 V

⇒

Assertion (A): In 8085 SP and PC are 8 bit each.

Reason (R): 8085 is an 8 bit microprocessor.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following is not treated as hexadecimal constant by assembler in 8085?
45 H
6 AFH
234
64 H

⇒ Consider the following: Energy storage capability of basic passive elements is due to the fact that

resistance dissipates energy
capacitance stores energy
inductance dissipates energy

Which of the above is/are correct?
1, 2, and 3
1 and 3
3 only
1 and 2

⇒ In using mesh current method it is necessary that at least one mesh current links every element.
TRUE
FALSE

⇒ Which mode is called dominant mode in rectangular wave guide?
TE₀₁
TE₁₁
TE₁₀
TE₂₀

⇒ Consider the sequence x[n] = [- 4 - j5 1 + J2 4]
[- 4 - J2.5 J2 4 - J2.5]
[- J2.5 1 J2.5]
[- J5 J2 0]
[- x 1 4]