Question is ⇒ Figure represen, Options are ⇒ (A) JFET shunt switching circuit, (B) JFET series switching circuit, (C) JFET analog switch, (D) multiplexing, (E) , Leave your comments or Download question paper.

Question is ⇒ Figure represen, Options are ⇒ (A) JFET shunt switching circuit, (B) JFET series switching circuit, (C) JFET analog switch, (D) multiplexing, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Figure represen
A.	JFET shunt switching circuit [Correct Answer]
B.	JFET series switching circuit [Wrong Answer]
C.	JFET analog switch [Wrong Answer]
D.	multiplexing [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In 8085 microprocessor, which of the following is not vectored interrupt?
RST 5.5
RST 6.5
RST 7.5
INTR

⇒ For an RC impedance function Z
Z(∞) = Z(0)
Z(∞) < Z(0)
Z(∞) ≤ Z(0)
Z(∞) > Z(0)

⇒ In figure V_BE = 0.7 V. If base current required to saturate the transistor is 0.1 mA, V_{i5 V
5.7 V
10 V
10.7 V}

⇒ When the ac input signal is very large the instantaneous operating point CE amplifier moves all the way between
ac saturation and ac cut off points
ac operating and ac cut off points
ac saturation and ac operating points
none of the above

⇒ Which one of the following can be used as parallel to series converter?
Decoder
Digital counter
Multiplexer
Demultiplexer

⇒ In the series circuit shown in figure, for series resonance, the value of the coupling coefficient, K wil
0.25
0.5
0.1
1

⇒ Which of the following constitute the loss resistance of an antenna?
Dielectric loss
Leakage loss in insulation
Loss in earth connections
All of the above

⇒ A voltage V(t) is a Gaussian ergodic random process with a mean of zero and a variance of 4 volt². If it is measured by a dc meter. The reading will be
0
4
2
2

⇒ If the op-amp in figure has a unity gain frequency of 1 MHz, the cut off frequenc
100 kHz
1 MHz
10 MHz
90 MHz

⇒ A constant k high pass filter has f_c = 3000 Hz. At f = 1000 Hz, the phase shift is
zero
p
2 p
more than p

⇒ 8255 A is a
programmable peripheral interface
I/O device
memory chip
none of the above

⇒ Binary multiplication can be done by repeated addition.
TRUE
FALSE

⇒

Assertion (A): CO₂ has no resultant dipole moment but CO has a dipole moment.

Reason (R): The structure of CO₂ is O = C = O.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Machine cycle is always the same as instruction cycle.
TRUE
FALSE

⇒ For a series circuit of R and variable X_L the admittance locus is
a semicircle in first quadrant
a semicircle in fourth quadrant
a straight line in first quadrant
a straight line in fourth quadrant

⇒ In a linear op-amp circuit
the product of gain and bandwidth is constant
input can be dc only
input can be ac only
saturation may occur

⇒ In a JK master slave flip flop race condition does not occur.
TRUE
FALSE

⇒

Assertion (A): A Smith chart can be used for a number of calculations of a transmission line

Reason (R): Smith chart is basically a polar impedance diagram.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): The TTL output acts as a current sink in low state

Reason (R): The TTL input current is largest in low state.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Wood is a diamagnetic material.
TRUE
FALSE

⇒ The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be
200
40
4.878
1.212

⇒ If R_T, R_h represent condition for reciprocity in case of transmission parameter and hybrid parameter respectively and similarly S_T, S_h represent condition for symmetry in case of transmission parameter and hybrid parameter respectively then match the followi
1 - c 2 - d 3 - a 4 - f
1 - c 2 - b 3 - e 4 - d
1 - e 2 - d 3 - a 4 - b
1 - e 2 - d 3 - a 4 - f

⇒ The colour subcarrier and sidebands produced by its modulation with the chrominance signals are accommodated in the standard channel width by the process of
frequency adjustment
frequency interleaving
frequency changing
frequency amalgamation

⇒ Which of the following output configurations are available in a TTL gate?

Open collector output
Totem pole output
Tristate output

Select the correct answer from the codes given below:
1 only
1 and 2 only
2 and 3 only
1, 2 and 3

⇒ What is the purpose of peak clipper circuits in radio transmitters?
To prevent overmodulation
To reduce bandwidth
To increase bandwidth
To regulate oscillator I/P voltage

⇒ Calculate the conductivity of pure silicon at room temperature when the concentration of carriers is 1.6 x 10¹⁰ per cm³. Take μ_e = 1500 cm²/V-sec, μ_h = 500 cm²/V-sec at room temperature,
5.12 x 10^-16
5 x 10⁺¹⁶
10¹⁶
5 x 10²⁰

⇒ Average latency time of magnetic tape memory is of the order of
1 μ sec
1 msec
1 sec
1 minute

⇒ In classical analogue, torque is analogous to
current
voltage
charge
voltage gradient

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next, 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. then rms value of the waveform is
31 volt
32 volt
insufficient data
none

⇒ In an AM transmitter after the modulation stage, class C amplifier
can be used
cannot be used
may be used, but it has no use
can't be determine to use