Question is ⇒ Fidelity of a receiver represents, Options are ⇒ (A) the sensitivity expressed in terms of voltage that must be applied to the receiver input to give a standard output, (B) the extent to which the receiver is capable of distinguishing between the desired signal and other frequencies, (C) the variation of the output with the modulation frequency when the output impedance is a resistance, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Fidelity of a receiver represents, Options are ⇒ (A) the sensitivity expressed in terms of voltage that must be applied to the receiver input to give a standard output, (B) the extent to which the receiver is capable of distinguishing between the desired signal and other frequencies, (C) the variation of the output with the modulation frequency when the output impedance is a resistance, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Fidelity of a receiver represents
A.	the sensitivity expressed in terms of voltage that must be applied to the receiver input to give a standard output [Wrong Answer]
B.	the extent to which the receiver is capable of distinguishing between the desired signal and other frequencies [Wrong Answer]
C.	the variation of the output with the modulation frequency when the output impedance is a resistance [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A particular current is made up of two components 10A dc and sinusoidal current of peak value 14.14A. The average of resultant current is
zero
24.14A
10A
14.14A

⇒ The circuit shown in the figure has 4 boxes each described by inputs P, Q, R and outputs Y, Z
4 bit adder giving P + Q
4 bit subtractor giving P - Q
4 bit subtractor giving Q - P
4 bit adder giving P + Q + R

⇒ The equivalent circuit of an op-amp has
a virtual ground at input
a virtual ground at output
virtual ground at input as well as at output
none of the above

⇒ In figure the trace on the CRO wil
half rectifier wave
clamped wave
no trace at all
either (a) or (b)

⇒ A divide by 78 counter can be obtained by
6 numbers of mod-13 counters
13 numbers of mod-6 counters
one mod-13 counter followed by mod-6 counter
13 number of mod-13 counters

⇒ The radio receivers mostly used now a days are
TRF receivers
super heterodyne receivers
CW receivers
pulsed receivers

⇒ In which of the following 8085 instructions is the 8 bit number in accumulator adjusted to form two four bit BCD numbers
DAD rp
DAA
DCX rp
ADC M

⇒ Which of the following is not a special purpose peripheral?
Programmable DMA controller
Programmable Floppy disc controller
Programmable Hard disc controller
Programmable CRT controller

⇒ The most serious problems in ac bridge measurement is
eddy currents
leakage current
residual magnetism
stray fields

⇒ A pole zero pattern of a certain filter is shown in figure. This filter mus
LPF
BFP
HPF
APF

⇒ A 3 x 8 decoder with two enable inputs is to be used to address 8 blocks of memory. What will be the size of each memory block when addressed from a sixteen bit bus with two MSBs used to enable the decoder?
2 K
4 K
16 K
64 K

⇒ Which of the following is a vector quantity?
Standing wave ratio
Reflection coefficient
Gain
All of the above

⇒ When there is rapid attenuation of field inside the conductor, the field current are concentrated close to the surface of the conductor; this phenomenon is called
skin effect
EM concentration effect
Faraday's effect
Ohm's effect

⇒ If all the LEDs in a seven segment display are turned on, the number displayed is
1
3
0
8

⇒ 3N 200 is a
semi-conductor diode
P-N-P transistor
dual gate MOSFET
UJT

⇒ The network shown in figur
reciprocal
reciprocal and symmetrical
non-reciprocal
unsymmetrical

⇒ Consider the following features:

negative operands cannot be used
when immediate operand changes, the program should be reassembled
the program is difficult to read
the size of operand is restricted by word length of the computer

Disadvantages of immediate addressing include
1 and 2
2 and 4
2 and 3
1 and 4

⇒ An antenna is 30 metre high. The frequency is 1 MHz. The radiation resistance is about
1500 Ω
150 Ω
15 Ω
1.5 Ω

⇒ A h is the unit of quantity of electricity.
TRUE
FALSE

⇒ A loss less line is terminated in a circular lines are E lines
SWR = 0
SWE = 0
SWR is finite
SWR = ∞

⇒ Out of multiplexer and demultiplexer, which can be used as a logic function generator?
Multiplexer only
Demultiplexer only
Both
None

⇒ A differential amplifier is invariably used in the I/P stage of all OP-amps. This is done basically to produce the OP-amp with a very high.
CMRR
bandwidth
slew rate
open-loop gain

⇒ Which of the following is a self-complementing code?
8421 code
Excess 3 codes
Pure binary code
Gray code

⇒ In the following network, the switch is closed at t = 0 and the sampling starts from t = 0. The sampling frequency is 1
5(1 - e^-0.05n)
5e^-0.05n
5(1 - e^-5n)
5^e-5n

⇒ Superheterodyne receiver can be used in
AM
FM
SSB
All of the above

⇒ Binary number 11011.01 when converted to its 2's complement will become
101.11
1111.1
1100.1
100.11

⇒ MUF is highest in periods of greatest sunspot activity.
TRUE
FALSE

⇒ Which of the following exhibits negative resistance in a portion of its characteristics?
Tunnel diode
Zener diode
JFET
MOSFET and tunnel diode

⇒ The dead zone in a pyrometer is 0.125% of span. The calibration is 400°C to 1000°C. What temperature change might occur before it is detected.
0.125°C
0.75°C
0.4°C
1°C

⇒ In a P-N-P transistor, with normal bias
the collector junction has negligible resistance
only holes cross the collector junction
the collector-base junction is reverse biased and the emitter base junction is forward biased
only majority carriers cross the collector junction