Question is ⇒ Ferrities are particularly suited for high frequency applications because of their, Options are ⇒ (A) low distortion, (B) low eddy current loss, (C) high conductivity, (D) high mobility, (E) , Leave your comments or Download question paper.

Question is ⇒ Ferrities are particularly suited for high frequency applications because of their, Options are ⇒ (A) low distortion, (B) low eddy current loss, (C) high conductivity, (D) high mobility, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Ferrities are particularly suited for high frequency applications because of their
A.	low distortion [Wrong Answer]
B.	low eddy current loss [Correct Answer]
C.	high conductivity [Wrong Answer]
D.	high mobility [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In microwave system the function of mode filter is
to suppress modes with lower cut off frequencies
to suppress modes with higher cut off frequencies
to change mode of wave transmission
both (b) and (c)

⇒ A network contains only independent current source and resistors. If the values of all resistors are doubled, the value of the node voltage
will become half
will remain unchange
will become one third
cannot be determined unless the circuit configuration and the values of the resistors are known

⇒ If the number of atoms per unit volume of a monoatomic gas changes, the dielectric constant still remains constant.
TRUE
FALSE

⇒ A sequence detector is required to give a logical output of 1 whenever the sequence 1011 is detected in the incoming pulse stream. Minimum number of flip-flops needed to built the sequence detector is
4
3
1
2

⇒ The energy stored in a coil is 108 J. It is opened suddenly in 10 ms. The power dissipated instantaneously across the blades of switch is
108 W
1080 W
10800 W
108000 W

⇒

Assertion (A): In an R-L circuit having low resistance, current lags the voltage by nearly 90°.

Reason (R): Power factor of a series RL circuit is R/Z.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ For determining the network functions of a two-port network, it is required to consider that
all initial conditions remain same
all initial conditions are zero
part of initial conditions are equal to zero
initial conditions vary depending on nature of network

⇒ The main advantage of using micro waves for communications is
large bandwidth
small bandwidth
low power
high power

⇒ The shape of torque-speed curve of a two phase servo- motor mostly depends on
ratio of rotor reactance to rotor resistance
ratio of stator reactance to rotor resistance
ratio of rotor reactance to rotor resistance and also the ratio of stator reactance to stator resistance
magnitude of stator voltages

⇒ An RL impedance function can also be realized as
RC impedance function
RC admittance function
LC impedance function
LC admittance function

⇒ Which one of the following can be used for amplification of microwave energy?
TWT
Magnetron
Reflex klystron
Gunn diode

⇒ Saturation region of a JFET is also known as
source region
analog region
pinch off region
ohmic region

⇒ The bridge is balanced when the value of R is
50 Ω
100 Ω
200 Ω
250 Ω

⇒ TTL circuit with active pull up is preferred because of its suitability for
wired AND operation
bus operated system
wired logic operation
reasonable dissipation and speed of operation

⇒ The symbol in figure is
UJT
PUT
Shockley diode
TRIAC

⇒ If RADIUS = 3.0 the result of the following FORTRAN 77 program will be 1.5708
1
28.2744
18

⇒ The O/P char, of a FET is given in the figure. In which region is the device biased for small signal amplificat
AB
BC
CD
BD

⇒ What is the result for expression (map metho
A + D + BC
A + D
A D + B C
A + D + BC

⇒ Which one of the following is not LED material?
GaAs
GaP
SiC
SiO₂

⇒ A 10 μF capacitor is charged from a 5 volt source through a resistance of 10 kΩ. The charging current offer 35 m sec. If the initial voltage on C is - 3 V is
0.56 mA
5.6 mA
6 mA
5 μA

⇒ Ferrite have
low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒

Match the following:

	List I (Camera pick up tubes)		List II (Special feature)
A.	Vidicon	1.	Highest sensitivity
B.	Plumbicon	2.	Temperature sensitive
C.	Saticon	3.	Large lag
D.	New vicon	4.	Special target for red response

A-4, B-3, C-2, D-1
A-1, B-2, C-3, D-4
A-3, B-4, C-2, D-1
A-4, B-3, C-1, D-2

⇒ Hall effect is observed in a specimen when it is carrying current and is placed in a magnetic field. The resulting electric field inside the speciment will be in
direction normal to both current and magnetic field
the direction of current
direction antiparallel to magnetic field
an arbitrary direction depend upon conductivity

⇒ The advantage of LVDT over inductive bridge type transducer is that
it gives high output for small changes in core position
it can be used over a temperature range of - 265°C to 600°C
it can measure displacement of moving object
the error due to stray magnetic field is less

⇒ In figure, the capacitor is charged to 1 V. At t = 0 the switch is closed so that i = e^-t. When i = 0.37 A, the voltage across capacito
1 V
0.63 V
0.37 V
0.185 V

⇒ In major diatonic musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals

⇒ Z₀ = (Z_oc Z_sc)^0.5
TRUE
FALSE

⇒ In the circuit shown in the figure, steady-state was reached when the switch S was open. The switch was closed at t = 0. The initial value of the current through the capacitor 2
zero
0.0416666666666667
0.0833333333333333
0.125

⇒ For a Gaussian process, auto-correlation also implies
statistical dependence
statistical independence
ergodic process
none of the above

⇒ f_unity of an op-amp is about 1 kHz.
TRUE
FALSE