Question is ⇒ F = ∑(0, 3, 4, 5, 7) =, Options are ⇒ (A) [B ⊕ C] + AC, (B) B'C' + BC + AC, (C) AB + BC + CA, (D) None, (E) , Leave your comments or Download question paper.

Question is ⇒ F = ∑(0, 3, 4, 5, 7) =, Options are ⇒ (A) [B ⊕ C] + AC, (B) B'C' + BC + AC, (C) AB + BC + CA, (D) None, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	F = ∑(0, 3, 4, 5, 7) =
A.	[B ⊕ C] + AC [Wrong Answer]
B.	B'C' + BC + AC [Correct Answer]
C.	AB + BC + CA [Wrong Answer]
D.	None [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When a p-n Junction is forward biased
the current flow is due to electrons only
the majority carriers in both p and n materials are driven toward the junction.
the majority carriers in both p and n materials are away from the junction.
both (a) and (c).

⇒ Video signals are transmitted through
amplitude modulation
frequency modulation
either amplitude or frequency modulation
neither amplitude nor frequency modulation

⇒ Which of the following options is the closest in meaning to the world be
cyclic
indirect
confusing
crooked

⇒

Assertion (A): In FM the frequency of the carrier is varied by the modulating voltage

Reason (R): FM and PM are two forms of angle modulation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The term critical frequency denotes
the lowest frequency that is reflected by the ionosphere
the highest frequency that is reflected by the ionosphere at vertical distance
the lowest frequency by which communication is possible between two given points
none of the above

⇒ When a ferromagnetic substance is magnetised there are small changes in dimensions. This phenomenon is called
hysteresis
magnetostriction
diamagnetism
dipolar relaxation

⇒ The output of a full adder is
SUM
CARRY
SUM and CARRY
none of the above

⇒ The number of logic devices required in a Mod-16 synchronous counter are
4
5
6
7

⇒ L/C has the dimension of
time
capacitance
inductance
resistance

⇒ Identification of highest priority interrupt can be achieved in a minimum time by which of the following schemes?
Hardwired polling
Priority encode circuit
Software polling
Subdivision of interrupt register into a number of sub registers which are checked parallely

⇒ If E_y is the voltage applied to Y plates, the vertical deflection of beam is proportional to
E_y
E_y
E_y^1.5
E_y²

⇒ A full wave rectifier circuit using centre tapped transformer and a bridge rectifier are fed at 100 V, 50 Hz. The frequencies of outputs in these two rectifiers are
100 Hz each
50 Hz each
100 Hz and 50 Hz
50 Hz and 100 Hz

⇒ In a D-type latch EN = 1, D = 1, the O/P is
1
0
don't care
blocked

⇒ Four terminal approach is used in measuring low resistance because it
eliminates thermoelectric energy
eliminates stray capacitance
eliminates stray inductance
eliminates the effect of leads and contacts

⇒

Assertion (A): The 'do while' statement is used less frequently than the 'while' statement.

Reason (R): For most applications it is more natural to test for continuation of loop at the beginning than at the end of loop.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A two stage amplifier has an upper cutoff frequency of 2 MHz and a lower cutoff frequency of 2 MHz and a lower cut off frequency of 30 Hz. If both stages are similar, their individual upper and lower cut off frequencies respectively are
4 MHz and 60 MHz
3 MHz and 20 Hz
3 MHz and 60 Hz
4 MHz and 20 Hz

⇒ Which of the following is multiband HF receiving antenna?
Square loop
Log-periodic
Conical horn
Folded dipole

⇒ The given figure shows three Nyquist plots of G(s) H(s) = e^-sT/[s(s + 1)] for different values of T. The curves 1, 2, 3 ca
for T = 0, 0.5 and 1 respectively
for T = 1, 0.5 and 0 respectively
for T = 0.5, 1 and 0 respectively
for T = 0, 1 and 0.5 respectively

⇒ Consider the following statements: The function of oxide layer in an IC device is to

mask against diffusion or non implant
insulate the surface electrically
increase the melting point of silicon
produce a chemically stable protective layer

Of these statements:
1, 2, 3 are correct
1, 3, 4 are correct
2, 3, 4 are correct
1, 2, 4 are correct

⇒ A reactance function
has a pole at origin
has a zero at origin
may have a pole or zero at origin
has a pole or zero at origin and a pole or zero at infinity

⇒ For a bipolar transistor, avalanche multiplication factor depends on __________ .
V_CE
V_CB
V_BE
none of these

⇒ For an insulating material, dielectric strength and dielectric loss should be respectively
high and high
low and high
high and low
low and low

⇒ What does a link budget for satellite communication include?
Total cost of satellite
Cost of satellite plus launch vehicle
Signal and noise levels is dB
Margins of error permitted

⇒ Fidelity of a receiver represents
the sensitivity expressed in terms of voltage that must be applied to the receiver input to give a standard output
the extent to which the receiver is capable of distinguishing between the desired signal and other frequencies
the variation of the output with the modulation frequency when the output impedance is a resistance
none of the above

⇒

Assertion (A): The root locus of a control system is symmetrical about real axis.

Reason (R): For all polynomials with real coefficients, complex poles always occur in conjugate pairs.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ An electromagnetic wave can be completely guided by a dielectric rod or slab.
TRUE
FALSE

⇒ A narrow band noise n(t) has symmetrical spectrum and has power density spectrum 0.2 x 10^-6. The power density of quadrature component is
0.2 x 10^-6
10^-7
4 x 10^-7
5 x 10^-8

⇒ In 8085, the pairing of registers B, C, D, E, H, L is
B - C, D - E, H - L
B - D, C - E, H - L
B - C, D - L, H - E
B - H, D - E, C - L

⇒ Whether a linear system is stable or unstable that it
is a property of the system only
depends on the input function only
both (a) and (b)
either (a) or (b)

⇒

Assertion (A): In two wattmeter method of 3 phase power measurement, one of the wattmeters would read negative if power factor of load is less than 0.5.

Reason (R): In two wattmeter method of 3 phase power measurement, both the wattmeters would show equal readings if power factor of load is unity.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true