Question is ⇒ Eg is the band gap, A is pre-factor, k is Boltzmann constant? Which one of the following is the remaining grade of paper used in paper capacitor, besides the other two grade of paper-low and extra low loss?, Options are ⇒ (A) Strong dielectric, (B) Regular, (C) Rough, (D) High loss, (E) , Leave your comments or Download question paper.

Question is ⇒ Eg is the band gap, A is pre-factor, k is Boltzmann constant? Which one of the following is the remaining grade of paper used in paper capacitor, besides the other two grade of paper-low and extra low loss?, Options are ⇒ (A) Strong dielectric, (B) Regular, (C) Rough, (D) High loss, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	E_g is the band gap, A is pre-factor, k is Boltzmann constant? Which one of the following is the remaining grade of paper used in paper capacitor, besides the other two grade of paper-low and extra low loss?
A.	Strong dielectric [Wrong Answer]
B.	Regular [Correct Answer]
C.	Rough [Wrong Answer]
D.	High loss [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The order of the differential equa
1
2
3
4

⇒ Which of the following conditional statements is not valid in Pascal?
If A > = B then B : = C + D + X
If (N = 45) THEN X : = X + 2 ELSEX : = 0
If A < = B then A : = C * D
If (A > = B) X : Y else X : = Z

⇒ The waveguides compared to equivalent transmission lines at low frequency are
able to carry more power
less noisy
having lower attenuation
all of the above

⇒ A signal x(t) = 100 cos (24p x 10³t) is ideally sampled with a sampling period of 50 μ sec and then passed through an ideal low pass filter with cut off frequency of 15 kHz Which of the following frequencies are present at the filter output?
12 kHz only
8 kHz only
12 kHz and 9 kHz
12 kHz and 8 kHz

⇒ The moving iron instruments are generally repulsion type.
TRUE
FALSE

⇒ In a CE amplifier, the collector resistance is 6 kΩ and load resistance is 3 kΩ. The ac load resistance is
9 kΩ
6 kΩ
3 kΩ
2 kΩ

⇒ Mesh analysis is applicable __________ only.
planar network
non planar network
a circuit which contains only current sources
none

⇒ In a loss less line the propagation constant is equal to
jωLC
LC
jωLC
LC

⇒ The first column of a Routh arra
2
3
4
5

⇒ In PCM, the biggest disadvantage as compared to AM is
larger bandwidth
larger noise
inability to handle analog signals
incompatibility with time division multiplex systems

⇒

Assertion (A): In a series resonant circuit current is maximum at resonance.

Reason (R): The inductive and capacitive reactances are equal.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Match the following:

	List I (Double Rectifier)		List II (Number of Diodes)
A.	Full wave Bridge rectifier	1.	1
B.	Half wave rectifier	2.	2
C.	Full wave rectifier using centre tapped transformer	3.	4

A-1, B-2, C-3
A-3, B-1, C-2
A-2, B-1, C-3
A-3, B-1, C-2

⇒ The condition AD - BC = 1 for two port network implies that the network is a
reciprocal
lumped element network
lossless network
unilateral element network

⇒

Assertion (A): If an electron having charge e is revolving in an orbit of radius R and with angular velocity ω, the magnetic dipole moment of orbit is 0.5 eωR².

Reason (R): Orbital angular momentum and magnetic dipole moment are always equal.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Free electrons exist in
first band
second band
third band
conduction band

⇒ In figure, the capacitor is charged to 1 V. At t = 0 the switch is closed so that i = e^-t. When i = 0.37 A, the voltage across capacito
1 V
0.63 V
0.37 V
0.185 V

⇒ A constant k low pass T section filter has a characteristic impedance of 600 p at zero frequency. At f = f_c the characteristic impedance is
600 Ω
zero
infinite
more than 600 ohms

⇒ In a RAM chip with a total of 8096 words, the word addresses range from
1 to 8096
0 to 8095
1 to 8095
0 to 8096

⇒ The 8085 microprocessor is interrupted while executing MOV instruction at location 0210 H. What is the location at which contents of register D are stored
054 CH
054 DH
054 EH
054 FH

⇒ It is required to measure temperature in the range of 1300-1520°C. The most suitable thermocouple is
chromel constantan
iron constantan
chromel aluminium
platinum-rhodium

⇒

Assertion (A): A rectifier with inductor filter is more efficient for high load current.

Reason (R): In rectifier with inductor filter we can use a larger choke to reduce ripple, larger choke will have higher dc resistance which will result in lower dc output voltage for higher load current.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ An RLC series circuit has R = 7.07 Ω, L = .707 H and C = 7.07 μF. At Half power frequencies the circuit impedance is likely to be
7.07 Ω
10 Ω
14.14 Ω
20 Ω

⇒ What is the propagation constant for air filled wave guide with dimensions a = 1.59" and b = 0.795" at 4.95 GHz. The wave impedance is
400.94 Ω
562.94 Ω
502.80 Ω
492.80 Ω

⇒ In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit
all calculations done earlier have to be repeated
replace all calculated voltages by reverse values
replace all calculated currents by reverse values
replace all calculated voltages and currents by reverse values

⇒ Antenna radiation efficiency can be increased by
reducing radiation resistance of the system
increasing radiation resistance of the system
providing effective earthing
any of the above

⇒ Refer to the NAND and NOR latches shown in the figure. The inputs (P₁, P₂) for both the latches are first made (0, 1) and then, after a few seconds, made (1, 1). The corresponding stable outputs (Q₁, Q₂)
NAND: first (0, 1) then (0, 1) NOR: first (1, 0) then (0, 0)
NAND: first (1, 0) then (1, 0) NOR: first (1, 0) then (1, 0)
NAND: first (1, 0) then (1, 0) NOR: first (1, 0) then (0, 0)
NAND: first (1, 0) then (1, 1) NOR: first (0, 1) then (0, 1)

⇒ The number of flip-flops required to build a mod-19 counter is
4
5
6
7

⇒ Measurement of hall coefficient enables the determination of
mobility of charge carriers
type of conductivity and concentration of charge carriers
temperature coefficient and concentration of charge carriers
fermi level and forbidden energy gap

⇒ In 2's complement form, - 2 is
1011
1110
1100
1010

⇒ The main advantage of DM over PCM is
less bandwidth
less power
simple circuit
better S/N ratio