Question is ⇒ Epitaxial growth is used in ICs, Options are ⇒ (A) because it produces low parasitic capacitance, (B) because it yields back to back isolating pn junction, (C) to grow single crystal n doped silicon on a single crystal p type substrate, (D) to grow selectively single crystal p doped silicon of one resistivity on a p type substrate of a different resistivity, (E) , Leave your comments or Download question paper.

Question is ⇒ Epitaxial growth is used in ICs, Options are ⇒ (A) because it produces low parasitic capacitance, (B) because it yields back to back isolating pn junction, (C) to grow single crystal n doped silicon on a single crystal p type substrate, (D) to grow selectively single crystal p doped silicon of one resistivity on a p type substrate of a different resistivity, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Epitaxial growth is used in ICs
A.	because it produces low parasitic capacitance [Wrong Answer]
B.	because it yields back to back isolating pn junction [Wrong Answer]
C.	to grow single crystal n doped silicon on a single crystal p type substrate [Wrong Answer]
D.	to grow selectively single crystal p doped silicon of one resistivity on a p type substrate of a different resistivity [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the system in the given figure. The transfer function C(s)/R(s
G₁ + G₂ + 1
G₁ G₂ + 1
G₁ G₂ + G₂ + 1
G₁ G₂ + G₁ + 1

⇒ DS directive in 8085
forces the assembler to reserve one byte of memory
forces the assembler to reserve a specified number of bytes in the memory
forces the assembler to reserve a specified number of consecutive bytes in the memory
none of the above

⇒ Which of the following is not an integer constant?
2.3
156231
10
-256

⇒ Decimal 18.29 when converted int 10's complement will become
81.7707
81.7
81.777
81.077

⇒ A video monitor is exactly similar to TV receiver.
TRUE
FALSE

⇒ A 555 timer can be used as
an astable multivibrator
monostable multivibrator
frequency Divider only
any of the above

⇒ For a BJT, avalanche multiplication factor depends on
V_CE
V_CB
V_BE
none

⇒ A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if each array element feeding with 1 amp. current and operating at same frequency then find the half power beamwidth
4°
2°
10°
15°

⇒ When a p-n junction is forward biased, the current remains zero till the applied voltage overcomes the barrier potential.
TRUE
FALSE

⇒ The colour code on a carbon resistor is brown-black-red-gold. The value of resistance is
100 Ω
1000 Ω
1000 Ω ± 5%
1000 Ω ± 10%

⇒ Programs like compilers, assemblers etc. are stored in a mircocomputer in
registers
cache memory
primary memory
mass storage

⇒ The JFET in the circuit shown in figure has an I_DSS = 10 mA and V_p = -5V. The value of the resistance R_s for a drain current I_DS = 6.4 m
156 Ω
470 Ω
560 Ω
1 kΩ

⇒ Lead becomes a superconductor at
9.1 K
7 K
5 K
3 K

⇒ In an RC-coupled amplifier for improving the low frequency response
lower R_L is provided
more bias is used
less gain is provided
higher C_C is used

⇒ Percentage increase in the reverse saturation current of a diode if the temperature is increased from 25°C to 50°C
0.5
5
5.657
5.756

⇒ In the spectrum of a frequency modulated wave
carrier frequency cannot disappear
carrier frequency vanishes when modulation index is large
the number of significant sidebands depends upon modulation index
none of the above

⇒ For the system of the given figure, the closed loop poles ar
0 and -4
-2 ± j6
2 ± j6
-3 ± j8

⇒ If temperature increases by about 50°, the resistance of thermistor changes to
half of its initial value
twice of its initial value
eight times of its initial value
one eight of its initial value

⇒ An SCR has a turn on time of 4 μs. The gate pulse should have a duration of about
2 μs
5 μs
20 μs
50 μs

⇒ Consider the following stateme
1 and 2
1 and 3
2 and 3
3 only

⇒ For pole-zero plot shown, the system is ________
minimum phase
maximum phase
mixed phase
none of these

⇒ Which of the following has highest conductivity?
Silver
Aluminium
Tungsten
Platinum

⇒ A variable resistance R and capacitive reactance X_C are connected in series. As R is varied, the locus of Z is
a straight line parallel to Y axis in 4th quadrant
a straight line parallel to X axis in 4th quadrant
a straight line parallel to Y axis in second quadrant
a straight line parallel to Y axis in first quadrant

⇒ A short circuited stub is shunt connected to a transmission line as shown in the figure is, if z₀ = 500 ohms, the admittance y seen at the function of the stub and the transmission line
(0.01 - j 0.02) mho
(0.02 - j 0.01) mho
(0.04 - j 0.02) mho
(0.02 + j 0) mho

⇒

Assertion (A): Both sodium and ferrous are ferromagnetic.

Reason (R): Both sodium and ferrous have body centred cubic structure.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): If minimum phase system has a gain margin of 8 dB and phase margin of 21°, the system is stable.

Reason (R): For a minimum phase system both GM and PM must be positive for the system to be stable.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ If one wants to design a binary counter, preferred type of flip-flop is
D-type
SR type
Latch
JK type

⇒ Parabolic and lens antenna used at
microwave frequency
medium frequency
low frequency
high frequency

⇒ For an RC admittance function Y, the slope dY/dσ
is positive
is negative
may be positive or negative
0

⇒ The storage capacity of audio CD is 540 Mb per side.
TRUE
FALSE