Question is ⇒ Electric lines of force do not cross each other because, Options are ⇒ (A) the lines of force mutually repel each other, (B) the lines of force emanate from a point charge, (C) the tangent to the line of force gives the direction of E and if they cross two tangents for E which is not possible, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Electric lines of force do not cross each other because, Options are ⇒ (A) the lines of force mutually repel each other, (B) the lines of force emanate from a point charge, (C) the tangent to the line of force gives the direction of E and if they cross two tangents for E which is not possible, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Electric lines of force do not cross each other because
A.	the lines of force mutually repel each other [Wrong Answer]
B.	the lines of force emanate from a point charge [Wrong Answer]
C.	the tangent to the line of force gives the direction of E and if they cross two tangents for E which is not possible [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The 8086 arithmetic instruction work on

signed and unsigned numbers
ASCII data
unpacked BCD data

Select the correct answer using the codes given below :
1 and 2
1 and 3
2 and 3
1, 2 and 3

⇒ A clock signal driving a 6-bit ring counter has a frequency of 1 MHz. How long is each timing bit high?
1 ms
2 ms
3 ms
6 ms

⇒ The number of digits in hexadecimal system
15
16
10
8

⇒ An ac wave with superimposed dc is symmetrical about x - axis.
TRUE
FALSE

⇒ The h parameter h₁₁ is the same in CE and CC circuit.
TRUE
FALSE

⇒ A square in which each (i, j)^th element of matrix is equal to the negative of the conjugate complex of (j, i)^th element, is called
Hermitian matrix
Skew symmetric matrix
Conjugate anti-symmetric matrix
Skew-Hermitian matrix

⇒

Assertion (A): Many times a radar cannot detect 'grounding hopping' military aircraft.

Reason (R): Ground interference limits the range of radar.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A full adder adds
2 bits
3 bits
4 bits
any number of bits

⇒ Radiation efficiency of an antenna is defined as the ratio of
Total power radiated by an antenna to the net power accepted by the antenna from the connected transmitter
The frequency at which minimum power is radiated to the frequency at which maximum power is radiated
Total power accepted from the transmitter to total power generated by the transmitter
Power in main lobe to that in the side lobe

⇒ A communication channel disturbed by additive white, Gaussian noise has a bandwidth of 4 kHz and SNR of 15. The highest transmission rate that this channel can support (in k bits/sec) is
16
1.6
3.2
60

⇒ A TRIAC is equivalent to
two thyristors in series
two thyristors in parallel
one thyristor and one diode
one thyristor and one transistor

⇒ Which of the following microphones works on the principle of Faraday's law?
Carbon
Condenser
Moving coil
Electret

⇒

Match the following:

	List I (Types of memory)		List II (Used As)
A.	DRAM	1.	Cache memory
B.	SRAM	2.	Main memory
C.	Parallel Access Registers	3.	BIOS memory
D.	ROM	4.	CPU registers

A-1, B-4, C-2, D-3
A-3, B-4, C-2, D-1
A-1, B-2, C-4, D-3
A-3, B-2, C-4, D-1

⇒

Assertion (A): For networks in figure (1) and (2) sum of products of branch voltages and branch currents at any time is zero.

Reason (R): The networks in figure (1) and (2) are not the same structura
Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ For a high pass filter, β = p in attenuation band.
TRUE
FALSE

⇒ The five flags in 8085 are designated as
Z, CY, S, P and AC
D, Z, S, P, AC
Z, C, S, P, AC
Z, CY, S, D, AC

⇒ Nyquist plot provides information about absolute stability as well as relative stability.
TRUE
FALSE

⇒ The addressing mode depicted in the given figur
direct
register
register indirect
immediate

⇒ Heating effect of current is used in
ammeters
voltmeters
both ammeters and voltmeters
wattmeters

⇒ A waveguide twist is used to change the plane of polarization.
TRUE
FALSE

⇒ Which of the following is not an interrupt line in 8085?
TRAP
RST 5.5
RST 7.5
RST 9.5

⇒ Read the following statement

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The property not valid for basic singularity function is
it is even signal
convolution of any arbitrary function x{t) and an impulse is the original function itself.
the sum of two impulses at same location is the impulse with the strength equal to the summation of individual strengths.
none of these.

⇒

Assertion (A): A rectifier with inductor filter is more efficient for high load current.

Reason (R): In rectifier with inductor filter we can use a larger choke to reduce ripple, larger choke will have higher dc resistance which will result in lower dc output voltage for higher load current.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In voltage amplifiers, the load resistance
should be a small as possible
should be as large as possible
must be equal to output impedance
must be half of output impedance

⇒ In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit
all calculations done earlier have to be repeated
replace all calculated voltages by reverse values
replace all calculated currents by reverse values
replace all calculated voltages and currents by reverse values

⇒ Figure shows the arrangement
FM
PM
AM-DSB
AM-SSB

⇒ A low ratio of the A.C. load impedance of a diode detector results in
diagonal clipping
poor AGC operation
poor AF response
negative peak clipping

⇒ A current 10 sin (200t) A flows through a 5 mH inductance. The expression for voltage is
10 sin (200t + 90°)
10 sin (200t - 90°)
10 sin(1000t + 90°)
10 sin (1000t - 90°)

⇒ In a CD player the laser uses
silicon semiconductor
silicon/germanium semiconductor
aluminium gallium arsenide semiconductor
none of the above