Question is ⇒ Electric breakdown strength of a material depends on its, Options are ⇒ (A) composition, (B) moisture content, (C) thickness, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Electric breakdown strength of a material depends on its, Options are ⇒ (A) composition, (B) moisture content, (C) thickness, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Electric breakdown strength of a material depends on its
A.	composition [Wrong Answer]
B.	moisture content [Wrong Answer]
C.	thickness [Wrong Answer]
D.	all of the above [Correct Answer]
View Answer 4 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The effective refraction index of the ionosphere for radio wave is
more than unity
less than unity
equal to unity
either more or less than unity depending on the electron concentration

⇒ An m derived low pass filter has f_c = 1000 Hz and m = 0.6. This filter will have infinite attenuation at
f = 1250 Hz
all frequencies above 1000 Hz
f = 1562.5 Hz
f = 1666.67 Hz

⇒ Current requirement of a piezo buffer is about
100mA
20mA
4mA
0.4mA

⇒

Assertion (A): Alkali metals are used as emitters in phototubes.

Reason (R): Alkali metals have low work functions.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ When subjected to alternating stresses, an insulating material is characterised by complex dielectric constant ∈^'_r - j∈^"_r . In such materials, the dielectric losses under alternating stress is proportional
∈^"_r
both ∈^'_r and ∈^"_r
∈^'_r
(∈^"_r)²

⇒ If a signal f(t) has energy E, the energy of the signal f(2t) is equal to __________ .
E
E/2
E/4
2E

⇒ The characteristic equation of a feedback control system is given by s³ + 5s² + (K + 6)s + K
(- 3, 0)
(- 2, 0)
(- 1, 0)
(2, 0)

⇒ Radiation resistance of an antenna is 54 Ω and loss resistance is 6 Ω. If antenna has power gain of 10, then directivity is:
9
11.11
data not sufficient
10

⇒ In the circuit shown in the fi
only red will glow
only green will glow
both red and green will glow
none will glow

⇒ Which of following is recursive system?
y(n - 1)
y(n + 1)
y(n)
y(n) + y(n + 1)

⇒ A variable reluctance type tachometer has 150 teeth on rotor. The counter records 13500 pulse/sec. The rotational speed is
4800 RPM
5400 RPM
6000 RPM
7200 RPM

⇒ The units of resistivity are ohm-metre.
TRUE
FALSE

⇒ In a practical voltage source, the terminal voltage
cannot be less than source voltage
cannot be higher than source voltage
is always less than source voltage
is always equal to source voltage

⇒ The phase velocity of an EM wave propagating in a hollow metallic rectangular waveguide in the TE₁₀ mode is
equal to its group velocity
less than the velocity of light in free space
equal to the velocity of light in free space
greater than the velocity of light in free space

⇒ In which one of the following types of analog to digital convertors the conversion time is practically independent of the amplitude of the analog signal?
The dual slope integrating type
Successive approximation type
Counter ramp type
Tracking type

⇒ A cordless telephone using separate frequencies for transmission in base and portable units is known as
duplex arrangement
half duplex arrangement
either (a) or (b)
neither (a) nor (b)

⇒ In a TWT the loss in attenuator is
almost equal to forward gain of tube
much less than forward gain of tube
much higher than forward gain of tube
almost infinite

⇒ In a 3 phase full wave regulator feeding a star connected resistance load the input voltage is 400 V line to line. The firing angle is 160°. The line to line output voltage would be
400 V
about 100 V
about 20 V
zero

⇒ When a source is delivering maximum power to a load through a network, the ratio of power delivered to the source power
may be 50% or less than 50%
is 50%
may be 50% or more than 50%
may be 50% or more less than 50%

⇒ Which of the following statements is/are true for the diamond structure?

Coordination number is four.
Packing fraction is 0.34
Copper crystallizes into diamond structure
Lattice is FCC.

1 only
1, 2 and 4
2 and 3 only
2, 3 and 4

⇒ Which of the following is true?
SOP is a two level logic
POS is a two level logic
Both SOP and POS are two level logic
Hybrid function is two level logic

⇒ The counter shown in the given figure is built using 4 -ve edge triggered toggle FFs. The FF can be set asynchronously when R = 0. The combinational logic required to realize a modulo-13 counte
F = Q₄ Q₃ Q₂ Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄Q₃Q₂Q₁

⇒ Magnetic hysteresis phenomenon is explained by
motion of domain walls
motion of domain walls and domain rotation
domain rotation
none of the above

⇒ The unit of thermal resistance of a semi-conductor device is
Ohms
Ohms/°C
°C/ohm
°C/watt

⇒ Which of the following statement regarding link loss for a satellite is wrong?
For fixed antenna, it is inversely proportional to f²
For fixed frequency, it is inversely proportional to the product of the antenna aperture areas
For a given satellite operating at a given frequency, it is inversely proportional to
Loss in down-link is negligible as compared to that in uplink

⇒ The number of FF required for a divide by 12 circuit is
16
12
8
4

⇒ In CE approximately, the active region is where the collector curves are
almost horizontal
almost vertical
inclined at 45°
inclined at 60°

⇒ The amount of photoelectric emission current depends on
frequency of incident radiation
intensity of incident radiation
both frequency and intensity of incident radiation
none of the above

⇒ If the radiated power of AM transmitter is 10 kW, the power in the carrier for modulation index of 0.6 is nearly.
8.24 kW
8.47 kW
9.26 kW
9.6 kW

⇒ Hall effect can be used
to find type of semiconductor (whether p or n)
to find carrier concentration
to measure conductivity
all of the above