Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
Effective address is calculated by adding or subtracting displacement value to | |
A. | immediate address [Wrong Answer] |
B. | Relative address [Wrong Answer] |
C. | absolute address [Wrong Answer] |
D. | base address [Correct Answer] |
View Answer
Explanation:-
Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ If u is input, y is output and a, b are constants, the system y = au + b
is linear
is nonlinear
may be linear or nonlinear dependig on values of a and b
may be linear or nonlinear depending on value of u
⇒ A radar beacon is a small radar set having a receiver, a separate transmitter and an antenna.
TRUE
FALSE
⇒ The inverse response of a system h(n) = a^{n}∪(n) what is the condition for the system to be BIBO stable?
a is real and +ve
a is real and -ve
|a| > 1
|a| < 1
⇒ A computer monitor uses 180 W in normal operation and 20 W in sleep mode. The computer is on all the 24 hours but is in sleep mode for 18 hours a days. The energy units saved in 30 days are
0.54 units
86.4 units
2.88 units
4.8 units
⇒ In 8085 microprocessor, the interrupt enable flip-flop is reset by
DI instruction only
system RESET only
interrupt acknowledgment only
all of the above
⇒ Generally the wall thickness of rectangular waveguide is
about 1-5 mils
about 40-100 mils
about 0.1 to 0.5 mils
about 500 mils
⇒ In the graphical analysis of CE amplifier circuit, the intersection of base current and dc load line is called
saturation point
cut off point
Q point
operating point
⇒ A microprocessor needs memory chips and input-output chip to form a microcomputer.
TRUE
FALSE
⇒ Distances near the skip distance should be used for sky-wave propagation
to avoid the Faraday effect
to avoid tilting
to prevent sky-wave and upper ray interference
so as to exceed the critical frequency
⇒ Resistivity of carbon is around
10 to 70 m-ohm-cm
80 to 130 m-ohm-cm
800 to 1300 m-ohm-cm
8000 to 13000 m-ohm-cm
⇒ FORTRAN expression for 3b^{2}-5a^{2} is
SQRT (3 * B ** 2 - 5 * A ** 2)
SQRT 3 * B ** 2 - 5 * A ** 2
SQRT (3 * b ** 2 - 5 * a ** 2)
SQRT (3 * B ** 2) - SQRT (5 * A **2)
⇒ For a quadratic factor in transfer function the phase angle is not a function of damping factor.
TRUE
FALSE
⇒ The noise generated by a resistor depends upon
its resistance value
its operating temperature
both its resistance value and operating temperature
none of the above
⇒ The units of the spectrum obtained be Fourier transforming the covariance function of a stationery Stochastic Process is
Power per Hz
energy per Hz
Power per sec
Energy per second
⇒ An MTI compares a set of received echos with those received during the previous sweep.
TRUE
FALSE
⇒ When a function Z(s) having a pole at infinity is realized, we get
a capacitance in series
a resistance in series
an inductance in series
a resistance or inductance in series
⇒ If a signal band limited for f_{m} is sampled at a rate less than 2 f_{m} the reconstructed signal will be
smaller in amplitude
distorted
having higher frequencies suppressed
none of the above
⇒ A ring counter with 5 flip-flops will have __________ states.
5
10
32
Infinite
⇒ In anti-ferromagnetic materials, the graph of susceptibility versus temperature shows a sharp maximum at a certain temperature. This temperature is known as
Curie temperature
Neel temperature
Weiss temperature
Bitter temperature
⇒ In the network of figure, the voltage drops across R_{1}, R_{2}, R_{3} are 6 V, 8 V and 12 V with polarities as shown. The value of R_{312 Ω8 Ω5 Ω3 Ω}
⇒ If (225)_{Y} = (165)_{8} find value of Y
7
8
9
11
⇒ The Sun blots out the transmission of a geosynchronous satellite twice a year when satellite passes directly in front of it. This outage lasts for about
10 minutes on 5 consecutive days
5 minutes on 10 consecutive days
30 minutes for 5 consecutive days
one hour for 5 consecutive days
⇒ In a clocked NAND latch, race condition occur when
R and S are high CLK is low
R and CLK are high and S is low
R, S, CLK are high
R, S, CLK are low
⇒ In figure V_{i} may vary from 15 to 20 V and load current may vary from 20 mA to 100 mA. Suitable maximum value of
20 Ω
50 Ω
100 Ω
200 Ω
⇒ A digital voltmeter can count from 0 to 9999. If full scale reading is 9.999 V, the resolution of full scale reading is
0.001
1000
2 digit
1 mV
⇒ Which of the following is used in integrated circuits?
Microstrip line
Coaxial line
Twin wire line
Shield cable
⇒ When the magnetic vector is parallel to the boundary surface and electric vector is parallel to the place of incidence, the polarization is
zero
vertical
perpendicular
horizontal
⇒ Determine the potential difference between the points A and B in the steady s
40 V
60 V
25 V
75 V
⇒ In a uniformly doped BJT, assume that N_{E}, N_{B} and N_{C} are the emitter, base and collector dopings in atoms/cm^{3}, respectively. If the emitter injection efficiency of the BJT is close unity, which one of the following conditions is TRUE?
N_{E} = N_{B} = N_{C}
N_{E} >> N_{B} and N_{B} > N_{C}
N_{E} = N_{B} and N_{B} < N_{C}
N_{E} < N_{B} < N_{C}
⇒ In a multiphase chopper, the different choppers operate in
series and all simultaneously
parallel and one at a time
parallel and simultaneously
either (b) or (c)
⇒ If u is input, y is output and a, b are constants, the system y = au + b
is linear
is nonlinear
may be linear or nonlinear dependig on values of a and b
may be linear or nonlinear depending on value of u
⇒ A radar beacon is a small radar set having a receiver, a separate transmitter and an antenna.
TRUE
FALSE
⇒ The inverse response of a system h(n) = a^{n}∪(n) what is the condition for the system to be BIBO stable?
a is real and +ve
a is real and -ve
|a| > 1
|a| < 1
⇒ A computer monitor uses 180 W in normal operation and 20 W in sleep mode. The computer is on all the 24 hours but is in sleep mode for 18 hours a days. The energy units saved in 30 days are
0.54 units
86.4 units
2.88 units
4.8 units
⇒ In 8085 microprocessor, the interrupt enable flip-flop is reset by
DI instruction only
system RESET only
interrupt acknowledgment only
all of the above
⇒ Generally the wall thickness of rectangular waveguide is
about 1-5 mils
about 40-100 mils
about 0.1 to 0.5 mils
about 500 mils
⇒ In the graphical analysis of CE amplifier circuit, the intersection of base current and dc load line is called
saturation point
cut off point
Q point
operating point
⇒ A microprocessor needs memory chips and input-output chip to form a microcomputer.
TRUE
FALSE
⇒ Distances near the skip distance should be used for sky-wave propagation
to avoid the Faraday effect
to avoid tilting
to prevent sky-wave and upper ray interference
so as to exceed the critical frequency
⇒ Resistivity of carbon is around
10 to 70 m-ohm-cm
80 to 130 m-ohm-cm
800 to 1300 m-ohm-cm
8000 to 13000 m-ohm-cm
⇒ FORTRAN expression for 3b^{2}-5a^{2} is
SQRT (3 * B ** 2 - 5 * A ** 2)
SQRT 3 * B ** 2 - 5 * A ** 2
SQRT (3 * b ** 2 - 5 * a ** 2)
SQRT (3 * B ** 2) - SQRT (5 * A **2)
⇒ For a quadratic factor in transfer function the phase angle is not a function of damping factor.
TRUE
FALSE
⇒ The noise generated by a resistor depends upon
its resistance value
its operating temperature
both its resistance value and operating temperature
none of the above
⇒ The units of the spectrum obtained be Fourier transforming the covariance function of a stationery Stochastic Process is
Power per Hz
energy per Hz
Power per sec
Energy per second
⇒ An MTI compares a set of received echos with those received during the previous sweep.
TRUE
FALSE
⇒ When a function Z(s) having a pole at infinity is realized, we get
a capacitance in series
a resistance in series
an inductance in series
a resistance or inductance in series
⇒ If a signal band limited for f_{m} is sampled at a rate less than 2 f_{m} the reconstructed signal will be
smaller in amplitude
distorted
having higher frequencies suppressed
none of the above
⇒ A ring counter with 5 flip-flops will have __________ states.
5
10
32
Infinite
⇒ In anti-ferromagnetic materials, the graph of susceptibility versus temperature shows a sharp maximum at a certain temperature. This temperature is known as
Curie temperature
Neel temperature
Weiss temperature
Bitter temperature
⇒ In the network of figure, the voltage drops across R_{1}, R_{2}, R_{3} are 6 V, 8 V and 12 V with polarities as shown. The value of R_{312 Ω8 Ω5 Ω3 Ω}
⇒ If (225)_{Y} = (165)_{8} find value of Y
7
8
9
11
⇒ The Sun blots out the transmission of a geosynchronous satellite twice a year when satellite passes directly in front of it. This outage lasts for about
10 minutes on 5 consecutive days
5 minutes on 10 consecutive days
30 minutes for 5 consecutive days
one hour for 5 consecutive days
⇒ In a clocked NAND latch, race condition occur when
R and S are high CLK is low
R and CLK are high and S is low
R, S, CLK are high
R, S, CLK are low
⇒ In figure V_{i} may vary from 15 to 20 V and load current may vary from 20 mA to 100 mA. Suitable maximum value of
20 Ω
50 Ω
100 Ω
200 Ω
⇒ A digital voltmeter can count from 0 to 9999. If full scale reading is 9.999 V, the resolution of full scale reading is
0.001
1000
2 digit
1 mV
⇒ Which of the following is used in integrated circuits?
Microstrip line
Coaxial line
Twin wire line
Shield cable
⇒ When the magnetic vector is parallel to the boundary surface and electric vector is parallel to the place of incidence, the polarization is
zero
vertical
perpendicular
horizontal
⇒ Determine the potential difference between the points A and B in the steady s
40 V
60 V
25 V
75 V
⇒ In a uniformly doped BJT, assume that N_{E}, N_{B} and N_{C} are the emitter, base and collector dopings in atoms/cm^{3}, respectively. If the emitter injection efficiency of the BJT is close unity, which one of the following conditions is TRUE?
N_{E} = N_{B} = N_{C}
N_{E} >> N_{B} and N_{B} > N_{C}
N_{E} = N_{B} and N_{B} < N_{C}
N_{E} < N_{B} < N_{C}
⇒ In a multiphase chopper, the different choppers operate in
series and all simultaneously
parallel and one at a time
parallel and simultaneously
either (b) or (c)