Question is ⇒ Effect of loading of line is, Options are ⇒ (A) increase in Z0, a and β, (B) increase in Z0 and β but decrease in a, (C) decrease in Z0, a and β, (D) decrease in Z0 and β but increase in a, (E) , Leave your comments or Download question paper.

Question is ⇒ Effect of loading of line is, Options are ⇒ (A) increase in Z0, a and β, (B) increase in Z0 and β but decrease in a, (C) decrease in Z0, a and β, (D) decrease in Z0 and β but increase in a, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Effect of loading of line is
A.	increase in Z₀, a and β [Wrong Answer]
B.	increase in Z₀ and β but decrease in a [Correct Answer]
C.	decrease in Z₀, a and β [Wrong Answer]
D.	decrease in Z₀ and β but increase in a [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For Ergodic Process
ensemble Average equal to time Average
ensemble Average is not equal to time Average
ensemble Average > Time Average
ensemble Average < Time Average

⇒ In a negative feedback amplifier A = 100, β = 0.04 and V_s = 50 mV, then feedback will be
4
8
10
2

⇒ The function of an AM detector circuit is to
rectify the input signal
discard the carrier
provide audio signal
all of the above

⇒ The maximum signal propagation time of a geosynchronous satellite transmission is about __________ millisecond.
540
270
135
1080

⇒ In a CE amplifier the ac cut off voltage is 9 V and slope of ac load line is - 0.5 mA/V. The ac saturation current is
9 mA
4.5 mA
3 mA
18 mA

⇒ In a crystal
the frequencies of series and parallel resonance are equal
the frequency of series resonance is more than frequency of parallel resonance
the frequency of parallel resonance is more than frequency of series resonance
None of the above

⇒ Due to the formation of Schottky defects the density of the crystal
increases slightly
increases appreciably
decreases slightly
decreases appreciably

⇒ A wire has a diameter d and resistance R. If the diameter is made 3d, the length and material remaining the same, the new value of resistance will be
R/3
3 R
R/9
9 R

⇒ For frequencies upto 1650 kHz __________ antenna is used
yagi
grounded
turnstile
marconi

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then modulating frequency is
159 Hz
1590 Hz
1.59 MHz
15.9 MHz

⇒

Match the following:

	List I (Characteristics)		List II (Decrease)
A.	Paramagnetic	1.	All dipoles are aligned is one preferred direction
B.	Ferromagnetic	2.	Half the dipoles are aligned in opposite direction and have equal magnitude
C.	Antiferromagnetic	3.	Half the dipoles (with equal magnitudes) are aligned in opposite direction to the other half having equal but lower magnitude
D.	Ferrimagnetic	4.	All dipoles have equal magnitude but are randomly oriented

A-4, B-3, C-2, D-1
A-4, B-1, C-2, D-3
A-2, B-1, C-4, D-3
A-2, B-3, C-4, D-1

⇒ CATV stands for
Common Antenna Television
Community Antenna Television
Cable Antenna Television
Channel Antenna Television

⇒ An ideal power supply has
zero internal resistance
very high internal resistance
high output resistance
both (b) and (c)

⇒ Which of the following are difficult to be fabricated in a monolithic IC?
Inductors
Large capacitors
Small capacitors
Both (a) and (b)

⇒ In FM noise can be decreased by a feature that AM does not have
increasing deviation
decreasing deviation
reducing modulation index
increasing modulation index

⇒ FET amplifier is more difficult to analyse than BJT amplifier.
TRUE
FALSE

⇒ A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. If the oscillator is to be made variable using the same value of R, what should be the value of capacitor to obtain a frequency if 1 kHz?
636 pF
180 pF
65 pF
30 pF

⇒ In binomial arrays the elimination of secondary lobes takes place
at the cost of directivity
at the cost of gain
both (a) and (b)
none of the above

⇒ Ferrimagnetic materials have anti-parallel orientation of equal moments of permanent dipoles.
TRUE
FALSE

⇒

Assertion (A): For the function shown in fi
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ What is the purpose of using ALE signal high?
To latch low order address from bus to separate A₀ - A₇ lines
To latch data D₀ - D₇ from bus to separate data bus
To disable data bus latch
All of the above

⇒ In Java 31% gives an answer
3
4
42798
42828

⇒ The resolution of a wire wound potentiometer is about
0.00001
0.001
0.01
0.05

⇒ In figure the output V₀
2V₁ + V₂ - 2V₃
2(V₁ + V₂) - V₃
V₁ + V₂ + V₃
V₁ + 2V₂ - V₃

⇒ If a piece of wood is placed in a magnetic field
the magnetic field will not be affected
the magnetic lines of force will bend towards the piece
the magnetic lines of force will bend away from the piece
the flux may increase or decrease

⇒ The circuit given below
Band stop filter
Band pass filter
Oscillator circuit
All pass filter

⇒ The 8086 arithmetic instruction work on

Select the correct answer using the codes given below :
1 and 2
1 and 3
2 and 3
1, 2 and 3

⇒ For an RC admittance function Y, the slope dY/dσ
is positive
is negative
may be positive or negative
0

⇒ If E is electric field intensity, the current density due to field emission is proportional to
E
E²
E^2.5
E^3/2

⇒ A single phase bridge type cycloconverter uses eight thyristors.
TRUE
FALSE