Question is ⇒ Eddy current loss is, Options are ⇒ (A) proportional to frequency, (B) independent of frequency, (C) proportional to (frequency)2, (D) proportional to (frequency)3, (E) , Leave your comments or Download question paper.

Question is ⇒ Eddy current loss is, Options are ⇒ (A) proportional to frequency, (B) independent of frequency, (C) proportional to (frequency)2, (D) proportional to (frequency)3, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Eddy current loss is
A.	proportional to frequency [Wrong Answer]
B.	independent of frequency [Wrong Answer]
C.	proportional to (frequency)² [Correct Answer]
D.	proportional to (frequency)³ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ E7F6₁₆ = __________ .
600000₁₀
59382₁₀
9382₁₀
382₁₀

⇒ A chopper
converts constant voltage dc into ac and then into variable voltage dc
converts constant voltage dc into variable voltage dc directly
converts ac of one frequency into ac of another frequency
converts ac to dc

⇒ In a JK master slave flip flop
master is clocked when clock is low
slave is clocked when clock is high
master is clocked when clock is high and slave is clocked when clock is low
master is clocked when clock is low and slave is clocked when clock is high

⇒ A vibration galvanometer is a
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ One of the advantages of base modulation over collector modulation in a class C transistor amplifier is
higher efficiency
more linear operation
more power output per transistor
lesser requirement of modulating power

⇒ Permittivity has the units of F/m.
TRUE
FALSE

⇒ In 180° mode of operation of a 3 phase bridge inverter, two thyristors conduct at one time.
TRUE
FALSE

⇒ In a combination limiter with sinusoidal input voltage the output wave can be nearly square.
TRUE
FALSE

⇒ In figure, capacitor is used to develop pulses of short duration and large duty cycle across R₂ when switch is closed. Which of the following combinations is best sui
R₁ and R₂ large but C small
R₁ and R₂ small but C large
R₁ and C large and R₂ small
R₂ and C large but R₁ small

⇒ Which of the following bridges is also used in an oscillator?
Maxwell
Schering
Hay
Wien

⇒ Which of the following transducers requires a high input impedance preamplifier for proper measurements?
Thermocouple
Piezoelectric
Thermistor
L.V.D.T

⇒ A d.c. power supply has an open circuit voltage of 100 V. When the full load current is drawn, the output drops to 80 V. The percentage voltage regulation is
0.9725
0.75
0.5
0.25

⇒ In figure, which value of Z_L will cause maximum power to be transferred to the l
2 + j2 Ω
2 - j2 Ω
- 2 Ω
2 Ω

⇒ The network shown in the figure represen
band pass filter
low pass filter
high pass filter
band stop filter

⇒ When a peripheral device is not ready for data transfer it will send to the microprocessor a
low READY bit
high READY bit
low or high READY bit depending on whether input or output is activated
none of the above

⇒ De Sauty bridge is very widely used due to
simplicity
perfect balance for imperfect capacitor
perfect balance for air capacitors
maximum sensitivity

⇒ Thyristors can be used for control of
dc separately excited motor
dc shunt motor
dc series motor
all of the above

⇒ The response of a function is decided by
the location of its zeros
the location of its poles
both (a) and (b)
none of the above

⇒ During playback the take up reel is
in clockwise motion
in anticlockwise motion
either clockwise or anticlockwise motion
none of the above

⇒ The first machine cycle of an instruction is always
a memory read cycle
a fetch cycle
a input/output read cycle
a memory write cycle

⇒ A metal loses electrons at room temperature.
TRUE
FALSE

⇒ In a single phase full wave ac regulator the rms value of load current is 20 A load is purely resistive. Then
average thyristor current will be less than 20 A but rms thyristor current will be more than 20 A
both the average and rms thyristor currents will be less than 20 A
both the average and rms thyristor currents will be more than 20 A
rms thyristor current will be 20 A and average thyristor current will be 10 A

⇒ Which of the following ICs has only one NAND gate?
7410
7420
7430
7447

⇒ Consider the following statements regarding electro-dynamometer type indicating instrum
1 and 2 are corect
3 and 4 are correct
1 and 3 are correct
1, 2, 3, 4 are correct

⇒ Consider the following differences between QPSK and MSK

The side lobes in MSK are relatively much smaller in comparison to the main lobe
The spectrum of MSK has a main centre lobe which is 1.5 times as wide as the main lobe of QPSK
The waveforms of both MSK and QPSK exhibit phase continuity

Which of the above statements are correct?
1 only
1 and 2 only
1, 2 and 3
2 and 3 only

⇒ In force voltage analogy the quantity analogous to spring constant K is
R
C
L
1/C

⇒ In a ferromagnetic material, the internal field seen by a dipole is
equal to applied field
equal to applied field minus a contribution from neighbouring dipoles
equal to applied field plus a contribution from neighbouring dipoles
equal to or less than applied field

⇒ The output of a Piezoelectric crystal has
low amplitude and low impedance
high amplitude and low impedance
low amplitude and high impedance
high amplitude and high impedance

⇒ A forward voltage of 9 V is applied to a diode in series with a 1 kΩ load resistor. The voltage across load resistor is zero. It indicates that
diode is short circuited
diode is open circuited
resistor is open circuited
diode is either short circuited or open circuited

⇒ Which one of the following is correct?
Coding reduces the noise in the signal
Coding deliberately introduces redundancy into messages
Coding increases the information rate
Coding increases the channel bandwidth