Question is ⇒ ECL can be used to high frequencies in the order of, Options are ⇒ (A) 500 kHz, (B) 1 MHz, (C) 100 MHz, (D) 500 MHz, (E) , Leave your comments or Download question paper.

Question is ⇒ ECL can be used to high frequencies in the order of, Options are ⇒ (A) 500 kHz, (B) 1 MHz, (C) 100 MHz, (D) 500 MHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	ECL can be used to high frequencies in the order of
A.	500 kHz [Wrong Answer]
B.	1 MHz [Wrong Answer]
C.	100 MHz [Wrong Answer]
D.	500 MHz [Correct Answer]
View Answer 3 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is the point of reference JFET?
Drain
Gate
Source
None of the above

⇒ Which one of following is correct condition to check the stability of sysytem in terms of impulse response?
Σ(x(n)) < ∞
Σx(n) < 0
Σx(n) = 0
Σx(n) = ∞

⇒ In a one pole active low pass filter, the cut off frequency is f_c. Then
gain decreases at the rate of 20 dB per decade increase in frequency above f_c
gain decreases at the rate of 20 dB per decade decrease in frequency below f_c
gain decreases at the rate of 40 dB per decade increase in frequency above f_c
gain decreases at the rate 40 dB per decade decrease in frequency below f_c

⇒ For the time domain response shown in figure the
lies in left half plane
lies in right half plane
lies at origin
may be complex or imaginary

⇒ A current source inverter has simple commutation circuit.
TRUE
FALSE

⇒

Assertion (A): A backward wave oscillator has an internal positive feedback.

Reason (R): A positive feedback is necessary for sustained oscillations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider the following statements

Acceptor level lies close the valence band.
Donor level lies close to the valence band.
n type semiconductor behaves as an insulator at 0 K.
p type semiconductor behaves as an insulator at 0 K.

Of these statements:
2 and 3 are correct
1 and 3 are correct
1 and 4 are correct
3 and 4 are correct

⇒ A collector collects
electrons from the base in case of N-P-N transistor
electrons from the emitter in case P-N-P transistor
holes from the base in case of N-P-N transistor
holes from the base in case of P-N-P transistor

⇒ A Darlington pair consist of
two CB amplifiers
two CC amplifiers
two cascaded CC amplifiers
two cascaded CE amplifiers

⇒ In figure, A is ideal ammeter having zero resistance. It will read __________ amp
2
2.5
3
4

⇒ An encoder converts decimal numbers to binary and other codes.
TRUE
FALSE

⇒ Which of the following is equivalent to x?
x EX-OR 0
x EX-NOR 0
1 NOR x
x AND x

⇒ Which of the following is the ferric electric material?
Rochelle salt
Barium titanate
Potassium dihydrogen phosphate
All of the above

⇒ A bypass capacitor produces
dc ground
ac ground
both dc and ac ground
none of the above

⇒ Which of the following is the common feature between FETs and bipolars?
Have low input impedance
Have low voltage gain
Are difficult to bias
None of them

⇒ For the current wave i = 10 + 10 sin θ, the rms value is
0.416666666666667
12.247 A
20 A
14.14 A

⇒

Assertion (A): A demultiplexer cannot be used as a decoder

Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): The surge current which an SCR can withstand is much higher than rms on state current.

Reason (R): The duration of surge current is very small.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): FM requires more bandwidth than AM

Reason (R): Wide band FM is used for broadcast transmissions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The permeability of soft iron can be increased by
purifying it
reducing carbon percentage
alloying with cobalt
increasing percentage

⇒ Which of the following statements is true regarding the fundamental mode of the metallic waveguides sh
Only P has no cutoff- frequency
Only Q has no cutoff- frequency
Only P has no cutoff- frequency
All there have cut-off frequency

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. The frequencies present in the output will be
998 kHz and 1002 kHz
998 kHz, 999.2 kHz, 1000.8 kHz, 1002.0 kHz
998 kHz, 999.2 kHz, 999.7 kHz, 1000.3 kHz, 1000.8 kHz and 1000.2 kHz
none of the above

⇒ At T = 0, the resistivity of a perfect single crystal of a metal is
0
low
high
finite

⇒ In equally tampered musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals

⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bits) is FFFF. Its magnitude in decimal representation is
0
1
32, 767
65, 535

⇒

Assertion (A): The output of a NOR gate is equal to the complement of OR of input variables.

Reason (R): A XOR gate is a universal gate.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A narrow band noise show
AM only
AM and FM
FM
PCM

⇒ A second order system will have
all resistances
resistances and inductances
resistances, inductance and capacitances
either (b) or (c)

⇒ In figure, V_{020 V
10 V
5 V
0}

⇒ Reflection from the object to be measured is significant only when the wavelength is
much bigger than the size of object
much smaller than the size of object
almost of the size of object
either (a) or (c)