Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
Each of two cascaded stages has a voltage gain of 30. The overall gain is | |
A. | 3 [Wrong Answer] |
B. | 9 [Wrong Answer] |
C. | 30 [Wrong Answer] |
D. | 900 [Correct Answer] |
View Answer
Explanation:-
Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ Which of the following bus is used to transfer data from main memory to peripheral device?
DMA bus
Output bus
Input bus
Data bus
⇒ The diagram to show distance time history of electrons in klystron amplifier is called
apple gate diagram
asynchronous diagram
bunching diagram
velocity modulation diagram
⇒ A 100 + j 100 Ω load is to be matched to a line with Z_{0} = 300 Ω to give SWR = 1. The reactance of stub is
j 200 Ω
-j 200 Ω
j 100 Ω
-j 100 Ω
⇒ The total number of fundamental products of three variables is
3
5
8
16
⇒ A voltage v = 100 sin ωt + 10 sin 5 ωt is applied to a pure capacitor having capacitance of 1 μF. If ω = 314 rad/sec, the current through the capacitor is
0.0314 cos 314 t + 0.0157 cos 1570 t
0.0314 sin 314 t + 0.0157 sin 1570 t
0.0314 cos 314 t + 0.0314 cos 1570 t
0.0157 cos 314 t + 0.0157 cos 1570 t
⇒ In 8085, which of the following registers cannot be paired?
A
E
C
both (b) and (c)
⇒ Audio frequency range lies between
20 Hz and 20 kHz
20 kHz and 20 MHz
2 MHz and 20 MHz
20 MHz and 200 MHz
⇒ Consider the following statements about loop antenna
1 and 2 only
1 only
1, 2, 3
2 and 3 only
⇒ When a complex voltage wave is applied to a capacitor the resulting current wave is more distorted than the voltage wave.
TRUE
FALSE
⇒ Three phase four wire induction energy meter is used to measure
energy in 3 phase balanced star load
energy in 3 phase balanced delta load
energy in 3 phase unbalanced load
either (a) or (b)
⇒ The resistance of a metallic wire would
increase as the operating frequency increase
decrease as the operating frequency increase
remain unaffected on increasing the operating frequency
first increase then decrease
⇒ The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be
200
40.12
4.878
2.2
⇒ The pressure coil of a wattmeter should be connected to the supply side of the current coil when
load impedance in high
load impedance is low
voltage is high
voltage is low
⇒ The characteristic impedance of loss less transmission line is
L/R
L/C
1/LC
C/L
⇒ The on voltage and forward breakover voltage of an SCR depend on
gate current alone
band gap of semiconductor alone
gate current and semiconductor band gap respectively
semiconductor band gap and gate current respectively
⇒ A mode-10 counter can divide the clock frequency by a factor of
10
100
1000
10000
⇒ If the target cross-section is changing, the best scanning system for accurate tracking is
lobe switching
monopulse
sequential lobing
conical scanning
⇒ Which of the following is a valid variable in FORTRAN 77?
0.125
ALPHA -3
ALPHA 3
BALPHAC
⇒ A good dielectric should have
low losses
good heat conductivity
high intrinsic strength
all of the above
⇒ VLF is generally used for
telegraphy
satellite communication
instrument landing system
all of the above
⇒ The changes in ambient temperature affect the open loop gain of amplifier.
TRUE
FALSE
⇒ For a BJT, under the saturation region.
I_{C} = βI_{B}
I_{C} > βI_{B}
I_{C} is independent of other parameter
I_{C} < βI_{B}
⇒ 84_{16} - 2A_{16} is equal to
5A_{16}
4A_{16}
7A_{16}
15A_{16}
⇒ The log magnitude for the system in the given figure is (where T =
20 log (1 + ωT)
-20 log (1 + ωT)
-10 log (1 + ω^{2}T^{2})
-20 log (1 + ω^{2}T^{2})
⇒ The cut in voltage
is the same for silicon and germanium diodes
is a forward voltage
is a reverse voltage
is a forward voltage below which the current is very small
⇒ The property is not valid for basic singularity function is
it is even signal
convolution of any arbitary function x(t) and an impulse is the original function itself
the sum of two impulses at same location is the impulse with the strength equal to the summation of individual strengths.
none of these.
⇒ The maximum counting range of a four stage counter using IC 74193 is
0 to 1023
0 to 4093
0 to 65535
0 to 131071
⇒ The two modes of operation of three phase bridge inverters are known as
60° mode and 120° mode
90° mode and 120° mode
120° mode and 180° mode
120° mode and 240° mode
⇒ Which of the following is 'synchronous'?
Half adder
Full adder
R-S flip-flop
Clocked R-S flip-flop
⇒ TTL inverter has
one input
two inputs
one or two inputs
three inputs
⇒ Which of the following bus is used to transfer data from main memory to peripheral device?
DMA bus
Output bus
Input bus
Data bus
⇒ The diagram to show distance time history of electrons in klystron amplifier is called
apple gate diagram
asynchronous diagram
bunching diagram
velocity modulation diagram
⇒ A 100 + j 100 Ω load is to be matched to a line with Z_{0} = 300 Ω to give SWR = 1. The reactance of stub is
j 200 Ω
-j 200 Ω
j 100 Ω
-j 100 Ω
⇒ The total number of fundamental products of three variables is
3
5
8
16
⇒ A voltage v = 100 sin ωt + 10 sin 5 ωt is applied to a pure capacitor having capacitance of 1 μF. If ω = 314 rad/sec, the current through the capacitor is
0.0314 cos 314 t + 0.0157 cos 1570 t
0.0314 sin 314 t + 0.0157 sin 1570 t
0.0314 cos 314 t + 0.0314 cos 1570 t
0.0157 cos 314 t + 0.0157 cos 1570 t
⇒ In 8085, which of the following registers cannot be paired?
A
E
C
both (b) and (c)
⇒ Audio frequency range lies between
20 Hz and 20 kHz
20 kHz and 20 MHz
2 MHz and 20 MHz
20 MHz and 200 MHz
⇒ Consider the following statements about loop antenna
- It is suitable for direction finding application
- It is a single turn or multiturn coil carrying RF current
- The loop is surrounded by a magnetic field everywhere perpendicular to the loop
1 and 2 only
1 only
1, 2, 3
2 and 3 only
⇒ When a complex voltage wave is applied to a capacitor the resulting current wave is more distorted than the voltage wave.
TRUE
FALSE
⇒ Three phase four wire induction energy meter is used to measure
energy in 3 phase balanced star load
energy in 3 phase balanced delta load
energy in 3 phase unbalanced load
either (a) or (b)
⇒ The resistance of a metallic wire would
increase as the operating frequency increase
decrease as the operating frequency increase
remain unaffected on increasing the operating frequency
first increase then decrease
⇒ The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be
200
40.12
4.878
2.2
⇒ The pressure coil of a wattmeter should be connected to the supply side of the current coil when
load impedance in high
load impedance is low
voltage is high
voltage is low
⇒ The characteristic impedance of loss less transmission line is
L/R
L/C
1/LC
C/L
⇒ The on voltage and forward breakover voltage of an SCR depend on
gate current alone
band gap of semiconductor alone
gate current and semiconductor band gap respectively
semiconductor band gap and gate current respectively
⇒ A mode-10 counter can divide the clock frequency by a factor of
10
100
1000
10000
⇒ If the target cross-section is changing, the best scanning system for accurate tracking is
lobe switching
monopulse
sequential lobing
conical scanning
⇒ Which of the following is a valid variable in FORTRAN 77?
0.125
ALPHA -3
ALPHA 3
BALPHAC
⇒ A good dielectric should have
low losses
good heat conductivity
high intrinsic strength
all of the above
⇒ VLF is generally used for
telegraphy
satellite communication
instrument landing system
all of the above
⇒ The changes in ambient temperature affect the open loop gain of amplifier.
TRUE
FALSE
⇒ For a BJT, under the saturation region.
I_{C} = βI_{B}
I_{C} > βI_{B}
I_{C} is independent of other parameter
I_{C} < βI_{B}
⇒ 84_{16} - 2A_{16} is equal to
5A_{16}
4A_{16}
7A_{16}
15A_{16}
⇒ The log magnitude for the system in the given figure is (where T =
20 log (1 + ωT)
-20 log (1 + ωT)
-10 log (1 + ω^{2}T^{2})
-20 log (1 + ω^{2}T^{2})
⇒ The cut in voltage
is the same for silicon and germanium diodes
is a forward voltage
is a reverse voltage
is a forward voltage below which the current is very small
⇒ The property is not valid for basic singularity function is
it is even signal
convolution of any arbitary function x(t) and an impulse is the original function itself
the sum of two impulses at same location is the impulse with the strength equal to the summation of individual strengths.
none of these.
⇒ The maximum counting range of a four stage counter using IC 74193 is
0 to 1023
0 to 4093
0 to 65535
0 to 131071
⇒ The two modes of operation of three phase bridge inverters are known as
60° mode and 120° mode
90° mode and 120° mode
120° mode and 180° mode
120° mode and 240° mode
⇒ Which of the following is 'synchronous'?
Half adder
Full adder
R-S flip-flop
Clocked R-S flip-flop
⇒ TTL inverter has
one input
two inputs
one or two inputs
three inputs