Question is ⇒ Each frequency in the modulating wave gives rise to four side bands., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ Each frequency in the modulating wave gives rise to four side bands., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Each frequency in the modulating wave gives rise to four side bands.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Electronic and Ionic polarization in a polyatomic gas are independent of temperature.

Reason (R): The orientation polarization is independent of temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The following statements are true with respect to "Cascode Amplifier".

The reduction in h₁₂ and Miller capacitance result in negligible reverse internal feedback.
A's is large loads cannot be connected.
As a narrow band amplifier, it provides small range of c_μ is reduced.
As a narrow band amplifier it provides small range of frequencies parameters the effect of c_μ reduces.

only 1
only 1 and 4
only 2 and 4
only 1 and 3

⇒ For global communication, the number of satellites needed is
1
3
10
5

⇒

Assertion (A): Gray code is used in shaft position encoding.

Reason (R): In gray code only a single bit change occurs when going from one code to another.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The control logic for a binary multiplier is specified by a states diagram. The state diagram has four states and two inputs. To implement it by the sequence register and decoder method.
two flip-flop & 2 x 4 decoder are needed
four flip-flop & 2 x 4 decoder are needed
two flip-flop & 3 x 9 decoder are needed
four flip-flop & 3 x 9 decoder are needed

⇒ DVD uses
Laser beam for both recording and playback
Laser beam for recording and video head for playback
Video head for recording and laser beam for playback
None of the above

⇒ A full wave rectifier using centre tapped transformer and a bridge rectifier use similar diodes and have equal no load output voltage. Under equal load conditions
Output voltage of bridge rectifier
Output voltage of bridge rectifier will be more than that of other
Output voltage of both will be exactly equal
Output voltage of any one may be more than that of other

⇒ When measuring phase angle between two waves using a CRO, the time base generator is connected to
X plate
Y plate
both X and Y plate
neither X nor Y plates

⇒ Δ²V = - r/E is known as __________ equation
Poisson
Fourier
Laplace
Maxwell

⇒ In a 3 phase bridge inverter with 120° mode of operation the. number of thyristors conducting at one time are
1
2
3
4

⇒ If the temperature of an extrinsic semiconductor is increased so that the intrinsic carrier concentration is doubled, then
the majority carrier density is doubled
the minority carrier density is doubled
the minority carrier density becomes 4 times the original value
both the majority and minority carrier densities double

⇒ The first critical frequency nearest the origin of the complex frequency plane for an RL driving point impedance will be
a zero in left half plane
a zero in right half plane
a pole in left half plane
a pole or zero in left half plane

⇒ In a JK flip flop toggle means
set Q = 1 and Q = 0
set Q = 0 and Q = 1
change the output to the opposite state
no change in output

⇒ In a klystron amplifier dc electron velocity is v₀ and dc electron charge density is r₀ the dc beam current is
r₀v₀
r₀^/v₀
v₀^/r₀
(v₀^/r₀)²

⇒ The coils of Drysdale polar potentiometer are wound non-inductively.
TRUE
FALSE

⇒

Assertion (A): A GTO can be turned on and turned off by gate pulses

Reason (R): A GTO can be turned off by negative gate pulse.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of these has lowest dielectric strength?
Dry air
Wet air
Cotton
Paper

⇒ Registers and counters are similar in the sense that they both
count pulses
store binary information
are made from an array of flip-flops and gates integrated on a single chip
are shift registers

⇒ Absolute permeability (μ) is given by __________ henry/metre
4p x 10^-12
4p x 10^-7
8.854 x 10^-12
8.854 x 10^-7

⇒ When .4546 E 5 and .5433 E 7 are to be added in normalized floating point mode
none of the numbers is changed to any other form
.4546 E 5 is changed .004546 E 7 and .5433 E 7 is not changed
.5433 E 7 is changed to 54.33 E 5 and .4546 E 5 is not changed
both the numbers are changed and their exponents are made equal to 6

⇒ In a thermocouple temperature transducer, the output voltage is usually measured by
high resistance ammeter
high resistance voltmeter
high resistance milli-voltmeter
none of the above

⇒ A 1000 kHz carrier is simultaneously modulated by 300 Hz and 2 kHz audio sine wave. Which of the following frequencies will not be present in the output?
998 kHz
999.7 kHz
1000.3 kHz
700 kHz

⇒ A current source inverter has simple commutation circuit.
TRUE
FALSE

⇒ The saturation current in a semi-conductor diode
depends on forward voltage
depends on reverse voltage
is due to thermally generated minority carriers
none of the above

⇒ For a random variable x following the probability density function, p(x), shown in figure, the mean and the variance are respective
1/2 and 2/3
1 and 4/3
1 and 2/3
2 and 4/3

⇒ For a NAND SR latch of input is the normal resting state of inputs is
S = R = 1
S = 0, R = 1
S = 1, R = 0
S = R = 0

⇒

Assertion (A): Different symbols are used for different gates

Reason (R): IEEE symbols are the same as traditional symbols for gates.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A meter having 0-1000 μA range and 1000 Ω resistance is required to be changed to 0-100 mA meter. The value of shunt resistance is about
1 Ω
10 Ω
99 Ω
100 Ω

⇒ The SID data received is
LSB first
LSB last
1
none of these

⇒ The circuit shown in the figure has 4 boxes each described by inputs P, Q, R and outputs Y, Z
4 bit adder giving P + Q
4 bit subtractor giving P - Q
4 bit subtractor giving Q - P
4 bit adder giving P + Q + R