Question is ⇒ During processing the instructions, data, intermediate results and final results in a computer are held in, Options are ⇒ (A) CPU, (B) ALU, (C) Primary memory, (D) Secondary memory, (E) , Leave your comments or Download question paper.

Question is ⇒ During processing the instructions, data, intermediate results and final results in a computer are held in, Options are ⇒ (A) CPU, (B) ALU, (C) Primary memory, (D) Secondary memory, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	During processing the instructions, data, intermediate results and final results in a computer are held in
A.	CPU [Wrong Answer]
B.	ALU [Wrong Answer]
C.	Primary memory [Correct Answer]
D.	Secondary memory [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A moving iron instrument has
two iron vanes, one fixed and one movable
two movable iron vanes
two aluminium vanes, one fixed and one movable
two vanes, one fixed made of Aluminium and the other movable made of iron

⇒ A two branch parallel circuit has a 20 Ω resistance and 1 H inductance in one branch and a 100 μF capacitor in the second branch. It is fed from 100 V ac supply, at resonance, the input impedance of the circuit is
500 Ω
50 Ω
20 Ω
5 Ω

⇒ For an illumination control circuit it is advisable to use a matched TRIAC-DIAC pair.
TRUE
FALSE

⇒ The orientation polarization of a polyatomic gas is inversely proportional to absolute temperature.
TRUE
FALSE

⇒ A differential amplifier is invariably used in the I/P stage of all OP-amps. This is done basically to produce the OP-amp with a very high.
CMRR
bandwidth
slew rate
open-loop gain

⇒ Which of the following statements is true regarding the fundamental mode of the metallic waveguides sh
Only P has no cutoff- frequency
Only Q has no cutoff- frequency
Only P has no cutoff- frequency
All there have cut-off frequency

⇒ Surface integral of the electric field intensity is
differential of volume flux
electrical charge
net flux emanating from the surface
none of the above

⇒ An SR flip flop can be built using
NOR gate only
NAND gate only
either NOR or NAND gates
neither NOR nor NAND gates

⇒ The deflection of a DArsonval galvanometer is measured through a mirror and scale. The mirror is 1 m away from the light source. The mirror is mounted on, the moving system. If mirror rotates through 0.2 rad the displacement on the scale is
0.2 m
0.4 m
0.1 m
0.05 m

⇒ If three cascaded stages of amplifier have gains 10, 20 and 30 the overall voltage will be
30
60
600
6000

⇒ Which of the following is used to generate PDM?
Free running multi-vibrator
Monostable multi-vibrator
JK flip-flop
Schmitt trigger

⇒ The saturation current in a semi-conductor diode
depends on forward voltage
depends on reverse voltage
is due to thermally generated minority carriers
none of the above

⇒ In brushless excitation system of modern alternators, the main exciter is
dc generator
ac generator
either dc or ac generator
induction generator

⇒ Which curve represents the fidelity curve of a standard recei
Curve A
Curve B
Curve C
Curve D

⇒ If a = 0.995, I_E = 10 mA, I_CO = 0.5 mA, then I_CEO will be
100 μA
25 μA
10.1 μA
10.5 μA

⇒ If f(t) is in volts, then F(jω) is in
volts
volt seconds
volts/sec
volt-sec²

⇒ The number of comparators of needed in a parallel conversion type 8 bit A to D converter is
8
16
255
256

⇒ In figure, the capacitor is charged to 1 V. At t = 0 the switch is closed so that i = e^-t. When i = 0.37 A, the voltage across capacito
1 V
0.63 V
0.37 V
0.185 V

⇒ The purpose of incorporating a pre-selector stage in a receiver is to
provide higher selectivity
provide higher fidelity
improve linearity
larger passband

⇒ If f(t) = A d(t - a), F(s) is
A e^-as
A e^as
A a e^-as
Aa e^as

⇒ The speed transducer using a drag cup rotor has the main advantage of
very high accuracy
low energy requirement
cheap construction
all of the above

⇒ If ω is the frequency of modulating voltage in FM, the modulation index is proportional to
ω
1/ω
ω
1/ω

⇒ Which one of the following is digital?
Pulse code modulation
Pulse width modulation
Pulse frequency modulation
Pulse position modulation

⇒ Figure repres
Integrator
Differentiator
High Pass Filter
Band Pass Filter

⇒ In controlled heating circuits, thyristors act as
rectifier
inverter
ac regulator
chopper

⇒ In a P-N-P transistor, electrons flow
into the transistor at the collector only
into the transistor at the base and the collector leads
out of the transistor at base and collector leads
out of the transistor at base, collector as well as emitter leads

⇒ A current of 3.25 A is flowing through a resistance of 34.98 Ω. The voltage drop across resistance to the appropriate number of significant figures is
113.685 V
113.68 V
113.6 V
114 V

⇒ If an electron move through a potential difference of 500 V, the energy possesses by it will be
500 ergs
500 joules
500 eV
500 mV

⇒ In a four variable K map eight adjacent cells give
single variable term
two variable term
three variable term
four variable term

⇒ A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the starting torque is 100 N-m. At 25 Hz, the starting torque
will be less than 100 N-m
will be more than 100 N-m
may be more or less than 100 N-m depending on motor parameters
very small