Question is ⇒ During electroplating the weight of a substance deposited depends upon, Options are ⇒ (A) shape of the article, (B) quantity of electricity, (C) room temperature, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ During electroplating the weight of a substance deposited depends upon, Options are ⇒ (A) shape of the article, (B) quantity of electricity, (C) room temperature, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	During electroplating the weight of a substance deposited depends upon
A.	shape of the article [Wrong Answer]
B.	quantity of electricity [Correct Answer]
C.	room temperature [Wrong Answer]
D.	all of the above [Wrong Answer]
View Answer 18 -5 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a lead acid battery, separators are provided to
reduce internal resistance.
facilitate flow of the current.
avoid internal short circuits.
increase the energy efficiency.

⇒ Rust, scales and oxides can be removed from a surface with the help of
various acids.
alkali and salt solution.
mechanical abrasion.
electrolytic cleaning any of the above.

⇒ Which of the following cells is more likely to be damaged due to short circuiting ?
Daniel cell
Dry Cell
Acid cell
Fuel cell

⇒ Whithin the electric cell, the charge is transported by
Free electrons
Only positive ions
Only negative ions
Both positive and negative ions

⇒ In comparison to constant current charging method, the constant voltage charging method of charging a lead acid battery has the advantage(s) of
increasing capacity of the battery.
reducing charging time.
avoiding of excessive gassing.
both (b) and (c).

⇒ The emf of a lead battery
increases with the increase in specific gravity of the electrolyte.
slightly increases with the increase in temperature.
decreases with the increase in temperature.
both (a) and (b).

⇒ A 24 V battery of internal resistance r = 4 ω connected to a variable resistance R. The rate of heat dissipation in the resistor is maximum when the current drawn from the battery is I. The current drawn from the battery will be 1/2 when R is equal to
8 ω
12 ω
16 ω
20 ω

⇒ Which of the following tests is performed for ascertaining whether the battery plates are defective or not?
Specific gravity test.
High discharge test.
Cadmium test.
None of the above.

⇒ Nickel-cadmium accumulators in comparison to nickel-iron accumulators have the advantages of
being lighter in weight and cheaper in cost.
low internal resistance and longer life.
higher emf and higher efficiency.
all of the above.

⇒ The arrangement of 12 cells, each of internal resistance 1.5 ω, to give maximum current in external load resistance of 2 ω will be
all 12 cells in series.
all 12 cells in parallel.
4 cells in series with 3 rows in parallel.
3 cells in series with 4 rows in parallel.

⇒ First electrochemical cell was designed by
Galvani
Faraday
Lechlanche
None of these

⇒ What happens during the charging of acid cell ?
Voltage increases
Energy is given out
Both
None of these

⇒ The ratio of the number of hydrogen to that of oxygen atoms liberated in the electrolysis of acidulated water is
1 : 4
1 : 2
2 : 1
4 : 1

⇒ In a lead acid battery, fillers are provided to
facilitate flow of gasses
prevent flow of gasses.
recover acid losses through vapours.
reduce tendency for polarisation.

⇒ Battery charging equipment should be installed
in well ventilated, clean and dry place.
as near as practical to the battery under charge.
both (a) and (b).
wherever convenient.

⇒ Oil and grease can be removed from a surface with the help of
soaps.
hot alkaline solutions.
solvents such as gasoline or carbon tetrachioride.
any of the above.

⇒ Short circuiting of a cell results in
reduced gassing during charging.
abnormal high temperature.
low specific gravity of the electrolyte.
all of the above.

⇒ What happens during the discharging of Edison cell ?
Relative density of electrolyte decreases
The emf does not change
The emf decreases
Relative density increases

⇒ If the specific gravity of the electrolyte in a lead acid cell increases beyond 1.23 there will be
loss of life.
loss of capacity.
increase in internal resistance.
corrosion of the grids of the plate.

⇒ What causes lower efficiency of alkali cell as compared to the acid cell ?
Lower emf
Small amount of electrolyte
Longer life
Higher internal resistance

⇒ The emf of primary cell depends upon the
physical dimensions of a cell.
nature of electrolyte.
nature of electrode.
both (b) and (c).

⇒ Charging of a sulphated battery at high rate causes
warping of plates.
boiling of electrolyte owing to gassing.
damage to separators, cell caps, covers and battery case due to excessive temperature.
all of the above.

⇒ Which of the following statements is correct about lead acid batteries ?
It delivers current as soon as its components are put together.
Density of electrolyte increases while delivering current
lt does not deliver current on putting its components together until it is supplied electrical energy from an external source
It has lead as positive plates.

⇒ Capacity of a dry cell is
more when it supplies current continuously.
more when it supplies current intermittently.
not affected by the type of discharge.
none of the above.

⇒ Common impurity in a battery electrolyte is
dust particles.
iron.
lead crystals.
sodium chloride.

⇒ Standard cell
will have precise and accurate constant voltage when current drawn from it is few microamperes only.
will have precise and accurate constant voltage when few milliamperes are drawn from it.
will continue to have constant voltage irrespective of loading conditions.
can supply voltages up to 10 V.

⇒ During electrodeposition. the amounts of different substances liberated by same quantity of electricity are proportional to
atomic weights.
valency.
chemical equivalents.
atomic numbers

⇒ The relative density of the electrolyte of acid accumulator should not be allowed to fall below
1.80
1.50
1.28
1.18

⇒ In which of the following cells polarisation is the major defect ?
Voltanic cell
Lechlanche cell
Daniel cell
None of these

⇒ Who was the first to design storage cell ?
Plante
Galvani
Edison
Volta