Question is ⇒ During electrodeposition. the amounts of different substances liberated by same quantity of electricity are proportional to, Options are ⇒ (A) atomic weights., (B) valency., (C) chemical equivalents., (D) atomic numbers, (E) , Leave your comments or Download question paper.

Question is ⇒ During electrodeposition. the amounts of different substances liberated by same quantity of electricity are proportional to, Options are ⇒ (A) atomic weights., (B) valency., (C) chemical equivalents., (D) atomic numbers, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	During electrodeposition. the amounts of different substances liberated by same quantity of electricity are proportional to
A.	atomic weights. [Wrong Answer]
B.	valency. [Wrong Answer]
C.	chemical equivalents. [Correct Answer]
D.	atomic numbers [Wrong Answer]
View Answer 12 -4 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Capacity of a dry cell is
more when it supplies current continuously.
more when it supplies current intermittently.
not affected by the type of discharge.
none of the above.

⇒ The amount of ions liberated by 96500 C of charge passed through the electrolyte is called ?
Electrochemical equivalent
Chemical equivalent
Gram equivalent
None of these

⇒ For a group of cells when internal resistance of the group is equal to external load resistance, the group will deliver maximum
voltage.
current.
ampere-hours.
efficiency.

⇒ A battery is connected to a resistance causing a current of 0.5 A in the circuit. The current drops to 0.4 A when an additional resistance of 5 ω is connected in series. The current will drop to 0.2 A when the resistance is further increased by
10 ω
15 ω
25 ω
40 ω

⇒ Rust, scales and oxides can be removed from a surface with the help of
various acids.
alkali and salt solution.
mechanical abrasion.
electrolytic cleaning any of the above.

⇒ The emf of primary cell depends upon the
physical dimensions of a cell.
nature of electrolyte.
nature of electrode.
both (b) and (c).

⇒ Overcharging of a lead acid battery would cause
excessive gassing.
loss of active material.
increase in temperature resulting in buckling of plates.
all of the above.

⇒ Addition of which of the following substances in electrolyte promotes smooth deposition?
Albumen.
Glucose.
Phenol.
Any of these.

⇒ Who was the first to design storage cell ?
Plante
Galvani
Edison
Volta

⇒ In a lead acid battery, separators are provided to
reduce internal resistance.
facilitate flow of the current.
avoid internal short circuits.
increase the energy efficiency.

⇒ The capacity of a lead acid battery is adversely affected by increase in
discharge rate.
charge rate.
temperature.
specific gravity of the electrolyte.

⇒ Nickel-cadmium accumulators in comparison to nickel-iron accumulators have the advantages of
being lighter in weight and cheaper in cost.
low internal resistance and longer life.
higher emf and higher efficiency.
all of the above.

⇒ Through an electrolyte an electric current is due to drift of
Free electrons
Positive and negative ions
Free electrons and holes
Protons

⇒ Which of the following statements is correct about lead acid batteries ?
It delivers current as soon as its components are put together.
Density of electrolyte increases while delivering current
lt does not deliver current on putting its components together until it is supplied electrical energy from an external source
It has lead as positive plates.

⇒ Charging of a sulphated battery at high rate causes
warping of plates.
boiling of electrolyte owing to gassing.
damage to separators, cell caps, covers and battery case due to excessive temperature.
all of the above.

⇒ Five cells are connected in series in a row and then four such rows are connected in parallel to feed the current to a resistive load of 1.25 ω. Each cell has an emf of 1.5 V with an internal resistance of 0.2 ω. The current through the load will be
3.33 A
23.33 A
5 A
1 A

⇒ Which of the following acts as depolariser in Lechlanche cell ?
MnO₂
NH₄Cl
Mn₂O₃
ZnCI₂

⇒ The energy capacity of a storage battery is rated in
kWh.
kW.
ampere hours.
joules.

⇒ In a lead acid battery, excessive formation of lead sulphate occurs due to
idleness of battery for a long time.
low level of electrolyte.
persistent undercharging.
all of the above.

⇒ The ratio of the number of hydrogen to that of oxygen atoms liberated in the electrolysis of acidulated water is
1 : 4
1 : 2
2 : 1
4 : 1

⇒ For keeping the lead acid battery terminals free from corrosion it is advisable to
keep electrolyte level low
apply petroleum jelly.
charge the battery at frequent intervals.

⇒ Which of the following statements is incorrect about lead acid batteries ?
The electrolyte in weak sulphuric acid.
When fully charged both of the plates become lead-per-oxide.
The number of plates is always odd.
The number of negative plates is one more than the number of positive plates.

⇒ Internal resistance of primary cell varies
inversely with the distance between electrodes.
inversely with the surface area of electrodes.
directly with the distance between electrodes
with the nature of electrodes.

⇒ In which of the following cells polarisation is the major defect ?
Voltanic cell
Lechlanche cell
Daniel cell
None of these

⇒ For achieving uniform thickness of deposit on irregular surface
anode and cathode are kept farther apart
anode and cathode are kept closer.
high current densities are used.
electrolyte is agitated constantly

⇒ Short circuiting of a cell results in
reduced gassing during charging.
abnormal high temperature.
low specific gravity of the electrolyte.
all of the above.

⇒ Standard cell
will have precise and accurate constant voltage when current drawn from it is few microamperes only.
will have precise and accurate constant voltage when few milliamperes are drawn from it.
will continue to have constant voltage irrespective of loading conditions.
can supply voltages up to 10 V.

⇒ A 24 V battery of internal resistance r = 4 ω connected to a variable resistance R. The rate of heat dissipation in the resistor is maximum when the current drawn from the battery is I. The current drawn from the battery will be 1/2 when R is equal to
8 ω
12 ω
16 ω
20 ω

⇒ During electrodeposition. the amounts of different substances liberated by same quantity of electricity are proportional to
atomic weights.
valency.
chemical equivalents.
atomic numbers

⇒ The emf of a lead battery
increases with the increase in specific gravity of the electrolyte.
slightly increases with the increase in temperature.
decreases with the increase in temperature.
both (a) and (b).