Question is ⇒ During day time ionosphere can be considered to be consisting of, Options are ⇒ (A) D, E, F1 and F2 layers, (B) D, E, F1 layers, (C) D, E, F2 layers, (D) D and E layers, (E) , Leave your comments or Download question paper.

Question is ⇒ During day time ionosphere can be considered to be consisting of, Options are ⇒ (A) D, E, F1 and F2 layers, (B) D, E, F1 layers, (C) D, E, F2 layers, (D) D and E layers, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	During day time ionosphere can be considered to be consisting of
A.	D, E, F₁ and F₂ layers [Correct Answer]
B.	D, E, F₁ layers [Wrong Answer]
C.	D, E, F₂ layers [Wrong Answer]
D.	D and E layers [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a multiphase chopper, the different choppers operate in
series and all simultaneously
parallel and one at a time
parallel and simultaneously
either (b) or (c)

⇒ A TV remote control works on the principle of
pulse code modulated ultra violet light
pulse code modulated infrared light
demodulation
either (a) or (b)

⇒ A source is delivering maximum power to a resistance through a network. The ratio of power delivered to the source power,
is always 0.5
may be 0.54 or less
may be 0.5 or less
may be 0.5 or more

⇒ Resistivity of metals is expressed in terms of
μ ohm
μ ohm/cm
μ ohm-cm
μ ohm-cm/°C

⇒ Consider the following symbols for arithmetic operators for integers

Which of the above are used in Pascal?
1, 2 and 4 only
All
1, 2, 3 only
1 and 4 only

⇒ Find the FSV (full scale voltage) in a 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V.
6.4 V
0.1 V
7 V
8 V

⇒ In a minimum function
the degree of numerator and denominator are equal
the degree of numerator and denominator are unequal
the degree of numerator is one more than degree of denominator
the degree of numerator is one less than degree of denominator

⇒ Ferrites have
low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒ A number is expressed in binary 2's complement as 10011 decimal equivalent value is
19
13
-19
-13

⇒ ALU 1C 74181 can accept two words each having
2 bits
4 bits
8 bits
16 bits

⇒ Number of fundamental cut-sets of any graph will be
same as the number of twigs
same as the number of tree branches
same as the number of nodes
equal to one

⇒ State variable formulation is very suitable for computer solution.
TRUE
FALSE

⇒ The circuit shown in the figure conv
BCD to Binary code
Binary to excess - 3 code
Excess - 3 to Gray
Gray to Binary

⇒ In the given figure the number of combinations of three non touching loop
0
1
2
3

⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is
30 V
60 V
15 V
10 V

⇒ The analog signal m(t) is given below m(t) = 4 cos 100 pt + 8 sin 200 pt + cos 300 pt, the Nyquist sampling rate will be
1/100
1/200
1/300
1/600

⇒ A FET has
very high input resistance
very low input resistance
high connection emitter junction
forward biased PN junction

⇒ In pulse width modulation of chopper
T is kept constant and T_on is varied
T_on is kept constant T is varied
both T and T_on are varied
either T or T_on is varied

⇒ The generic microprocessor contains a zero and a carry flag. These are located on
interrupt control
status register
either (a) or (b)
none of the above

⇒ For a 1 cm x 2 cm air filled rectangular waveguide the maximum frequency should be less than about
1000 MHz
5000 MHz
14000 MHz
140000 MHz

⇒ Temperature is analogous to
voltage
flux
charge
none of the above

⇒ The Boolean function A + BC is a reduced form of
AB + BC
(A + B) . (A + C)
AB + ABC
(A + C) . B

⇒ In a CD the channel separation is
1 μm
1.6 μm
2.5μm
4 μm

⇒ (FE35)₁₆ XOR (CB15)₁₆ is equal to
(3320)₁₆
(FE35)₁₆
(FF50)₁₆
(3520)_l6

⇒ In the circuit of figure the current through C at t = &infin
0.166666666666667
2.5 A
3.1 A
0

⇒ If V_A = - 10 V and V_B = - 15 V, VAB = 5 V.
TRUE
FALSE

⇒ In the circuit, S was initially open. At time t = 0, S is closed. When the current through the inductor is 6 A, the rate of change of current through the resistor is 6 A/s. The value of the inductor woul
1 H
2 H
3 H
4 H

⇒ The typical squelch circuit
cuts off IF amplifier when AGC is minimum
cuts off IF amplifier when AGC is maximum
cuts off audio amplifier when carrier is absent
eliminates RF interference when signal is weak

⇒ In the circuit of figure, PIV can be u
E_m
2 E_m
0.5 E_m
2 E_m

⇒ The characteristic equation of flip-flop gives the next state Q_{N + 1} in terms of present state Q_N and the inputs. Which one of the following is the characteristic equation of J - K flip-flop?
Q_N+1 = JQ_N + KQ_N
Q_N+1 = J + KQ_N
Q_N+1 = KQ_N + JQ_N
Q_N+1 = K + JQ_N