Question is ⇒ Distances near the skip distance should be used for sky-wave propagation, Options are ⇒ (A) to avoid the Faraday effect, (B) to avoid tilting, (C) to prevent sky-wave and upper ray interference, (D) so as to exceed the critical frequency, (E) , Leave your comments or Download question paper.

Question is ⇒ Distances near the skip distance should be used for sky-wave propagation, Options are ⇒ (A) to avoid the Faraday effect, (B) to avoid tilting, (C) to prevent sky-wave and upper ray interference, (D) so as to exceed the critical frequency, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Distances near the skip distance should be used for sky-wave propagation
A.	to avoid the Faraday effect [Wrong Answer]
B.	to avoid tilting [Wrong Answer]
C.	to prevent sky-wave and upper ray interference [Correct Answer]
D.	so as to exceed the critical frequency [Wrong Answer]
View Answer 2 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which liquid crystal is used for LCD display?
Mercury
Pneumatic fluid
Aqua regia
Liquid boron

⇒ The core of a solenoid is made of material of relative permeability μ_r. A small cavity area dA and length dl is cut in the core. If it is desired that flux density in the cavity should be equal to B₀
the fields inside and outside the cavity must be equal
the field inside the cavity must be made stronger than field outside the cavity
the field inside the cavity must be made weaker than the field outside the cavity
none of the above

⇒ A . 0 =
1
A
0
A or 1

⇒

Assertion (A): In circular waveguide the attenuation of TE₀₁ mode decreases as the operating frequency increases.

Reason (R): The wall currents in a circular waveguide in TE_Q1 mode are completely circumferential.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The most commonly used moving iron instruments are
repulsion type
attraction type
a combination of attraction and repulsion type
none of the above

⇒ Schrodinger wave equation is partial differential equation.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	AM-DSB FC	1.	2
B.	WBFM	2.	1
C.	PCM	3.	3m
D.	AM-DSB	4.	2^2N

A-1, B-2, C-3, D-4
A-2, B-1, C-4, D-3
A-2, B-3, C-4, D-1
A-4, B-3, C-2, D-1

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I_CBO = 0, if V_BB = 6V, R_E = 2 kΩ and β = 90, I_BQ = 20 μA then I_{EQ1800 μA
180 μA
2000 μA
3000 μA}

⇒ The gain margin for a stable system
has a positive decibel value
has a negative decibel value
has a large negative decibel value
none of the above

⇒ In a cable with ∈_r = 4, the wave velocity is
3 x 10⁸ m/s
0.75 x 10⁸ m/s
1.5 x 10⁸ m/s
10⁸ m/s

⇒ The open wired circuit in the given figure works
EX - NOR gate
AND gate
XOR gate
NOR gate

⇒ In Z_RC(s) has a pole at s = 0, the first element in first Foster realization is
a capacitor
a resistor
R-C in series
either a capacitor or resistor

⇒ Trinitron is a monochrome picture tube.
TRUE
FALSE

⇒ In the above case, what will be the value of capacitor to obtain 100 kHz frequency?
0.0065 pF
0.0130 pF
0.0260 pF
0.520 pF

⇒ A radar receiver has a noise figure of 10 dB at 300 K having a bandwidth of 2.5 MHz. The minimum power it can receive is
3.45 x 10^-15 W
1.38 x 10^-15 W
7.5 x 10^-15 W
93.15 x 10^-15 W

⇒ Negative feedback reduces noise originating at the amplifier input.
TRUE
FALSE

⇒ Which of the following terms are applicable to troposcatter propagation?
Faradays rotation
SIOs
Fading
Atmospheric storms

⇒ Ultra high frequency oscillators work in the range
20 Hz to 20 kHz
1 kHz to 30 kHz
30 kHz to 30 MHz
above 30 MHz

⇒ The derivative of unit step function is
unit impulse
ramp with slope 1
impulse
either (a) or (b)

⇒ Which of the following correctly declares a pointer to an array of intergers in C?
int * P [20]
int * P
int (* P) [20]
int * (P [20])

⇒ VF glows with __________ colour when activated.
Red
Orange
Bluish green
none of these

⇒ The 8085 microprocessor is interrupted while executing MOV instruction at location 0210 H. What is the location at which contents of register E are stored.
054 CH
054 DH
054 EH
054 FH

⇒ The response of a function is decided by
the location of its zeros
the location of its poles
both (a) and (b)
none of the above

⇒ How much r.m.s. current does a 300 W, 200 V bulb take from the 200V, 50 Hz power line?
0.5 A
1.5 A
0.0833333333333333
0.125

⇒ To couple a coaxial line to a parallel wire line, it is best to use a
balun
slotted line
quarter wave transformer
directional coupler

⇒ Program counter in a digital computer
counts the number of program run in the machine
counts the number of times a subroutine is called
counts the number of times the loops are executed
points the memory address of the current or the next instruction to be executed

⇒ A meter coil has a resistance of 100 Ω and a full scale deflection current of 10 mA. To convert it into a voltmeter of 0-200 V range, the series resistance should be
20 kΩ
19.9 kΩ
1.9 kΩ
20.1 kΩ

⇒ Consider the following statements about data structures in Pascal

Arrays and files are types of data structures.
List structure is not a data structure in Pascal.
Each element of a binary tree is called a node of the tree.

Which of the above are statements correct?
All
1, and 2 only
1 and 3 only
2 and 3 only

⇒ TM₀₁ mode in circular waveguide is analogous to
TM₁₀ mode in square waveguide
TM₁₁ mode in square waveguide
TM₂₀ mode in square waveguide
TM₀₂ mode in square waveguide

⇒ Find R_{AB2 Ω
1.5 Ω
3 Ω
None of the above}