Question is ⇒ Directivity of antenna is defined as, Options are ⇒ (A) maximum directive gain, (B) average directive gain, (C) ∞, (D) 0, (E) , Leave your comments or Download question paper.

Question is ⇒ Directivity of antenna is defined as, Options are ⇒ (A) maximum directive gain, (B) average directive gain, (C) ∞, (D) 0, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Directivity of antenna is defined as
A.	maximum directive gain [Correct Answer]
B.	average directive gain [Wrong Answer]
C.	∞ [Wrong Answer]
D.	0 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The memory segment registers in 8086 are denoted by
AS, BS, CS, DS
BS, CS, SS, ES
CS, DS, SS, ES
DS, ES, FS, SS

⇒ The normal operation of JFET is
constant voltage region
constant current region
both constant voltage and constant current regions
either constant voltage or constant current region

⇒ In force current analogy, displacement x is analogous to
charge
magnetic flux linkage
electrostatic energy
voltage

⇒ A P-N junction diode dynamic conductance is directly proportional to
the applied voltage
the temperature
its current
thermal voltage

⇒ Donor energy level is n type semiconductor is very near valence band.
TRUE
FALSE

⇒ The factor which will have least effect on the voltage at the load end of a two-wire supply circuit is
length of the circuit
whether supply frequency is 25 Hz or 50 Hz
amount of load on the circuit
cross-section of the circuit wires

⇒ Class A amplifiers are preferred when
minimum distortion is required
maximum voltage gain is required
output signal is desired in phase with input signal
signal having A.C. superimposed on D.C. are to be amplified

⇒ The number of FF required for a divide by 12 circuit is
16
12
8
4

⇒ It is desired to reduce distortion in an amplifier from 8% to 2% by using 5% negative feedback. The open and closed loop gains respectively are
60 and 15
15 and 60
6 and 1.5
1.5 and 6

⇒ Nichrome is used for
overhead line wires
heater coils
lamp filaments
all of the above

⇒ Which circuit is called emitter follower?
CC
CE
CB
Both (a) and (b)

⇒ Some advantages of optical fibre cables are

small diameter
Immunity to cross talk and EM interference
Laser and LED modulation methods lend themselves ideally to digital operation

Which of the above are correct?
1 only
1 and 2
1, 2, 3
2, 3

⇒ Which of the following can be used as a tachogenerator in control systems?
Microsyn
DC servomotor
AC servomotor
Magnetic amplifier

⇒ Zoning is used with a dielectric antenna in order to
permit pin-point focusing
reduce the bulk of the lens
increase the bandwidth of the lens
correct the curvature of the wavefront from a horn that is too short

⇒ A signum function is
zero for t greater than zero
zero for t less than zero
unity for t greater than zero
2∪(t) - 1

⇒

Match the following:

	List I		List II
A.	Wein bridge oscillator	1.	Low output impedance
B.	Voltage shunt feedback amplifier	2.	RF frequency range
C.	Crystal oscillator	3.	Audio frequency range
D.	Current shunt feedback amplifier	4.	High input impedance
		5.	High output impedance

A-3, B-1, C-2, D-5
A-3, B-5, C-1, D-2
A-4, B-3, C-1, D-2
A-5, B-1, C-2, D-1

⇒ The cut in voltage of a diode is nearly equal to
applied forward voltage
applied reverse voltage
barrier potential
none of the above

⇒

Assertion (A): Most of magnetic circuits have an air gap.

Reason (R): An air gap has high reluctance.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In which of the following devices can the operation be visualised in terms of a series feedback loops?
TWT
Reflex klystron
Klystron amplifier
Backward wave oscillator

⇒ An RLC series circuit is excited by a step voltage E. The circuit current at t = 0 is
E/R
E/LC
zero
infinity

⇒ When duct propagation exists
the line of sight and diffraction. Zone concepts are payable
the line of sight and diffraction zone concepts are not applicable
line of sight concept is applicable but diffraction zone concept is applicable
diffraction zone concept is not applicable but line of sight concept is not applicable

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after ACI 0 A4 H?
4 AH, 0
4 AH, 1
4 BH, 0
4 BH, 1

⇒ In electromagnetic wave polarization is caused by
refraction
reflection
longitudinal nature of electromagnetic waves
transverse nature of electromagnetic waves

⇒ The power dissipated per gate
is constant at all frequencies
increases with frequency
decreases with frequency
may increase or decrease with frequency

⇒ Resistivity of semiconductors is around 100 Ω-m.
TRUE
FALSE

⇒ What will be BCD number when the output is 0.37 V?
110111
10110111
11001000
1001000

⇒ Typical values of voltage gain for CE, CB and CC amplifiers are
100, 100 and 1 respectively
100, 1 and 100 respectively
100, 1 and 1 respectively
1, 100 and 100 respectively

⇒ In the following transistor circuit V_BE = 0. 7 V, r_c = 25mV/I_E, and β and the capacitance are very l
1 mA
2 mA
5 mA
10 mA

⇒ A non-inverting voltage feedback amplifier is a
voltage amplifier
current amplifier
current to voltage converter
voltage to current converter

⇒

Match the following:

	List I (Devices)		List II (characteristic)
A.	BJT	1.	Voltage controlled negative resistance
B.	MOSFET	2.	High current gain
C.	Tunnel diode	3.	Voltage regulation
D.	Zener diode	4.	High input impedance

A-1, B-4, C-2, D-3
A-2, B-4, C-1, D-3
A-2, B-3, C-1, D-4
A-1, B-3, C-2, D-4