Question is ⇒ Diffraction of electromagnetic waves, Options are ⇒ (A) may occur around the edge of a sharp obstacle, (B) is caused by reflections from the ground, (C) arises only with the spherical wave fronts, (D) will occur when the waves pass through a large slot, (E) , Leave your comments or Download question paper.

Question is ⇒ Diffraction of electromagnetic waves, Options are ⇒ (A) may occur around the edge of a sharp obstacle, (B) is caused by reflections from the ground, (C) arises only with the spherical wave fronts, (D) will occur when the waves pass through a large slot, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Diffraction of electromagnetic waves
A.	may occur around the edge of a sharp obstacle [Correct Answer]
B.	is caused by reflections from the ground [Wrong Answer]
C.	arises only with the spherical wave fronts [Wrong Answer]
D.	will occur when the waves pass through a large slot [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a turnstile antenna two-half wave resonant wire radiators are placed at 90° to each other in the same plane and are excited
in phase
in phase opposition
90° out of phase with each other
45° out of phase with each other

⇒ Which of the following characters is allowed in variable names in C?
comma
dot
blank
underscore

⇒ In a second order system, the time constant t of exponential envelopes depends
only on damping factor
only on natural frequency
both on damping factor and natural frequency
neither on damping factor nor on natural frequency

⇒ Which synthesis procedure requires the use of mutual inductance?
Foster's synthesis
Cauer synthesis
Bott-Duffin synthesis
Brune's synthesis

⇒ The slope of log magnitude curve changes by - 40 dB/decade at a certain frequency and the error between asymptote and actual curve is positive. This means that
a double pole is present
a pair of complex conjugate poles is present
either (a) or (b)
neither (a) nor (b)

⇒

Assertion (A): In hot wire instrument the material of hot wire in generally platinum iridium.

Reason (R): A hot wire ammeter is suitable for ac only

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A tweeter should be fed from the input through a
low pass filter
high pass filter
band pass filter
band stop filter

⇒ When two ALU 1C 74181 are cascaded
the carry out of first stage is connected to carry in of second stage
the carry in of first stage connected to carry in of second stage
the carry in of first stage is connected to carry out of second stage
the carry out of first stage is connected to carry out of second stage

⇒ An enhancement mode MOSFET is on when the gate voltage is
zero
positive
high
more threshold value

⇒ A Varactor diode has
a fixed capacitance
a fixed inductance
a voltage variable capacitance
a current variable inductance

⇒ Am equivalent 2's complement representation of the 2's complement number 1101 is
110100
1101
110111
111101

⇒ The coil of a moving iron instrument has a resistance of 500 Ω and an inductance of 1 H. It reads 250 V when a 250 V dc is applied. If series resistance is 2000 Ω, its reading when fed by 250 V, 50 Hz ac will be
260 V
252 V
250 V
248 V

⇒ Non-coherently detection is not possible for
PSK
ASK
FSK
both (a) and (c)

⇒ A hollow rectangular waveguide has dimensions a = 2b. Calculate the amount of attenuation, if the frequency is 3 GHz, and b = 1 cm.
49
47.33
50.33
50

⇒ In a line with finite attenuation
power transmission is least efficient when there are no standing waves on the line
power transmission is most efficient when there are no standing waves on line
Load power depends on phase constant
standing waves will always exist on the line

⇒ The flow rate of electrically conducting liquid without any suspended particle can not be measured by
turbine flow meter
electromagnetic flow meter
ultrasonic flow meter
thermistor based heat flow meter

⇒ In FDM systems used for telephone, which modulation scheme is adopted?
AM
DSB-SC
SSB-SC
FM

⇒ A 1 MHz sinusoidal carrier is amplitude modulated by a symmetrical square wave of period 100 μ sec. Which of the following frequencies will not be in the modulated signal?
990 kHz
1010 kHz
1020 kHz
1030 kHz

⇒ The conduction band is
same as forbidden energy gap
generally located on the top of the crystal
generally located on the bottom of the crystal
a range of energies corresponding to the energies of the free electrons

⇒ The early effect in a BJT is caused by
fast turn on
fast turn off
large collector base reverse bias
large emitter base forward bias

⇒ The minimum charge carried by an ion is
zero
equal to the change of an electron
equal to the change of a pair of electrons
equal to the change of electrons left in the atom

⇒ A series resonant circuit is capacitive at f = 150 Hz. The circuit will be inductive somewhere at
f greater than 150 Hz
f less than 150 Hz
f equal to 150 Hz by increasing the value of the resistance
none of the above

⇒ A crowbar circuit is generally needed for protection under fault conditions.
TRUE
FALSE

⇒ The emitter coupled pair of BJT's gives a linear transfer relation between the differential output voltage and the differential input voltage V_id only when the magnitude of V_id is less a times the thermal voltage, where a is
4
3
2
1

⇒ A VF display operates on the principle of a vacuum diode.
TRUE
FALSE

⇒ An FM signal with a deviation is passes through the mixer, and has its frequency reduced five fold. The deviation in the output of the mixer is
Δ
5Δ
Δ/5
indeterminant

⇒ In which of the following 8085 instructions is the 8 bit number in accumulator adjusted to form two four bit BCD numbers
DAD rp
DAA
DCX rp
ADC M

⇒ ECL has high switching speed because the transistors are
switching between cutoff and saturation regions
switching between cutoff and active regions
switching between active and saturation regions
none of the above

⇒ In the circuit of figure the current through 3 Ω resistance at t = 0^{+0.166666666666667
2.5 A
3.1 A
0}

⇒ Nichol's chart is symmetric about - 180° axis.
TRUE
FALSE