Question is ⇒ Debye temperature of metals is, Options are ⇒ (A) about 10 K, (B) about 200 K, (C) about 600 K, (D) about 2 K, (E) , Leave your comments or Download question paper.

Question is ⇒ Debye temperature of metals is, Options are ⇒ (A) about 10 K, (B) about 200 K, (C) about 600 K, (D) about 2 K, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Debye temperature of metals is
A.	about 10 K [Wrong Answer]
B.	about 200 K [Correct Answer]
C.	about 600 K [Wrong Answer]
D.	about 2 K [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An ammeter is
secondary instrument
absolute instrument
recording instrument
integrating instrument

⇒ The operator precedence in Java is in the order
arithmetic operation, increment and decrement operation, comprassion, logical operation and assignment operation.
increment and decrement operation, arithmetic operation, comparison, logical operation and assignment operation.
comparison, arithmetic operation, increment and decrement operation, logical operation and assignment operation.
arithmetic operation, comparison operation, increment and decrement operation, logical operation and assignment operation.

⇒ A mod-2 counter followed by a mod 5 is same as
mod-7 counter
A decade counter
mod-3 counter
none

⇒ In telecast
video and audio signals are frequency modulated
video signals are frequency modulated but audio signals are amplitude modulated
both audio and video signals are amplitude modulated
video signals are amplitude modulated and audio signals are frequency modulated

⇒ A boot strap generally incorporates
CB configuration
CE configuration
emitter follower
none of the above

⇒ In all base driver amplifiers
ac collector voltage is 180° out of phase with ac base voltage
ac emitter voltage is 180° out of phase with ac base voltage
ac collector voltage is in phase with ac base voltage
none of the above

⇒ The drift velocity of electrons is
very small as compared to speed of light
equal to speed of light
almost equal to speed of light
half the speed of light

⇒ Common base configuration is little used because
it has low input impedance
it has high input impedance
it does not heat up
it has very high gain

⇒ In a common emitter BJT amplifier, the maximum usable supply voltage is limited by
avalanche Beakdown of Base-Emitter junction
collector emitter breakdown voltage with base open(βV_CEO)
collector emitter breakdown voltage with emitter open(βV_CEO)
zener break down voltage of the emitter base junction

⇒ A 3 phase series inverter has
12 thyristors
6 thyristors
3 thyristors
3 or 6 thyristors

⇒ Which of the following memories normally has highest storage capacity?
Magnetic disc
Magnetic tape
Semiconductor memory
Core memory

⇒ In cellphone communication base antennas are connected to other base antennas in
line of sight communication
ionospheric propagation
ground wave propagation
medium wave propagation

⇒ A 200 turn coil has a self inductance of 10 mH. If the number of turns is doubled, all other quantities remaining the same, the self inductance will be
2.5 mH
5 mH
20 mH
40 mH

⇒ The contents of the program counter after the call operation point to the first instruction on
stack
subroutine
either of the above
none of the above

⇒ In a radio receiver the input from local oscillator is fed to
RF amplifier
mixer
IF amplifier
detector

⇒ Binary 1000 multiplied by binary 1000 gives
10000
100000
1000000
10000000

⇒ It is required to study transients during switching process. Which CRO should be preferred?
Ordinary CRO
Dual beam CRO
Dual trace CRO
Storage oscilloscope

⇒ Insulation resistance of a cable is directly proportional to its length.
TRUE
FALSE

⇒ Which of the following is correct? The circuit shown in the fig
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2 and 4

⇒ When a transistor is connected in common emitter mode, it with have
negligible input resistance and high output resistance
high input resistance and low output resistance
medium input resistance and high output resistance
low input resistance as well as output resistance

⇒ If C is spring constant and θ is deflection, controlling torque is
Cθ
C/θ
θ/C
C²θ

⇒ For the logic circuit of the given figure the simplified Boolean expressio
A + BC
A + BC
A + B C
A + BC

⇒ To produce p type semiconductor we add
acceptor atoms
donor atoms
pentavalent impurity
trivalent impurity

⇒ The impulse response h[n] of a linear time invariant system is given by h[n] = ∪[n + 3 ] + ∪[n - 2] -2∪[n -7]. The above system is
stable but non-casual
stable and casual
casual but unstable
unstable and not casual

⇒ When a wave reaches an open circuit
the voltage at termination is doubled the incident voltage
the current at termination is doubled the incident voltage
the voltage at termination is zero
both V and I at termination are doubled the incident voltage and current

⇒ The difference between measured value and true value is called
gross error
relative error
probable error
absolute error

⇒ Neper is
larger than a decibel
smaller than decibel
equal to 1 decibel
none of the above

⇒ At 0 K, silicon and germanium behave like monoatomic crystals.
TRUE
FALSE

⇒ The density of states (i.e. number of states per eV per m³) in the conduction band for energy level E is proportional to
E
E
E^1.5
E²

⇒ In a positive edge triggered D flip flop
D input is called direct set
Preset is called direct reset
Present and clear are called direct set and reset respectively
D input overrides other inputs