Question is ⇒ Cross-over distortion behaviour is a characteristic of, Options are ⇒ (A) class A output stage, (B) class B output stage, (C) class AB output stage, (D) common base output stage, (E) , Leave your comments or Download question paper.

Question is ⇒ Cross-over distortion behaviour is a characteristic of, Options are ⇒ (A) class A output stage, (B) class B output stage, (C) class AB output stage, (D) common base output stage, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Cross-over distortion behaviour is a characteristic of
A.	class A output stage [Wrong Answer]
B.	class B output stage [Correct Answer]
C.	class AB output stage [Wrong Answer]
D.	common base output stage [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the circuit of figure, Thevenin's resistance is 10 &
25 Ω
10 Ω
13.33 Ω
6 Ω

⇒ Which circuit is called swamped amplifier?
CC
CE
CB
Both (a) and (b)

⇒

Assertion (A): If difference between static and optical dielectric constant is high, the mechanical compressiblity of that material is also high.

Reason (R): For soft ions, ionic polarization per unit field is higher than that of hard ions.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Bit is a unit of
entropy
information
channel capacity
rate of information

⇒ A silicon wafer has 100 nm of oxide it and is inserted in a furnace at a temperature above 1000°C for further oxidation in dry oxygen. The oxidation rate
is independent of current oxide thickness and temperature
is independent of current oxide thickness but depends on temperature
slows down as the oxide grows
is zero as the existing oxide prevents further oxidation

⇒ The sign of a floating point number depends on
only the sign of mantissa
only the sign of exponent
the sign of both mantissa and exponent
either (a) or (b)

⇒ FIR filter Passes __________ Phase.
non-linear phase
linear phase
variable phase
none

⇒ Inductors used at V.H.F. are made using
air core
cast iron cored
sheet steel cored
thin film technique

⇒ The breakdown voltage in a zener diode
is almost constant
is very small
may destroy the diode
decreases with increase in current

⇒ In a turnstile antenna the crossed dipoles are excited with voltages
in phase with each other
90° out of phase with each other
120° out of phase with each other
180° out of phase with each other

⇒ If the intrinsic resistivity at 300°K is 0.37 ohm-m and the electron and hole mobilities at 300°K are 0.28 and 0.15 m²/volt-sec, then the intrinsic carrier concentration of Germanium is __________ .
2.92 x 10¹⁹/m³
2.92 x 10^-19/m³
1.92 x 10¹⁹/m³
3.92 x 10¹⁹/m³

⇒ Which of the following characters is allowed in variable names in C?
comma
dot
blank
underscore

⇒ In a semiconductor material. The hole concentration is found to be 2 x 2.5 x 10¹⁵ cm^-3. If mobility of carriers is 0.13 m²/ v-s. Then find the current density if electric field intensity is 3.62 x 10^-19
7.6237 x 10^-4 A/cm²
7.6237 x 10^-5 A/cm²
7.6237 x 10^-3 A/cm²
none of these

⇒ Ebers Moll model is applicable to
bipolar Junction transistor
N MOS transistor
unipolar junction transistor
field effect transistor

⇒ In a horizontal polarized wave
magnetic field is perpendicular to ground
magnetic field component is parallel to ground
electric field component is perpendicular to ground
electric field is parallel to ground

⇒ Class A amplifiers are preferred when
minimum distortion is required
maximum voltage gain is required
output signal is desired in phase with input signal
signal having A.C. superimposed on D.C. are to be amplified

⇒ If V_a1 = V_a2 = 100 V and V_a0 = 0, then V_a, V_b, V_c are
200, -100 and -100 V
100, 100, 300 V
200, 100, 100 V
100, -100, 100 V

⇒ A pure tone at 1000 Hz has a dB level of 40 dB. If the required dB level is 100, the number of such tones is
2.5
60
10⁴
10⁶

⇒ If the drift velocity of holes under a field gradient of 100 V/m in 5 m/s, their mobility (in SI units) is
0.05
0.5
50
500

⇒ Tellegen's theorem is applicable to
circuits with passive elements only
circuits with linear elements only
circuits with time invariant elements only
circuits with active or passive, linear or nonlinear and time invariant or time varying elements

⇒ Consider the following applications/ advantages of radar beacons

navigation
target identification
accurate tracking of enemy targets
large increase in maximum range

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2
2, 3, 4

⇒ The current I_CBO
increases with increases in temperature
is normally greater for silicon transistor than germanium transistors
mainly depends on the emitter base junction bias
depends largely on the emitter doping

⇒ If the numerator of Z(s) is one degree higher than denominator, Z(s) has a pole at infinity.
TRUE
FALSE

⇒ Figure shows the equivalent circuit of resistor. The resistor is non-inductive w
R = L/C
LR = L/C
L = CR²
C = LR²

⇒ Consider 49 cascaded amplifiers having individual rise time as 2 n sec. 3 n sec. ... 50 n sec. The input waveform rise time is 1 n sec. Then the output signal rise time is given time by (Assume output signal rise time is measured within 10 percent range of the final output signal.)
39 - 28 μsec
2.28 μsec
0.228 μsec
39.28 μsec

⇒ TRAP is __________ whereas RST 7.5, RST 6.5, RST 5.5 are __________ .
maskable, non-maskable
maskable, maskable
non-maskable, non-maskable
non-maskable, maskable

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. Which of the following frequency is least likely to be present in the output?
1002 kHz
1000 kHz
999.2 kHz
998.0 kHz

⇒ The number of digit 1 present in the binary representation of 3 x 512 + 7 x 64 + 5 x 8 + 3 is
8
9
10
12

⇒

Assertion (A): A parallel resonant circuit is also called anti-resonant circuit.

Reason (R): In a parallel resonant circuit impedance is maximum at resonance.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is used in temperature alarm circuits?
Thermistor
Photoconductor
Transistor
Varistor