Question is ⇒ Coulomb friction is, Options are ⇒ (A) the force of sliding friction between dry surfaces, (B) the force of friction between moving surfaces separated by viscous fluid, (C) the force required to initiate motion between two contacting surfaces, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Coulomb friction is, Options are ⇒ (A) the force of sliding friction between dry surfaces, (B) the force of friction between moving surfaces separated by viscous fluid, (C) the force required to initiate motion between two contacting surfaces, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Coulomb friction is
A.	the force of sliding friction between dry surfaces [Correct Answer]
B.	the force of friction between moving surfaces separated by viscous fluid [Wrong Answer]
C.	the force required to initiate motion between two contacting surfaces [Wrong Answer]
D.	all of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When analysing two port networks in parallel it is more convenient to use
z parameters
h parameters
T parameters
y parameters

⇒

Match the following:

	List I		List II
A.	loop antenna	1.	flat line
B.	folded dipole	2.	300 W
C.	SWR of 1	3.	sharp broadside full
D.	VHF band	4.	30 to 300 MHz

A-1, B-4, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4

⇒ The resolution of an n bit DAC with a maximum input of 5 V is 5 mV. The value of n is
8
9
10
11

⇒ The dynamic characteristics of capacitive transducer are similar to those of
LP filter
HP filter
notch filter
band stop filter

⇒ The response shown in figur
over damped
critically damped
under damped
either (a) or (c)

⇒ For the logic circuit of the given figure the simplified Boolean expression
A ⊕ B
A + B
AB
A + B

⇒ As compared to dimensions of most feeds, the skin depth at microwave frequencies is
of the same magnitude
much larger
much smaller
either (b) or (c)

⇒ In a superheterodyne broadcast receiver, the frequency of local oscillator is __________ the incoming signal frequency.
higher than
lower than
equal to
not comparable to

⇒ Which of the following are linear ICs?
RF and IF amplifiers
Wide band amplifier
Audio amplifiers
All of the above

⇒ Two meters X and Y require 40 mA and 50 mA for full scale deflection. Then
X is more sensitive
Y is more sensitive
both are equally sensitive
it is not possible to determine from given data

⇒ If the mantissa has a sign bit of 0 and the exponent is changed from a negative number to a more positive number the result is
a positive number and closer to zero
a positive number and away from zero
a negative number
a negative number and closer to zero

⇒ For global communication, the number of satellites needed is
1
3
10
5

⇒ In the given fi
0 rad/sec
2 rad/sec
3/2 rad/sec
None of these

⇒ The impurity added to extrinsic semiconductor is of the order of
1 in 100
1 in 1000
1 in 100, 0000
1 in 100, 000, 000

⇒ Which of the following material can be used in cable shields?
Copper
Aluminium
Cast iron
Lead

⇒ e^-2t is __________ .
energy signal
power signal
neither energy signal nor power signal
both energy and power signal

⇒ Digital technologies being used now-a-days are
DTL and EMOS
TTL, ECL, CMOS and RTL
TTL, ECL and CMOS
TTL, ECL. CMOS and DTL

⇒ Which of the following frequency is likely to be associated with AM radio broadcast?
1000 kHz
100 MHz
500 MHz
10 GHz

⇒ Consider the following sets of values of E, R and C for the circuit in the given fig
1 and 4
1 and 2
3 and 4
2 and 3

⇒ With reference to C programming language, which of the following statements are correct?

An identifier may start with an underscore.
An identifier may end with an underscore.
If is a valid identifier.
The number of significant characters in and identifier is implementation dependent.

Select the correct answer from the codes given below:
1 and 2 only
2 and 3 only
1, 2, 3 and 4
3 and 4 only

⇒ Which binary addition is incorrect?
1001.1 + 1011.01 = 10100.11
100010 + 1000101 = 1001010
0.0011 + 0.1110 = 1.1
1011.01 + 1001.11 = 10111

⇒ In a transistor receiver, the use of FET as the first stage amplifier is likely to
improve selectivity of the receiver
improve the effectiveness of the AGC
reduce the effect of negative peak clipping
reduce the effect of noise at all frequencies

⇒ In 8086 the flag which enables or disables external interrupts is
IF
DF
TF
CF

⇒ Nichrome is used for
overload line wires
heater coils
lamp filaments
all of the above

⇒ The ratio of the directivity of an end fire antenna to that of a broadside antenna is
2
3
4
5

⇒ In a receiver, which of the following device has IF input but RF output?
Demodulator
Loudspeaker
Audio amplifier
Frequency changer

⇒ Which of the following is not a valid real constant in C?
426
321
-621.231
201.2314

⇒ The antenna diameter of a radar system is doubled. The maximum range will
be doubled
become four times
be halved
decrease to one fourth

⇒ Which one is correct option?

A pure capacitor never dissipates energy, but only stores.
Capacitor can store finite amount of energy even cunent is zero.
The current through a capacitor is zero if voltage across it d.c.
Voltage across a capacitor cannot change instantaneously since it would require an infinite current.
q_c(0^-) = q_c(0⁺)

5, 4, 3, 2
3, 4, 1, 2
2, 4, 3, 1
1, 2, 3, 4, 5

⇒ The forbidden energy gap for germanium is
0.12 eV
0.32 eV
0.72 eV
0.92 eV